User Manual WalkingPad Walking Device Please read this manual carefully before operating the product and keep it properly. Model No.: WPA1F User Manual Content Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the eq-
uipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause un-
desired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following mea-
sures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 1. Product and Accessories 2. Function schematic diagram 3. Guide for initial operation 4. Learn to use WalkingPad 5. Safety Notice 6. Maintenance and servicing 7. Hazardous substances declaration 8. Trademark and legal declaration 02 03 07 09 13 16 17 18 Welcome to use 01 Product and Accessories Thank you for choosing WalkingPad Walking Device , hereinafter referred to as a WalkingPad, which posess various advantages including exquisite, simple, innovative integral design. From now on, enjoy the quality life of walking at home. Please carefully check whether the contents of the package are complete and intact. If there is any missing or damaged, please contact the seller. Performance &indicators Detailed parameters Expansion dimensions Folding dimensions The area of Walking belt Gross weight Net weight Maximum load Applicable age Applicable height Minimum speed Maximum speed Power Input Rated voltage Sport mode 1432547129mm/
56.5"21.5"5"
822547129mm/
32.5"21.5"5"
1200415mm/
47"16.5"
68 Ibs / 31kg 62 lbs / 28kg 220 lbs / 100kg 12-60 years old Unlimited 0.5 mi/hr 0.5 km/hr 3.75 mi/hr 6 km/hr 746W 110-120V~
Standby mode /
Fixed mode /Automatic mode Parts Other accessories Power Cable Remote Controller Lanyard Wrench Silicone Oil 01 02 User Manual Main Product 02 Function schematic diagram 1.Product main body Walking Belt Fold Hinge 03 Display Panel Mode Indicator Light Roller Power switch Power plug Roller Mode Button 04 02 Function schematic diagram 2.Introduction of the function of the indicator panel 3.Walkingpad remote control Display Time Display Speed Show Distance Show Steps START/STOP ACCELERATION DECELERATION Standby Mode Manual Mode Automatic Mode LANYARD Fault Warning Light MODE BATTERY COVER 05 06 03 Guide for initial operation 1.Choose flat ground to place the walkingpad. It is forbidden to place it on a thick and soft cushion. 2. Unfold the walkingpad slowly and press it down to completely flat. 3.Check and adiust the walking belt in the middle position . 7. Enter novice guide. 8.Complete learning to get all functions, Otherwise, the Speed Limit is 1.75mi/hr, 3.75mi/hr can be unlocked after novice guide. 9. Start to use the walker. 4. Connect the power line and turn on the switch. 5.Search "Walkingpad" App from Apple Store or Android Google Play and complete installation. 6. Open the App,follow the prompts to set up the device. 10. If the belt deviates from the orbit in use, please adjust properly. SEE: 06 Mainten-
ance and servicing. 07 08 04 Learn to use WalkingPad 1. Mode instruction Standby Mode Light of the Standby mode is on;
Motor and sensor stop response. Fixed speed mode Light of the fixed speed mode is on; Control the speed through the remote control or APP. Automatic Mode Light of the automatic mode is on;
Speed is automatically controlled by intelligent algorithm. 2. Instructions of the standby mode control. 3. Instructions of fixed speed mode control (primary mode) Standby Mode The motor and sensor stop respo-
nding in this mode to prevent non-
users from accidentally triggering the WalkingPad. Mode Switch Short press: return the previous mode. Fixed speed mode In this mode, the speed of the WalkingPad can be controlled by the remote control. It is re-
commended that beginners use the fixed speed mode first and then use the automatic mode after being skilled in using the WalkingPad.The fixed speed mode is controlled by remote co-
ntrol by default, that is, the START/STOP button of the remote control is used to start or stop the WalkingPad, which can be modified in the client Personalized. ACCELERATION Short press: increase speed by 0.25mi. START/STOP Short press: start or stop the WalkingPad. DECELERATION Short press: reduce speed by 0.25mi. MODE SWITCH Short press: switch to automatic mode. Long press: switch to standby mode. 09 10 04 Learn to use WalkingPad 4. Description of automatic mode control (advanced mode) 5. Remote Controller Notice 6. Fault Waming Linght If the remote controller has no response or you change a new one, The remote controller and walking device need to re-establishing communication. Pairing method: Restart walking device and short press the MODE Button of Controller many times during display "WAIT". Under this automatic mode, set as the intelligent start and stop, the WalkingPad will start automatically to the target speed(default is 1.75 mi/hr) while entering this area. Automatic Mode This mode is advanced mode, which is more difficult and can be used completely without the remote control. It is recommended for users who have good sports coordination or have walking machine experience. Entering this area, the WalkingPad will start or accelerate under the automatic mode. Entering this area, the WalkingPad will slow down automatically under the automatic mode. Short press: stop the WalkingPad. Mode switch:
Short press: switch to the fixed speed mode Long press: switch to the standby mode The Fault Warning Light is off when the walking machine is working well. While error occurs, the fault warning light is on and the display panel shows the error code E01Drive communication fault E02Motor abnormalities E05Overcurrent protection E06Motor Protection E08Sensor Fault E10:
E11:
High temperature protection, automatic recovery after the end of countdown. Overload protection, please add lubricating oil, and resume automatically after countdown. 11 12 05 Safety Notice Please keep a rear distance of 50cm or more. Please choose sport shoes. Please do not stand up on the walking machine when it is un-
der power on and auto-calibrat-
ion situation. Anti-pinch Folding the machine if not power off is prohibited. Prohibition of vertical placement Please keep a distance of 50cm or more for both sides. Using on uneven ground is prohibited. It is strictly prohibited to walk up and down the walking device when running. Anti-involved, please do not trample. Please pull out the plug when youre not using it. Prohibition of lateral placement 13 14 05 Safety Notice Horizon 06 Maintenance and servicing 1. Clean the walking machine Please keep your sight horizontal to avoid dizziness. More than one person to use the machine at same time is prohibited. Using machine with peg is prohibited. Trampling the machine head is prohibited. 2. Adjust the belt Minors must be accompanied by an adult. Walking sideways on the machine is prohibited. Walking backwards on the machine is prohibited. Please do not use the walking machine if you are aged people or pregnant women. 3. Lubricate the Belt Unplug the unit from the electrical source before you begin. Pour a little gentle detergent in the cotton rag or towel. Dont pour the detergent on the belt directly, and dont use acid or corrosive cleaners. Wipe down the frame, motor encasement and belt. Dont wipe backside of the belt. After a period of using, the end part may appear dust and stains, thats normal situation, and just clean up. Pressing both Mode Button and Acceleration Button on the remote controller over 3 seconds. The display panel shows CALI and the speed is 2.5mi/hr(4km/h). If belt moves left: Turn the left adjusting screw a half-circle clockwise. If belt moves right: Turn the right adjusting screw a half-circle clockwise. If belt is slipping: Turn both left and right adjusting screw a half-circle clockwise at same time. Check whether need to readjust after use 1 to 2 minutes. Unplug the unit from the electrical source before you begin. Lift up the belt and apply the silicone to the underside surface of the belt. Power on the walking machine. Make the machine running with 2.5mi/hr(4km/h) 10 to 20 seconds. No more 5 to 10ml lubricant, too much will make the belt slipping. Silicone oil once every 3 months. 15 16 07 Hazardous substances declaration 08 Trademark and Legal Declaration The table of Hazardous Substances Part Name Lead Mercury Cadmium Hexavalent Chromium Polybrominated Biphenyls Polybrominated diphenyl ethers
(Pb)
(Hg)
(Cd)
(Cr(VI))
(PBB)
(PBDE) Electronic Components Metal Parts Shell Battery Other Parts X This form has been prepared in compliance with the provisions of SJ/T 11364.
: Indicates that the content of said hazardous substance in all of the homogenous materials in the component is within the limits required by GB/T 26572. X: Indicates that the content of said hazardous substance excee-
ds the limits required by GB/T 26572 in at least one homogenous material in the component. Beijing Kingsmith Technology Co., Ltd has patents of WalkingPad Walking Machine series products. This manual is created by Kingsmith and owns the copyright.Any form of unauthorized distribution, reproduction, publication, release or quotation by any institution or individual is prohibited without Kingsmith's written permission, not allow using the patents. This manual contains as much as possible functions and instructions for use when it is printed. However, due to pro-
duct imperfections, design changes, etc., may still have discrepancies with the product you purchased. In view of pr-
oduct updates, this manual and the actual product may vary in color, appearance, etc., actual supplies prevail. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction conc-
erning use of the appliance by a person responsible for their safety.Children should be supervised to ensure that they do not play with the appliance.This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by childr-
en without supervision. 17 18 Manufacturer: Beijing Kingsmith Technology Co., Ltd Address:Floor 4, Building 25, Area 18, ABP Park, Fengtai, Beijing, China. Product performance standard: Q/FTSMS0001-2017 FCC ID: 2ARDB-WPA1F Manufacturer: Beijing Kingsmith Technology Co., Ltd Address:Floor 4, Building 25, Area 18, ABP Park, Fengtai, Beijing, China