FCC ID: UX2BEL-3388R-W BEL-3388R-W WIRELESS TEMPERATURE CONTROLLER

Statement according to FCC part 15.19:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Statement according to FCC part 15.105:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected. Consult the dealer or an experienced radio/TV technician for help. Statement according to FCC part 15.21:

Modifications not expressly approved by this company could void the user's authority to operate the equipment.

INSTRALLATION GUIDE Open the front cover and back by using screwdriver Fix the bottom hull onthe wall by

? using screwdriver . 3 Close the front cover. 3388R-W The control is for installed by expert technician and in accordance with the wiring diagram, during installation the applicable electrical safety regulation and the local electricity supply company regulations must be observed. Not to be exposed to dripping or splashing. For installation, no metal conduit or of cable provided with a metal sheath. The thermostat must be mounted on clean, dry indoor place. Instruction manual shall be provided to the user for proper use of the control. In case of doubt ask your electrician Battery replacement:

~---- Disconnect the supply before battery replacement

----- Replace only with the same or equivalent type of batteries.

----- Do not dispose the used up battery with the household waste. refer to your local area for the proper disposal You can help protect the environment!

Please remember to respect the local regulations: hand in the non-working electrical equipments to an appropriate waste disposal center. |

INSTRALLATION GUIDE

! Open the front cover and back by using | Fix the back plate on the wall. screwdriver and take away the front cover. Close the front cover and tighten the Fix the cable well. ! screw. 3388R-W

@The control is for installed by expert technician and in accordance with the wiring diagram, during installation the applicable electrical safety regulation and the local electricity supply company regulations must be observed.

@Not to be exposed to dripping or splashing.

@For installation, no metal conduit or of cable provided with a metal sheath.

@The thermostat must be mounted on clean, dry indoor place.

@The unit is for fixed wiring conductors with current carried by terminal up to 1A.

@ Disconnect from supply before open.

@Recommend to add fuse of 6A in the line circuit.

@The size of wire connect to the terminal is1to 1.5mm

@ The thermostat must be placed in circuits of over- voltage category | with a maximum working voltage not exceeding 24VAC.those places are:

1) the secondary side of transformer 2) protected circuits(e.g.by a suitable surge protector)

@ The current should not exceed:iA Symbol a indicating separate collextion for electrical and electronic equipment. You can help protect the environment!

Please remember to respect the local regulations: hand in the non-working electrical equipments to an appropriate waste disposal center. BATTERY REPLACEMENT GUIDE Open the front cover and back by using screwdriver

| B Take away the old battery.

! C Place the new battery. | D) Close the battery compartment. 3388R-W mBattery replacement:

-~--Disconneet the supply before battery replacement.

- Replace only with the same or equivalent type of batteries.

----Do not dispose the used up battery with the household waste, refer to your local area for the proper disposal. You can help protect the environment!

Please remember to respect the local regulations: hand in the non-working electrical equipments to an appropriate waste disposal center. WIRING DIAGRAMS 24VAC LDADING mee TO OO Coal 3388R RX