User Guide
. Preparation
. CONTENTS
. BATTERY & CHARGING
. Drone
. Controller
. Spare Propeller
. Charger
. Battery Charging
. SPECIFICATION Length Height Weight Flying Time Battery Full charging mm mm about g (Batteries included) about min(May vary depending on ight conditions) mAh / S / .V / C
. Flight
. CONTROLS (MODE) Speed change Escape mode On/O Throttle & Rudder Power Sensor Reset Controller Lever Calibration
(Not paired with a drone) Press and hold Short press
-degree ip LED change Mode / change Link mode / Control mode change
(On a USB connection) Elevator & Aileron Auto Takeo /Landing Pairing (Not paired with a drone) Trim
*Controls and feature descriptions are based on Mode
. Auto Takeo /Landing
. Emergency stop Press for more than seconds
. Motor start & stop (operates in landing state)
. Escape mode
. Mode / change (Can be changed in landed state) Press for more than seconds Press for more than seconds
. Trim Settings Mode On(diming) O(Light) Mode
. Change the color of the drone LED (can be changed in the landing state) White Yellow Rainbow Pink Red Aqua Green Blue
. Adjusting the speed
. -degree ip (works with battery levels above %) Turbo
. Pairing (works within seconds after connecting the drone's battery. Shake rapidly times or more Press for more than seconds
. Sensor Reset
*Proceed if the drone is unable to hover or maneuver normally
. Controller Lever Calibration
*Proceed without connecting the drone and controller single short press single short press
. USB connection Control Mode Link Mode This product is for indoor use only, please be careful of the rotating propellers when ing in the vicinity of people or animals. FCC Instructions FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.