FCC ID: ON5-SLNW100 Sync Wearable

Introduction How to Charge How to Mount Switch Operation Firmware Update Frequently Asked Questions Appendix CatEyeSYNC Compatible Rechargeable Safety Light SL-NW100 Manual Information in the instruction manual is subject to change without notice. SLNW100-200701 4 Install CatEyeSYNC SYNCWearable is capable of the following when used with the CatEyeSYNC smartphone app. Synchronize on/off operations with other CatEyeSYNC-

compatible lights Synchronize modes and flashing timing with other CatEyeSYNC-compatible lights*

Synchronize Kinetic mode operation

(when connected to compatible models) Configure light settings, check remaining battery level, and receive notifications via the app

* Excluding headlights If using an iPhone If using an Android smartphone

* Downloading and using the app incurs communication fees. A Wi-Fi connection is recommended.

* For the latest information on compatible smartphones, see CatEyeSYNC Compatible Devices.

* This manual describes how to perform operations using the light only. For information on operations using CatEyeSYNC, refer to the CatEyeSYNC instruction manual.

* Pairing with CatEyeSYNC is required to synchronize the lights. 2 Checking package contents Light unit

+ Clip bracket Rubber band and hook USB cable

(MICRO USB) Before Initial Use This unit is shipped with small charge to check the light. Be sure to charge it before use, according to the instructions How to Charge (Page 3) and Cautions on recharging

(Page 11). How to Charge 1. Connect the light unit to your PC or a com-

mercial USB battery charger using the USB cable. The indicator turns on and charging starts. 3 Charge jack cover 1 2 USB cable To PC or USB battery charger Indicator Steady red light :

Charging Off :

Charging is completed Flashing red light :

Remaining battery low Standard charging time Approx. 2.5 h (USB2.0)

* When your PC is in sleep state, the unit cannot be charged.

* Use a USB battery charger of 500mAh (USB2.0) or more. The cartridge can be fast-charged with high capacity USB battery charger. 2. Once charging is complete, be sure to dis-

connect the USB plug.

* Charging time is approximate values, and will vary de-

pending on the environmental and usage conditions. How to Mount How to attach to a backpack or jersey pocket 4 Light unit +

Clip bracket Install 1 2 Remove Click Clip bracket 1. Confirm the jack cover of the light unit facing the clip bracket tab, and snap the unit on the bracket. 2. Remove the unit from the bracket by turning the unit to the left or right. How to mount to a bicycle Seatpost Rubber band and hook 1 OK NO 2 Mountable diameter range:

Approx. 22 32 mm 5 Switch Operation Press the switch to turn the light on/off or to select the mode. OFF ON

*2 Switch Press and hold High 30 lm

(Approx. 1.5 hours) Click Low 2 lm

(Approx. 18 hours) Daytime HyperFlash

(Approx. 25 hours) 50 lm Flashing 50 lm

(Approx. 45 hours) Group Ride 50 lm

(Approx. 12 hours) Rapid 50 lm

(Approx. 16 hours)

*2 When turning the light on, it lights up in the mode that was used last time. (Mode memory function) Battery auto-save function When the remaining battery power is low, the lighting mode changes to slow flashing. Charge the light as soon as possible. Indicator

(Flashing red light) 6 Firmware Update Update Notifications When a new firmware version is available, CatEyeSYNC will show a notification. Firmware update notification Installing and Executing Firmware Updater for CatEyeSYNC To update the firmware, install Firmware Updater for CatEyeSYNC on your PC.

* The PC must be connected to the Internet. Operating environment : Windows 7 / 8 / 8.1 / 10, or Mac OS 10.10 or later 7 3. Download the updater from the CATEYE website. Download location Home page SUPPORT Downloads Software and App Firmware Updater for CatEyeSYNC 4. Download the Firmware Updater for CatEyeSYNC that matches your OS. After download is complete, follow the on-screen instruc-

tions to install. Executing Firmware Updater for CatEyeSYNC

* The PC must be connected to the Internet. 1. Fully charge the light being used. Important : Please make sure the light is fully charged before updating the firmware. 2. Start Firmware Updater for CatEyeSYNC. 8 3. Follow the on-screen instructions to connect the light to a PC and update the firmware. Important : Be sure to use the included USB cable when connecting a light to a PC. Do not simultaneously connect any other lights. Do not power off the PC or disconnect the light while updating. Doing so may damage the light. Click [Update] button to begin updating. Wait until a dialog appears with the message [Updating complete]. 4. After the update is complete, disconnect the light. After updated, the light will enter a sleep state. Click the switch on the light to wake the light.

* For information on operations using CatEyeSYNC, refer to the CatEyeSYNC instruction manual. 9 Frequently Asked Questions The firmware update does not finish, or an alert is displayed. Try updating the firmware again from the beginning.

* Please make sure the light is fully charged before updating

* Be sure to use the included USB cable when connecting a the firmware. light to a PC.

* Do not simultaneously connect any other lights. Appendix Warning!!!

Check periodically to ensure that the light unit is attached securely. Do not use a damaged rubber band. Always attention to the remaining battery power by check-

ing the indicator periodically while using. 10 Caution!

Stop your bicycle to operate the switch. Do not place it within childrens reach. This unit is not totally waterproof. Please wipe and dry it com-

pletely after using in rain. Otherwise, it may cause failure. If the light unit or parts become dirty with mud, etc., clean with a soft cloth which is moistened with mild soap. Never apply paint thinner, benzine or alcohol; damage will result. Lithium-ion batteries Cautions on recharging Avoid charging in direct sunlight or in a vehicle parked under direct sunlight, and make sure to charge only when the ambient temperature is between 41F and 104 F (5 and 40C). Before charging, be sure that no dust or other foreign objects attach to the USB plug. Do not subject the light to vibrations while charging. Once charging is complete, be sure to disconnect the USB plug. Cautions in use Charging, discharging, and storing in high temperatures will cause the rechargeable battery to deteriorate faster. Do not place the light inside a vehicle or near a heater. 11 If the illumination time is significantly reduced even after proper charging, the rechargeable battery may be nearing the end of its service life. Dispose of the battery as de-

scribed in Cautions for dispose. Cautions on storage Cool and dry storage is recommended. For long period storage, it is important to charge the battery 30 minutes every 6 months. Cautions for dispose When disposing of the light unit, remove the internal recharge-

able battery and dispose of it according to local regulations. Communication Interference occurs in the following places and/or environments, which may result in incorrect operation. Near TVs, PCs, radios, or motors or in cars or trains. Near railroad crossings, along railway tracks, around tele-

vision transmitting stations and radar bases, etc. Used with other wireless devices or certain battery-pow-

ered lights. Frequency Band: 2.4 GHz Radiated Power: -4.6 dBm Hereby, CATEYE Co., Ltd. declares that the radio equipment type SL-NW100 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the follow-

ing internet address: cateye.com/doc 12 Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the users au-

thority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause un-

desired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable pro-

tection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the in-

structions, may cause harmful interference to radio communi-

cations. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help. 13 This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Develop-

ment Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interfer-

ence that may cause undesired operation of the device. CNR dInnovation, Sciences et Dveloppement conomique Can-

ada applicables aux appareils radio exempts de licence. Lex-

ploitation est autorise aux deux conditions suivantes :

1) Lappareil ne doit pas produire de brouillage;

2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Specifications Battery Charge Operating time Rechargeable lithium-ion polymer battery 300 mAh Micro USB plug High Low Flashing Rapid Group Ride Daytime HyperFlash

* Average runtime at 20C.

: Approx. 1.5 hours

: Approx. 18 hours

: Approx. 45 hours

: Approx. 16 hours

: Approx. 12 hours

: Approx. 25 hours 14 High Low Flashing Rapid Group Ride Daytime HyperFlash Approx. 2.5 hours

: Approx. 1.4 hours

: Approx. 6 hours

: Approx. 7 hours

: Approx. 5 hours

: Approx. 5 hours

: Approx. 6 hours Charging : 41F 104F (5C 40C) Operating : 14F 104F (-10C 40C) About 300 times

(until the rated capacity drops to 70%) Approximate illumi-

nation times based on 60 operations of the Kinetic mode in 1 hour Standard charging time Temperature range Recharge/

discharge number of times Dimensions/weight 1-51/64 x 1-47/64 x 25/32 (45.5 x 44 x 20 mm)

/ 0.74 oz (21 g)

* The specifications and design are subject to change without notice. Spare / optional parts 5442620 Rubber band and hook

(WA100) 5442610 Clip bracket 15 5342730 USB cable

(MICRO USB) Limited warranty 2-year Warranty: Light unit only (excludes battery deterioration) CatEye products are warranted to be free of defects from mate-

rials and workmanship for a period of 2 years from original pur-

chase. If the product fails to work during normal use, CatEye will repair or replace the defect at no charge. Service must be per-

formed by CatEye or an authorized retailer. To return the prod-

uct, pack it carefully and enclose the warranty certificate (proof of purchase) with instruction for repair. Please write or type your name and address clearly on the warranty certificate. Insurance, handling and transportation charges to CatEye shall be borne by person desiring service. For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights. 2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan Attn: CATEYE Customer Service Phone : (06)6719-6863 E-mail : support@cateye.co.jp URL : https://www.cateye.com Fax : (06)6719-6033 16

[For US Customers]

CATEYE AMERICA, INC. 2825 Wilderness Place Suite 1200, Boulder CO 80301-5494 USA Phone : 303.443.4595

: 303.473.0006 Fax Toll Free : 800.5.CATEYE E-mail

: service@cateye.com 17

Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID: ON5-SLNW100. Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, we hereby request confidential treatment of information accompanying this application as outlined below:

Exhibit Type Block Diagram Operational Description Schematics The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Cateye Co., Ltd File Name ON5-SLNW100 BlkDia.pdf ON5-SLNW100 OpDes.pdf ON5-SLNW100 Schem.pdf

Koichi Tsuyama President

Federal Communications Commission Authorization and Evaluation Division 1435 Oakland Mills Road Columbia, MD 21046 Date: 16 Jul 2020 SUBJECT: FCC Application for FCC ID: ON5- SLNW100 To Whom It May Concern:

We, (Cateye Co., Ltd.), declare the product Sync Wearable (FCC ID: ON5- SLNW100) operating with 3 channels only, 2402MHz, 2426MHz, 2480MHz. Regards, Cateye Co., Ltd

Koichi Tsuyama President

Federal Communications Commission Authorization and Evaluation Division 1435 Oakland Mills Road Columbia, MD 21046 Date: 06 Mar 2020 SUBJECT: FCC Application for FCC ID: ON5-SLNW100 To Whom It May Concern:

We, the undersigned, hereby authorize CMA Industrial Development Foundations Limited

(Andrew Wong) on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by CMA Industrial Development Foundation Limited (Andrew Wong) on our behalf shall have the same effect as acts of our own. This is to advise that we are in full compliance with the Anti- Drug Abuse Act. We, the

(Cateye Co., Ltd.), are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Regards, Cateye Co., Ltd

Koichi Tsuyama President D:\Job\Current\LW028506 C-MAX Smart Bike\J00730941 FCC\SL\POA_Letter_140225_CMA.docx