Annex no. 5 Functional Description /
User Manual State: 2010-03-01 Vers. no.: 1.10 m. dudde hochfrequenz-technik Rottland 5a D-51429 Bergisch Gladbach/ Germany Tel. +49 2207-96890 Fax +49 2207 968920 Continental Automotive GmbH B&S S2 User Manual / Functional Description of the Continental Radio Frequency Transmitter Type S180144011 S180144014 S180144015 Functional description of Nissan DPF I key 3rd Bundle This document gives an overview of the different device operation modes and the RF transmissions performance of the key. In this document the device is referenced as "key", even if the mechanical backup key might be separated from it. Thierry RASPAUD Josef Lohr
-1-
2011-06-20 Continental Automotive GmbH B&S S2 1. Operating modes The key has three main operating modes which differ regarding of the signal transmitting with the RF:
Immo RKE PASE RES Immobilizer transponder mode Remote key functionality Passive key functionality Remote engine start functionality Immobilizer Transponder mode When the key is operating as an immobilizer transponder, the communication is done via a "contact less interface" depending on a magnetic coupling. The transponder is the passive side of the link and there is no RF transmission from it involved in any aspect. Remote key functionality This mode refers to use the key as a remote control unit to initiate actions on the vehicle such as open or close door latches. RF transmission depends on a user activating (a button pressing) on the key. During the button pressing the amount of telegrams are sent on the RF channel. Short button press:
A short valid button pressing results a sending of the minimum number of the RF telegrams, as showed on the diagram. Thierry RASPAUD Josef Lohr
-2-
2011-06-20 Continental Automotive GmbH B&S S2 Long button press:
If the duration of the button pressing extents the time required for transmitting the minimum amount of RF telegrams, additional telegrams will be sent until the button is released or a timeout of 10s is reached. This timeout function prevents the unintended transmission over the extended time periods in case of a button was fixed. Passive key functionality For passive key operation no user action on the key side is required. The trigger is delivered by the vehicle via an LF data telegram. When the key receive a valid LF message, it responds with two RF telegrams and the inter telegram timing in this mode depends on the key configuration data (sort of time slot concept). Remote engine start functionality This mode refers to use the key as a remote control unit to initiate actions on the vehicle such as start and stop engine. RF transmission depends on a user activating (a button pressing) on the key. During the button pressing the amount of telegrams are sent on the RF channel. In this mode, RF output power is higher than RKE mode. 2. Block diagram Thierry RASPAUD Josef Lohr
-3-
2011-06-20 Continental Automotive GmbH B&S S2 Immobilizer +
PASE frontend Transponder Receiver 125 KHz RES Lock Unlock Trunk Panic Atic37full PCF7952XTT button frontend SPI XCLK Battery CR2032 13,08 MHz to RF frequency F0 = 433.92 MHz 18,37 MHz to RF frequency F0 = 315 MHz Frantic PCF7900 RF antenna 3. RF parameters For all RF transmission the following parameters apply:
JP variant US/EUR variant Center frequency 315 MHz Frequency accurracy 15 kHz 433.92 MHz 22 kHz Frequency deviation 35 kHz nominal 35 kHz nominal RF modulation FSK RF frame data rate Data coding 4.096 kBps Manchester RKE RF power (max)
-16dBm RES RF power (max) FSK 4.096 kBps Manchester
-13dBm
-10dBm Button functions The validation of the accurate frequency deviation and the measurement of the transmission function of the key are implemented basing on RF test software. The graphic below shows the functionality of the buttons. Fourth Button press First Button press Second Button press Third Button press Button RES Button Lock Button Unlock CW; center frequency CW; center frequency Fup Flow With every additional button press switch between Fup and Flow Fmod Sweep Thierry RASPAUD Josef Lohr
-4-
2011-06-20 Continental Automotive GmbH B&S S2 CW; center frequency Button Trunk CW; center frequency RESET: if "Lock"- and "Unlock"- button is pressed at the same time Button Panic Variant S180144011 I_4_L/UL/PBD/P 433,92MHz S180144014 I_5_RES/L/UL/PBD/P 433,92MHz S180144015 N_4_L/UL/TR/P 315MHz Label Europe USA S180144014 Thierry RASPAUD Josef Lohr
-5-
2011-06-20 Continental Automotive GmbH B&S S2 Continental S180144014 FCC ID: KR5S180144014 Warning Statement:
NOTE This device complies with part 15 of the FCC Rules and RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause undesired operation. CAUTION Changes or modifications not expressly approved by the manufacturer could avoid the user's authority to operate the equipment. Canada Korea Continental S180144014 IC: 7812D-S180014 Continental S180144014 Taiwan Brazil Continental S180144014 ETCXXXLPDXXXX Continental S180144014 Thierry RASPAUD Josef Lohr
-6-
2011-06-20 Continental Automotive GmbH B&S S2 Japan Continental S180144015
[identification code]
Thierry RASPAUD Josef Lohr
-7-
2011-06-20