Continental Automotive France SAS Interior Division- Body & Security Radio Frequency Transmitter User Manual of the Continental Model:
TXN1 (433.92 MHz) TXN2 (315 MHz)
-1-
August 17, 2015 Continental Automotive France SAS Interior Division- Body & Security User manual of the TXN1 and TXN2 key 1 General Product Information This document gives an overview of the different device operation modes and the RF transmissions performance of the key model TXN1 and TXN2. In this document the device is referenced as "key", even if the mechanical backup key might be separated from it. 1.1 Trade mark Continental 1.2 Brand Continental 1.3 Manufacturer Continental Automotive GmbH Siemensstr. 12 93055 Regensburg Germany
-2-
August 17, 2015 Continental Automotive France SAS Interior Division- Body & Security 2 Operating modes The key has three main operating modes which differ regarding of the signal transmitting with the RF:
Immo RKE PASE Immobilizer transponder mode Remote keyless functionality Passive key functionality Immobilizer Transponder mode 2.1 When the key is operating as an immobilizer transponder, the communication is done via a "contact less interface" depending on a magnetic coupling. 2.2 Remote keyless functionality This mode refers to use the key as a remote control unit to initiate actions on the vehicle such as open or close door latches. RF transmission depends on a user activating (a button pressing) on the key. During the button pressing the amount of telegrams are sent on the RF channel. A short valid button pressing results a sending of the minimum number of the RF telegrams. If the duration of the button pressing extents the time required for transmitting the minimum amount of RF telegrams, additional telegrams will be sent until the button is released or a timeout of 10s is reached. This timeout function prevents the unintended transmission over the extended time periods in case of a button was fixed. 2.3 Passive key functionality For passive key operation no user action on the key side is required. The trigger is delivered by the vehicle via an LF 125 kHz data telegram. When the key receives a valid LF message, it responds with two RF telegrams and the inter telegram timing in this mode depends on the key configuration data
(sort of time slot concept).
- The Low Frequency stage operates at 125 kHz
-3-
August 17, 2015 Continental Automotive France SAS Interior Division- Body & Security 3 Button functions The validation of the accurate frequency deviation and the measurement of the transmission function of the key are implemented basing on RF test software. The graphic below shows the functionality of the buttons. First Button Press and hold button press Button Lock Button UnLock Button Trunk Button Panic Lock vehicle Comfort Close Unlock vehicle Comfort Open Open trunk Open trunk Alarm signaling Alarm signaling 4 Key fobs Variants Product reference Product variant Drawing S180144500 Lock/Unlock 433.92 MHz S180144501 Lock/Unlock/Trunk 433.92 MHz
-4-
August 17, 2015 Continental Automotive France SAS Continental Automotive France SAS Interior Division- Body & Security Body & Security S180144502 Lock/Unlock/Panic 433.92 MHz S180144600 Lock/Unlock 315 MHz S180144601 Lock/Unlock/PSD-L 315 MHz S180144602 Lock/Unlock/PSD-
L/PSD-R 315 MHz S180144603 Lock/Unlock/PSD-L 433.92 MHz S180144604 Lock/Unlock/PSD-
L/PSD-R 433.92 MHz
-5-
August 17, 2015 Continental Automotive France SAS Interior Division- Body & Security S180144700 Lock/Unlock/PBD 433.92 MHz S180144701 Lock/Unlock/PBD/P 433.92 MHz S180144702 RES/Lock/Unlock/PBD 433.92 MHz S180144703 RES/Lock/Unlock/PBD/P 433.92 MHz
-6-
August 17, 2015 Continental Automotive France SAS Interior Division- Body & Security 5 Label Information Continental Model: TXN1 5.1 EC 5.2 USA/Canada Continental Model: TXN1 FCC ID: KR5TXN1 IC:7812D-TXN1 6 Owner Manual 6.1 Owner Manual USA/Canada FCC ID: KR5TXN1 IC:7812DTXN1 This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. This device complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS102 of the IC radio frequency
(RF) Exposure rules. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Le prsent appareil est conforme l'exposition aux radiations FCC / IC dfinies pour un environnement non contrl et rpond aux directives d'exposition de la frquence de la FCC radiofrquence (RF) et RSS102 de la frquence radio (RF) IC rgles d'exposition. L'metteur ne doit pas tre colocalis ni fonctionner conjointement avec autre antenne ou autre metteur.
-7-
August 17, 2015 Continental Automotive France SAS Interior Division- Body & Security This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
-
- Connect the equipment into an outlet on a circuit different from that to which the receiver is Increase the separation between the equipment and receiver. connected.
- Consult the dealer or an experienced radio/TV technician for help. CAN ICES-3 (B) / NMB-3 (B) This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numrique de classe B est conforme la norme canadienne NMB-003. Continental Automotive GmbH has not approved any changes or modifications to this device by the user. Any changes or modifications could void the users authority to operate the equipment. Continental Automotive GmbH napprouve aucune modification apporte lappareil par lutilisateur, quelle quen soit la nature. Tout changement ou modification peuvent annuler le droit dutilisation de lappareil par lutilisateur.
-8-
August 17, 2015