70 mm Pulse Led Speaker Operation Manual PARAMETERS m m 6 7 FB-CHBS-MC1 Radio function Long press the LED flashing light to operate Previous song Volume down Pause / Play Next track Volume up Operating distance : 10m Battery capacity : 300mAh Basic function : USB+FM+Bluetooth +LED flashing TWS : 1+1 couplet function Running time : 1.5-2hours Product size : 101*50*155mm Speaker size : 52mm Output power: 3W *1 Input voltage (V): 5V SNR: >=80dB Product material ABS Standby time: 100hours Speaker size: 52mm Impedance (): 4 Frequency response range : 80HZ-20KHZ Charging time : 2hours Package accessories : manual + USB charging cable BT ID: D059694 FCC ID: 2AANZCHBS CHARGING THE SPEAKER The speaker come with a built-in rechargeable lithium-ion batttery. Before using it for the first time, we recommed you charge the battery fully, only use the supplied USB cable to charge the speaker. Connect the USB cable to a computer USB port and the DC 5V plug to the charging jack of the speaker. The red LED light will illuminate while the speaker is charging. A full charge of the battery takes around 2hours, when the battery is fully charged, disconnect the speaker at this point.the speaker will be ready for use. PAIRING THE SPEAKER 1) ensure the speaker is turned off, if it is not, please turn off the speaker first before pairing. 2) Turn on power on/off button while the LED flashes blue. this will indicate your speaker is now in pairing mode. 3) Place the speaker and the bluetooth device to which you would like to pair it within the operating distance. we recommend keeping the two devices no further than 3 feet apart. 4) Ensure bluetooth is enabled on your phone or music device. refer to the manufacturer's instructions for how to enable Bluetooth on your device. 5) Once you have activated Bluetooth on your device, select the speaker CLIP 5+RGB From the list of available Bluetooth devices. 6) If pairing is unsuccessful, turn off the speaker first and repair following the aforementioned steps. Once you have paired the speaker with a device,the speaker will remember this device and will pair automatically when the devices bluetooth is activated and in range.you do not need to repair any previously connected devices. FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Please note that changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user tis encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. DGL Group, Ltd. 195 Raritan Center Parkway, Edison, NJ 08837 www.dglusa.com