Wiring Diagram - Inputs/Outputs FRONT REAR SUB L-CH R-CH Antenna Connector PINK Parking Brake (-) BLUE Remote Turn-On Connect to amplifier or power antenna. Insulate wire if not used. ORANGE | Reverse (+) BLACK Ground Connect to the vehicle chassis ground. RED Accessory Connect to an existing ignition circuit or switched 12 volt source. YELLOW Memory Connect to the battery circuit or constant 12 volt source. Right Front Gray/Black (-) Gray (+) Right Rear Violet/Black (-) Violet (+) Left Front White/Black (-) White (+) Left Rear Green/Black (-) Green (+) Control Locations 1 2 3 4 5 6 18 17 16 BLACK Steering Wheel Interface Camera Input Video Output FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XDVD770BT uses one 10 amp ATM fuse located in-line. General Operation Faceplate Removal Press OPEN to open the face plate, then pull away from the right side to remove. To re-install, insert right side of faceplate first then push left side to secure. Power On/Off Press or any other button to turn the unit on. Press to turn the unit off. Source Press SOURCE to enter the Source Menu, then press SOURCE or rotate the volume knob to select between RADIO, DISC, AUX, Bluetooth, USB modes. Modes of operation are shown in the display. Auxiliary Input The XDVD770BT offers auxiliary input ports for connecting an audio device, MP3 player, etc. Press SOURCE to select the auxiliary input mode. Volume Adjust volume using volume knob (00-46). Display Press DISP to toggle between ID3 tag and file/folder name for MP3 files being played from CDs or USB devices. Reset Press RESET upon initial installation or if abnormal operation occurs. Reset button is located behind the front panel. Set the Clock The unit will display the time on the LCD display.Clock settings are adjusted in the General setup menu. 12/24-hour Clock The clock will display 12-hour AM/PM time or 24-hour time(22:00). Frequency spacing is adjusted in the General setup menu. Tuner Operations Storing Station Presets Select the desired band and station. Press the
(F)unction button, turn the volume knob until the desired preset number is highlighted, then press SELECT to store the preset. Recalling Station Presets Press the P+ or P- buttons to cycle through the 1-6 presets in the current band. 15 14 13 12 11 10 9 1. Open 2. Mic 3. Talk 4. Play / Pause 5. Preset Up 6. Tune / Track Up 7. USB Port 8. Auxiliary Input 9. Function 10. Tune / Track Down 11. Preset Down 12. Volume Knob/ Select(push) 13. Display 14. Mute 15. Band / Go Back 16. Menu 17. Power 18. Source Remote Control 1. Power 2. Mode 3. Play/Pause 4. Mute 5. Title 6. Sub Title 7. Setup 8. Angle 9. Eject (This does not work with XDVD770BT) 15. Audio 16. Goto/*
17. Loud/End call 18. Number keys 19. Root 20. OSD
(On Screen Display) 21. Local/Random 22. Seek Down/
Prevous Track 10. Volume UP 11. Zoom 12. Select/Talk 13. Seek UP/Next Track 14. Volume Down 23. AS/PS/Repeat 24. Stereo 25. Stop 26. Enter 27. Band 27 26 25 24 23 22 21 20 19 18 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 7 8 CD Operation Press (F)unction to enter the Function Menu, then rotate the volume knob until Repeat / Random /
Intro is highlighted. Press SELECT, then rotate the volume knob to select one of the following repeat / Random / Into options. Setup Menu Operation Press MENU to toggle through and select one of the following setup menus: Audio, General, Gain and Radio, Screen, Disc. 1. Once the desired menu is displayed, rotate the volume knob to scroll through the list of menu features. 2. Press SELECT to select a specific feature to adjust, then rotate the volume knob left / right to adjust or activate the desired feature. 3. Press SELECT to confirm and save the changes. Audio Setup You can select Preset EQ (Flat, Pop, Jazz, Classic, Beat, Rock, User), 7 Band (60Hz, 150Hz, 400Hz, 1KHz, 3KHz, 7KHz, 15KHz), Balance, Fader, Loudness, Subwoofer On/Off. General Setup You can select the area of tuner mode, auto station store and Local/DX and adjust the clock. DVD Operation Screen Setup You can adjust Brightness, Contrast, Hue, Saturation, and Sharpness of the LCD. Disc Setup You can select the language and display type in DVD mode. Bluetooth Operation Bluetooth Microphone The microphone is built-in to the receiver. Pairing and Connecting Before you can use a Bluetooth device, it must be paired and connected. The Multi Media broadcasts the pairing signal constantly when no devices are currently connected. Complete the pairing sequence from your Bluetooth device. The device name is "Dual Multimedia Receiver". The Bluetooth passcode "0000". Once pairing is complete, most Bluetooth will connect automatically if the device is in range when the unit is powered-on. Making and Ending a Call Press to connect a call, and press to end a call. Accessing Recent Call List Press to access the recent call list and view/select numbers from recent Received, Dialed or Missed calls. Streaming Audio Press to play or pause the music. Press to skip to the previous track. Press to advance to the next track. One-Year Limited Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp. agrees, at our option, during the warranty period, to repair any defect in material or workman-
ship or to furnish an equal new, renewed or comparable product (whichever is deemed necessary) in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase. Subsequent replacement products are warranted for the balance of the original warranty period. Who is covered? This warranty is extended to the original retail purchaser for products purchased from an authorized Dual dealer and used in the U.S.A. What is covered? This warranty covers all defects in material and workmanship in this product. The following are not covered: software, installation/removal costs, damage resulting from accident, misuse, abuse, neglect, product modification, improper installation, incorrect line voltage, unauthorized repair or failure to follow instructions supplied with the product, or damage occurring during return shipment of the product. Specific license conditions and copyright notices for the software can be found via www.dualav.com. What to do?
1. Before you call for service, check the troubleshooting guide in your owners manual. A slight adjustment of any custom controls may save you a service call. 2. If you require service during the warranty period, you must carefully pack the product (preferably in the original package) and ship it by prepaid transportation with a copy of the original receipt from the retailer to an authorized service center. 3. Please describe your problem in writing and include your name, a return UPS shipping address (P.O. Box not acceptable), and a daytime phone number with your shipment. 4. For more information and for the location of the nearest authorized service center please contact us by one of the following methods:
(Monday-Friday, 9:00 a.m. to 5:00 p.m. EST)
v.com Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the companys negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages. FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. Increase the separation between the equipment and receiver.
:
www.dualav.com 2016 Dual Electronics Corp. NSC0616-V01 Printed in China XDVD770BT Multimedia DVD/CD Receiver with Bluetooth featuring a 3 digital TFT LCD This Quick Start Guide gives you the basics to start using your XDVD770BT. Please visit www.dualav.com/support/manuals.php to download a complete owners manual or call customer service at 1-866-382-5476 (Monday-Friday, 9AM-5PM EST). Installation OPTIONAL REAR MOUNTING SUPPORT REMOVAL KEYS HEAD UNIT MOUNTING SLEEVE TYPICAL DIN FRONT-LOAD MOUNTING METHOD Copyright and Trademark Notes This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited. DVD Logo is a trademark of DVD Format/
Logo Licensing Corporation registered in the U.S., Japan and other countries. SD Logo is a trademark of SD-3C, LLC. iPod and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries. Dual Electronics Corporation is not affiliated with Apple, Inc. Other trademarks and trade names are those of their respective owners.