FCC ID: B94SNPRC2150 802.11b/g/n (2.4GHz) Wi-Fi + BT / BLE Radio Module

Antenna

(keep out) Model Number: SNPRC-2150 ANATEL: XXXXX-21-XXXXX C-XXXXX XXX-XXXXXX m m 7 Rev 1.0 5 GHz band (W52,W53) Indoor use only

(Except for transmission with high power system) X-X-hpi-SNPRC-2150 FCC ID: B94SNPRC2150 IC: 466S-SNPRC2150 XXXX21XXXXXXXX

) t u o p e e k

a n n e t n A 7mm HP Inc. Connector

(Keep out) 7 m m

HP Inc. 3390 East Harmony Road, MS 66 Fort Collins, CO 80528 Tel:(970) 8988713 Date: February 23, 2021 Federal Communications Commission Office of Engineering and Technology Laboratory Division 7435 Oakland Mills Rd Columbia MD 21046-1609 Subject: Request for Confidentiality FCC ID: B94SNPRC2150 Product: 802.11 b/g/n (2.4 Ghz) WiFi + BT/BLE Radio module To Whom It May Concern, Pursuant to the provisions of Sections 0.457 and 0.459 of Commissions rules (47CFR0.457, 0.459), we are requesting the Commission to withhold the following attachment(s) as confidential document from public disclosure indefinitely. Block Diagram Circuit Schematic Diagram Circuit Description Operational Description Part List Tune-up Procedure Internal Photos User Manual Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. In additional to above mentioned documents, pursuant to Public Notice DA 04-1705 of the Commission s policy, in order to comply with the marketing regulations in 47 CFT 2.803 and the importation rules in 47 CFR 2.1204, while ensuring that business sensitive information remains confidential until the actual marketing of newly authorized devices. We are requesting the commission to grant short-term confidentiality request on the following attachment(s) for 180 days after the grant as outlined in Public Notice DA 04-1705. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. External Photos Test Setup Photos Best Regards,

Manish Oswal Wireless Regulatory Engineer Tel: +65 6703 2925 E-mail: Manish.Oswal@hp.com

Authorization on Behalf of HP Inc. For the US Federal Communications Commission Office of Engineering and Technology and Other FCC Programs and Offices 1. I, Richard P. Tarsio, am on the Worldwide Technical Regulations staff of HP Inc. (HP) and Applicant/Grantee Contact of Record for HP Inc. together with its subsidiaries and affiliates worldwide (collectively, HP) for HPs dealings with the United States Federal Communications Commission (FCC). I am duly authorized by HP Inc. to make this Authorization on HP Inc.s behalf. 2. This Authorization will designate the person named below to act on my behalf and HP Inc.s behalf as authorized agent and representative, until further notice, with the additional power to designate one or more third party agents for HP Inc. with regard to particular matters and applications. All acts carried out and requests made by this named representative relating to any matter before the FCC, including requests for confidentiality, shall have the same effect as mine. Name:

Title:

Address:

Telephone:

E-mail:

Manish Oswal Regulatory Engineer HP Singapore (Private) Limited. 1 Depot Close, Singapore, 109841

+65 67032925 manish.oswal@hp.com 3. Questions about the scope and effect of this Authorization should be addressed as follows:

4. I declare under penalty of perjury that the foregoing is true and correct, and that this Authorization was executed at Fort Collins, Colorado on the date indicated below my signature. Richard P Tarsio US Canada Technical Regulations 3390 East Harmony Road, MS 66 Fort Collins, CO 80528 970 898 8713 Telephone richard.tarsio@hp.com ____________________________ Signature Richard P Tarsio US Canada Technical Regulations HP Inc. Date: 17 August 2017

HP Inc. 3390 East Harmony Road, MS 66 Fort Collins, CO 80528 Tel:(970) 8988713 Request for Modular Approval for FCC ID: B94SNPRC2150 Date: December 2, 2020 Product: 802.11 b/g/n (2.4 GHz) WiFi + BT/BLE Radio module Item Requirements EUT 1. The radio elements must have the radio frequency circuitry The module is equipped with its own shielding case. shielded. Physical components and tuning capacitor(s) may be located external to the shield, but must be on the module assembly ensure that the device will comply with Part 15 requirements with any type of input signal 2. The module must have buffered modulation/data inputs to The module has buffer modulation / data inputs. 3. The module must contain power supply regulation on the The module has its own power supply regulation. The host supplies a module DC voltage and is regulated by the chip to the DC voltages used by 4. The module must contain a permanently attached The module has a permanently attached antenna, with the internal RF blocks. antenna, or contain a unique antenna connector, and be maximum gain 4 dBi marketed and operated only with specific antenna(s), per 15.203, 15.204(b), 15.204(c), 15.212(a), 2.929(b) 5. The module must demonstrate compliance in a The module was tested on evaluation board, and its not inside of stand-alone configuration another device during testing 6. The module must be labeled with its permanently affixed The module transmitter will be labeled with its own FCC ID, and for FCC ID label, or use an electronic display OEM integration the integration manual contains labeling instructions for the host device per Part 15.212 (vi) 7. The module must comply with all specific rules applicable The module approved transmitter complies with all applicable rules to the transmitter, including all the conditions provided in and the integration manual contains any specific requirements the integration instructions by the grantee addressed to the integrator and/or to the end-user of the final 8. The module must comply with RF exposure requirements The module complies with the FCC RF exposure requirements for fixed and mobile applications. RF exposure is addressed in the RF end-product. exposure exhibit. Sincerely yours,

Manish Oswal Wireless Regulatory Engineer E-mail: Manish.Oswal@hp.com

HP Inc. 3390 East Harmony Road, MS 66 Fort Collins, CO 80528 Tel:(970) 8988713 To whom it may concern, Date: February 23, 2021 According to KDB 726920 D01, the user's manual and internal photos of the radio module (RMN: SNPRC-2150 and FCC ID: B94SNPRC2150) exhibit may be given Long-term Confidentiality under the following special conditions:

b) Users manual and internal photos of the radio module may be held confidential only when the manual contains proprietary technical information intended for professional technicians obligated under a NDA. All sales and distribution of the users manual must be under a NDA that restricts the disclosure of the information. c) In the application cover letter requesting Long-Term Confidentiality the following additional description (in item 7) and the NDA exhibit is required:

1. Describe in detail how internal photos and/or users manual information are controlled to prevent them from becoming public or disclosed to unauthorized persons. 2. Describe how public access is restricted for products serviceable by professional designated technicians. 3. A statement that all sales of the non-consumer device will be under a NDA to include third party sales and that the final user of the device is subject to the NDA. 4. Provide an example of the NDA between the grantee and a purchaser. The request for confidentiality must include the key terms of the NDA to ensure consistency between the two. Response 1. This module is HP Inc. proprietary and will not be used or sold anywhere else. Confidentiality of the User Manual is maintained by requiring that any party that is supplied a user manual must first sign a non-disclosure agreement. 2. The module will only be installed and/or repaired in the HP Inc.'s factory and it does not open to the public. 3. The module is not subject to third part sales. The final user of the module is always the HP Inc. 4. A sample copy of the HP Inc. NDA requiring that any party that is supplied with a user manual must first sign a non-disclosure agreement attached. Sincerely yours, Manish Oswal Manish.oswal@hp.com

HP Inc. 3390 East Harmony Road, MS 66 Fort Collins, CO 80528 Tel:(970) 8988713 Date: December 1, 2020 To whom it may concern, Please be notified that I, Manish Oswal, have designated Jones Tsai in Sporton International Inc. as the person being responsible for this project and to sign the form 731 and other documentation. Any and all acts carried out by Jones Tsai in Sporton International Inc. on the matters of relating to all processes required in the FCC approval and any communication needed with the national authority, shall have the same legal authority as acts on our own behalf. We further certify that neither the applicant nor any party to this application, as defined in 47 CFR Ch. 1.2002 (b), is subject to a denial to Federal benefits, that include FCC benefits, pursuant to section 5301 of the Anti-Drug Abuse Act of 1998, 21 U.S.C. 862. This authorization is limited to the product of as following:

FCC ID: B94SNPRC2150 Product: 802.11 b/g/n (2.4 GHz) WiFi + BT/BLE Radio module If you have any acknowledgement and response, please send it to Sporton International Inc. directly. Sincerely yours,

Manish Oswal Wireless Regulatory Engineer Tel: +65 6703 2925 E-mail: Manish.Oswal@hp.com