This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
(2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected. Attention:
1. Please keep the charger away from water or other liquid. 2. Please make sure its not connected with power supply when you need to clean the charger. 3. Using environmental temperature remains 0-45C Specications:
Power:10W/7.5W/5W Input: 5V-2A, 9V-1.67A Output: 5V/1A 9V/1.1A Coil type: single coil Transmission distance: 5mm Working frequency: 137KHZ Conversion eciency: 75%
Includes:
Wireless Charger Micro Cable
(Cord plugs into USB-A outlets.) Charging Devices:
Plug USB cord into USB port, make sure the micro plug in the charging pad is connected/secure. Small LED light on charging pad will light up when plugged into USB port. Place phone/device on charging pad. Check/Conrm, LED light will change from Red to Blue when device is charging. Reposition device if charger not engaging. Note:
Wireless charger is intelligent item with simple design, compatible with any mobile phones with Qi standard. Please note that receiver is required if your phone doesnt support. Made in China