NO.: 84555 INSTRUCTION dade o/s) i MULTI- FULL HIGH GRIP WORKING PLAYERS FUNCTION TYRES SUSPENSIONS
> YAMAHA Contents
-RC Vehicle (Vehicle) x 1
-RC Transmitter (Transmitter) x 1
-Instruction Manual x 1
+/+]/+]+]+ Epa Aaa
-{-{-[-[- (Not Included) RC Transmitter x 1 RC Vehicle x 1 Battery Precaution 1. Alkaline batteries are recommended to be used 8. Be sure to insert batteries with correct polarities and always follow the battery 2. Only batteries of the same or equivalent type as recommended are to be used manufacturers instructions 3. Do not mix alkaline, standard or rechargeable batteries 9. Remove all batteries from the Vehicle and Transmitter when not in use 4. Do not mix old and new batteries or different type of batteries 10. Exhausted batteries are to be removed from the product 5. Non-rechargeable batteries are not to be charged 11. The supply terminals are not to be short-circuited 6. If rechargeable batteries are to be used, they are only to be charged under 12. Dispose of batteries properly. Do not dispose the batteries in fire it may adult supervision cause them to explode or leak causing injury or damage 7. Rechargeable batteries are to be removed from the product before they 13. Battery installation and removal must only be done by adult are charged erica Installation For Vehicle (Fig. 1 and Fig. 2) For Transmitter (Fig. 3 and Fig. 4) 1. Switch OFF the power 1. Unscrew the screw on the battery cover 2. Unscrew the screw on the battery cover 2. Open the battery cover 3. Open the battery cover 3. Install 2 new 1.5V AAA batteries with correct polarities (+/-) 4. Install 5 new 1.5V AA batteries with correct polarities (+/-) as shown inside the battery compartment as shown inside the battery compartment 4. Close the battery cover 5. Close the battery cover i 6. Tighten the screw on the battery cover 5. Tighten the screw on the battery cover 5 a Ueelaiicele
(ese |
a4 Kor 9 Direction 2 2 2 Adjustment lial : r |
lila l o ON/OFF I I od Bind key Steering
: Accelerator wheel Battery Trigger Compartment | |
Fig. 1 s ae 0 METS armel ccd How To Bind 1. Turn on the Vehicle. 2. Hold the Signal Match Button for 4 second then the Transmitter signal light will flash for 6-7 second. When the Transmitter signal light keep on will show the matching. 3. After the wheels of the Vehicle turn left and right and the LED light of the Transmitter stops flashing, the binding process completed for playing. 4. If it cannot complete within 8 seconds, please turn off both Vehicle and Transmitter and re-start the binding process. 5. When the binding process is done, whenever switching the Vehicle and Transmitter on and off, it searches for the code that it memorized, and will only lock on to the Transmitter signal containing that code. 6. Please turn off both Vehicle and Transmitter and re-start all binding process if changing to another 2.4GHz Transmitter for playing. aoe e Ww T Ml 3. Use the Accelerator Trigger to drive the Vehicle Forward, Stop and Backward 1. Switch ON the Vehicle. Backward
(BoO)s8) r S\
d\
4. Ifthe vehicle does not run in straight line, adjust the Direction Adjustment on the Vehicle chassis (Fig.1) 5. Play on smooth surface to have the optimum performance 6. Remember to switch OFF the power of the Vehicle after playing 7. The optimum control range is up to 25m outdoor Performance Tips :
1. Do not drive on grass, dirt, sand, dusts, carpet or go through water Cautions ; ; ;
2. Do not drive in windy or rainy weather 1. Do not attempt to disassemble the Vehicle or Transmitter 3. Avoid direct impact the Vehicle with obstacles 2. Make sure the batteries are installed with correct polarities (+/-) as shown inside 4. eer the paver ee pe in ee to prevent damage of Vehicle and Transmitter the battery compartment ue to leakage of electrolyte from batteries F fe Ff 5. Remove all batteries from the Vehicle and Transmitter when not in use for long period 2 eee ei bi a a kL 6. Keep fingers, hair and loose clothing away from wheels Liglatsiqailbateiuertslallfeise) ple hy 7. The operating range can be affected by a variety of factors f F f ini F f a) Low Voltage of batteries in Transmitter or Vehicle te ssa (as hse instruction manual contain important information. Please keep b) Interference from other items that emit radio frequency signals SAMS WEIS Se Ree ; ;
8. Outdoor usage is recommended in order to get optimum control range Warning! Choking Hazard. Not suitable for children under the age of 3 years due to 9. Recommend to play the vehicle on a clean and smooth surface small parts. 10. Clean the battery compartment to make sure it is free from dust to prevent poor We reserve the right to improve/amend specifications and colors without notice. contact of batteries FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is needed
- Consult the dealer or an experienced radio/TV technician for help Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. RSS-210 Compliance Statement:
This device complies contains licence-exempt transmitter that comply with Innovation Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) Lappareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Declaration of Conformity The product is in conformity with the requirement of EU Directive 2014/53/EU. Environmental notes:
The whole product also does not belong to household waste at the end of the product life. You can return it at collection points for the recycling of electronic and electronical instruments The symbol on the item, instruction manual, hangtag or packing is showing this clearly. Materials should be recycled according to their respective markings. Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection. Please ask at your local community for the correct collection point. www.kidztech.net Disposal of batteries Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold. You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb=Battery contains lead > (conforms to the safety requirements of ASTM F963) Cd=Battery contains cadmium ab YA M A HH A Hg=Battery contains mercury LICENSED PRODUCT KIDZTECH TOYS MANUFACTURING LTD. Room 1201,12/F, Inter-Continental Plaza, YAMAHA,The Tuning Fork Mark, YXZ1000R, and the likeness thereof including the graphics are properties of Yamaha Motor Co,, Ltd., 94 Granville Road, TST East, Hong Kong. caeee nae 2d by KIDZTECH TOYS MANUFACTURING LTD. Tal: (652) 27218608 info@kidziech:net All Rights Reserved eae : Made in China _http://www.kidztech.net The packaging contain important information, Please keep for future reference. 20180612