CONTENTS TOTAL: 85 PIECES x 2 x 2 x 4 x 4 x 16 NO. 83151 / 83161 LAYOUT
#83151 BATTERY REQUIREMENTS
#83161 BATTERY REQUIREMENTS 6 X AA For Control Box
(Not Included) OR 4 X AAA For Transmitter x2
(Not Included) Transformer For Control Box
(Included only for #83161) INPUT: AC100-240Vac 50/60Hz 0.4A OUTPUT: DC9V 1.5A 4 X AAA For Transmitter x2
(Not Included) Recommend to play by adaptor ASSEMBLY X SLOT CAR TRACK SET - INSTRUCTION MANUAL CHALLENGE LEVEL - 660CM / 21.6FT x 16 x 1 x 1 5+
D x 4 H D x 4 H x 1 x 1 x 1 x 2 x 2 x 2 L L L D x 4 L D x 4 Z Z F H L L K O H L L L F L L L ASSEMBLY x 12 Y x 6 Z x 2 x 2Z x 8 Adjust the distorted joints before joining tracks. Do not join the tracks together if the joints are distorted. Hold and join tracks together as shown. Attach the guardrail to the side of the track as shown. Assemble the track support TO PLAY Control box - Battery installation (For B/O Version) 2. Open the battery cover. 1. Unscrew the screw on the battery cover. 3. Insert new 6 x AA (1.5V) batteries into the battery compartment of the control box with the correct polarity (+/). 4. Close the battery cover. 5. Tighten the screw on the battery cover. Transmitter - Battery installation Transformer For Control Box
(Included only for #83161) ON OFF DC
(USE AA BATTERIES)
(USE Transformer) Speed Control MAINTENANCE 1. Unscrew the screw on the battery cover. 2. Open the battery cover. 3. Insert new 2 x AAA (1.5V) batteries into the battery compartment of each transmitter with the correct polarity (+/). 4. Close the battery cover. 5. Tighten the screw on the battery cover. Make sure that the brushes are adjusted to the correct position as indicated. BRUSHES Guide pin Guide pin must be in the slot as shown. Check the brushes of the car are in the correct position. Place the car on the track and make sure it has good contacts with the track. The packaging and instruction manual contain important information. Please keep them for future reference. We reserve the right to improve/amend specifications and colors without notice. SAFETY are to be used 1. Alkaline batteries are recommended to be used (For B/O Version) 2. Only batteries of the same or equivalent type as recommended 3. Do not mix alkaline, standard or rechargeable batteries 4. Do not mix old and new batteries or different type of batteries 5. Non-rechargeable batteries are not to be charged 6. Rechargeable batteries for adult charging only 7. Rechargeable batteries are to be removed from the product before they are charged 8. Be sure to insert batteries with correct polarities and always follow the battery manufacturers instructions 9. Remove all batteries when not in use 10. Exhausted batteries are to be removed from the product 11. The supply terminals are not to be short-circuited 12. Dispose of batteries properly. Do not dispose the batteries in fire it may cause them to explode or leak causing injury or damage 13. Battery installation and removal must only be done by adult FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Increase the separation between the equipment and receiver RSS-210 Compliance Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.ion. Declaration of Conformity The product is in conformity with the requirement of EU Directive 2014/53/EU The instructions for battery toys with replaceable batteries shall contain the substance of the following, as applicable:
Control box : AA batteries x 6 should be used. Transmitter : AAA batteries x 4 (2 for each Transmitter) should be used. Frequency band : 2408 2475 MHz Maximum radio frequency power transmitted : <0 dBm 2450 - 2460 MHz Environmental notes:
The whole product also does not belong to household waste at the end of the product life. You can return it at collection points for the recycling of electronic and electronical instruments The symbol on the item, instruction manual, hangtag or packing is showing this clearly. Materials should be recycled according to their respective markings. Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection. Please ask at your local community for the correct collection point. Disposal of batteries Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold.You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb=Battery contains lead Cd=Battery contains cadmium Hg=Battery contains mercury PRODUCT MUST BE ASSEMBLED BY ADULT ONLY. Kidztech Toys Manufacturing Ltd., Hong Kong. MADE IN CHINA. HOT WHEELS and associated trademarks and trade dress are owned by, and used under license from Mattel. 2019 Mattel. All Rights Reserved. KIDZTECH TOYS MANUFACTURING LTD. Room 802, 8/F, Inter-Continental Plaza, 94 Granville Road, TST East, Hong Kong. Tel: (852) 27218868 info@kidztech.net http://www.kidztech.net SLOT CAR TRACK SET PRODUCT:
AGE GRADE: For ages over 5 years. CONTENTS:
All contents listed here. NO. 83151 / 83161 KT-HW-10/06/19 EN-R01 Make sure that the wheel tyres are located as shown. Conforms to the safety requirements of ASTM F963