How To Bind 1. Tum on the Vehicle. 2. Keep pulling the trigger of the Transmitter forward then tum the Transmitter on. Do not release the trigger until the binding process completed. 3. The LED light of the Transmitter will keep flashing for the binding process, which is within 8 seconds. Do not turn off any buttons while in progress, otherwise, the process will be terminated. 4. After the wheels of the Vehicle tum left and right and the LED light of the Transmitter stops flashing, the binding process completed for playing. 5. If it cannot complete within 8 seconds, please turn off both Vehicle and Transmitter and re-start the binding process. 6. When the binding process is done, whenever switching the Vehicle and Transmitter on and off, it searches for the code that it memorized, and will only lock on to the Transmitter signal containing that code. 7. Please tum off both Vehicle and Transmitter and re-start all binding process if changing to another 2.4GHz Transmitter for playing. evar a Le) od CM 3. Use the Accelerator Trigger to drive the Vehicle Forward, Stop and Backward 1. Switch ON the Vehicle and Transmitter. ig 4, Ifthe vehicle does not run in straight line, adjust the Direction Adjustment on the Vehicle chassis 5. Play on smooth surface to have the optimum performance 6. Remember to switch OFF the power of the Vehicle and Transmitter after playing 7. The optimum control range is up to 40m outdoor Braking Action Keep driving forward rapidly then switch to backward for the braking action. When the trigger of the Transmitter returns to the center position, push it again for the backward action. Performance Tips 4. Do not drive on grass, dirt, sand, dusts, carpet or go through water Cautions ; . ;
2. Do not drive in windy or rainy weather 1. Do not attempt to disassemble the Vehicle or Transmitter 3. Avoid direct impact the Vehicle with obstacles 2. Make sure the batteries ara installed with correct polarities (+/-) as shown inside the. 4. Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter ea a ; - ;
due to leakage of electrolyte from batteries 3. Remove the Lata and take out all accessories before giving the Vehicle and 5. Remove all batteries from the Vehicle and Transmitter when not in use for long period Mak 6. Keep fingers, hair and loose clothing away from wheels The packaging and instruction manual contain important information. Please keep them 7. The operating range can be affected by a variety of factors Bec Me= (=e a) Low Voltage of batteries in Transmitter or Vehicle Waming! Choking Hazard. Not suitable for children under the age of 3 years due to b) Interference from other items that emit radio frequency signals Sc ce 8. Outdoor usage is recommended in order to get optimum control range Dna eeu ele cee eee ul Uae e 9. Recommend to play the vehicle on a clean and smooth surface 10. Clean the battery compartment to make sure It Is free from dust to prevent poor contact of batteries FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation Is subject to the following two conditions:
1. This device may not cause harmful Interference, and 2. This device must accept any Interference recelved, Including Interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment doss cause harmful interference to radio or television recaption, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interferance by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and recsiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help Warming: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RSS-210 Compliance Statement:
This device complies with Industry Canada Licence-exempt RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Declaration of Conformity The product is in conformity with the requirement of EU Directive 1999/5/EC Environmental notes:
The whole product also does not belong to household waste at the end of the product life. You can retum it at collection points for the recycling of electronic and electronical instruments The symbol on the item, instruction manual, hangtag or packing is showing this clearly. Materials should be recycled according to their respective markings. Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection. Please ask at your local community for the correct collection point. Disposal of batteries Batteries should not be disposed of in the household waste. As the consumer you are legally D4 obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold. (Conforms tothe safety requirements of ASTM F963) You will find these chemical abbreviations along with a crossed-out refuse bin on batteries Confoiaito tha tafaty requirersants of ASTIA F963 containing harmful substances: KIDZTECH TOYS MANUFACTURING LTD. Pb=Battery contains lead & ) te Room 1204,12/F, inter-Continental Plaza, Cd=Battery contains cadmium 94 Granville Road, TST East, Hong Kong. Hg=Battery contains mercury Tel: (852) 27218968 | Info@kddztoch.net Made in China httpiiwww.kidztech.net