NO. 84058 Transmitter: 2 X 1.5V AA Batteries (not included) 2 x AA Batteries For Transmitter
(Not Included) Instruction Manual x 1 Battery Installation ON / OFF 1. Unscrew the screw on the battery cover. 2. Open the battery cover. 3. Install 2 new AA batteries with correct polarity (+/-) as shown inside the battery compartment. 4. Close the battery cover. 5. Tighten the screw on the battery cover. How To Bind 1. Turn on the Vehicle. 2. Install batteries in the Transmitter then the Transmitter signal light will flash for a few seconds. 3. After the wheels of the Vehicle turn left and right and the LED light of the Transmitter stops flashing, the binding process completed for playing. 4. If it cannot complete within 8 seconds, please turn off the Vehicle and re-start the binding process. 5. When the binding process is done, whenever switching the Vehicle on and off, it searches for the code that it memorized, and will only lock on to the Transmitter signal containing that code. 6. Please turn off the Vehicle and re-start all binding process if changing to another 2.4GHz Transmitter for playing. 1. Switch ON the Vehicle. 2. Use the Forward / Backward button (Fig.5) to drive the Vehicle forward and backward. 3. Use the Left / Right button (Fig.5) to control the Vehicle turning left or right. 4. If the vehicle does not run in straight line, adjust the wheel alignment lever on the vehicle chassis (Fig.6). 5. Play on smooth surface to have the optimum performance. 6. Remember to switch OFF the power of the Vehicle after playing. 7. The optimum control range is up to 25m(82ft)outdoor. FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Increase the separation between the equipment and receiver
- Reorient or relocate the receiving antenna
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. RSS-210 Compliance Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. Declaration of Conformity The product is in conformity with the requirement of EU Directive 2014/53/EU. Environmental notes:
The whole product also does not belong to household waste at the end of the product life. You can return it at collection points for the recycling of electronic and electronical instruments The symbol on the item, instruction manual, hangtag or packing is showing this clearly. Materials should be recycled according to their respective markings. Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection. Please ask at your local community for the correct collection point. Disposal of batteries Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold. You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb=Battery contains lead Cd=Battery contains cadmium Hg=Battery contains mercury www.kidztechtoys.com KIDZTECH TOYS MANUFACTURING LTD. Room 802, 8/F, Inter-Continental Plaza, 94 Granville Road, TST East, Hong Kong. Tel: (852) 27218868 info@kidztech.net Made in China http://www.kidztechtoys.com US OFFICE:
1540 Forest Avenue, River Forest, IL 60305, USA Tel: 708-689-0085 Fax: 708-689-8172