FCC ID: SP9-00011HB HydraBlast

HydraBlast Everythingproof TM

Wireless Speaker

IMW1300

QUICK START GUIDE

IMW1300 HydraBlast Everythingproof

Wireless Speaker

TM

Carabiner

In the Box

USB-C Charging Cable

Charging

≈3-4 Hours

Full Charge

(red) = Charging

(off) = Charging

Complete

Speaker

Controls

PRESS

+

-

Volume Up

Volume Down

Play/Pause

PRESS & HOLD (2 sec)

ON/OFF

Next Track

Previous Track

+

-

Answer & End Call

Reject Incoming Call

Voice Assistant /

Reset

Press

To activate Voice Assistant

(Siri or Google Assistant)

Reset- Press & Hold

Disconnect Bluetooth: Press

and hold for five seconds and

the speaker will beep

Reset All connections: Press

and hold for ten seconds and

the speaker will power off

Overall battery performance varies dependent upon

use setting, and environmental conditions. For

further information, please visit

www.alteclansing.com

Changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment. This

device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following

measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment.

This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

Sakar International Inc.

195 Carter Drive

Edison, New Jersey 08817, USA

855-292-4087

www.alteclansing.com

A Closer Look

Power Button

Link Button

Color Change Button

Volume Down/Previous Track

Volume Up/Next Track

USB-C Charging

Port

Reset

USB Port

Powering On/

Bluetooth

Pairing

PRESS & HOLD

1-2 SEC

Pairing Mode

Flashing Blue

Paired

Solid Blue

connected

AL HydraBlast

True Wireless

Pairing

Turn on the first speaker and connect It

with a Bluetooth compatible device.

PRESS & HOLD

1-2 SEC

Turn on the second speaker and press the

button on that speaker.

Second Speaker

Flashing Green = Pairing

Solid Green = Paired

Press and hold the button for 2-3

seconds on the first speaker. The first

speaker will now connect to the second

so they both play in sync. The Link Buttons

will illuminate green.

To end TWS press & hold the power button

on the speaker.

There are two modes:

Mode 1: Dual Stereo, both play stereo for parties etc.

Mode 2: Wide Stereo, one plays left and the other right.

Briefly press the button to switch between the

modes.

Light Change

Mode

Press

To toggle between the different light modes:

1. Multicolor slow transition

2. Single color pulse to music

3. Multi color pulse to music

4. Single color slow fade

5. Single color

6. Multicolor cycle changed

7. Multicolor fast changed

with background color

8. Multicolor slow fade

9. Four color slow fade

10. Four color rotation

with pulse to music

11. Four color rotation

12. Off

Press & Hold the button for 1-2 sec to

change the Strobe light modes.

* off Pulse to music Blink off *

IMW1300 Rating Label

1). Rating Label

Size : 35mm x 30mm

35.00 mm

IMW1300

MODEL NUMBER

Power Source: DC 5V 1A

FCC ID SP9-00011HB

www. alteclansing.com

MID#2390821

Made in China

m

m

0

0

.

0

3

2). FCC Label

Size : 45mm x 30mm

m

m

0

0

.

0

3

FCC ID: SP9-00011HB

This device complies with Par t

15 of the FCC Rules. Operation

is subject to the following two

conditions: (1) this device may

not cause har mful interference,

and (2) this device must accept

any interference received,

including interference that may

cause undesired operation.

45.00 mm

3).

Serial Number Label

(24x7mm)

* Letters H=2mm *

材质：普通贴纸，印白底黑字过光膜

m

m

0

0

.

4

S/N: KY1300000001

K Y 4 7 8 7 0 0 0 0 0 1

m

m

0

0

.

7

m

m

0

0

.

2

2 6 .0 0 m m

IMW1300

S/N: KY1301012679

S/N: KY1301016318

SGS North America Inc. Applicant Declaration 620 Old Peachtree Road SUITE 100 Suwanee, Georgia 30024 United States Applicant Legal Business Name Kysho Multimedia Ltd. Flat F, 5/F, Valiant Industrial Centre 2-12 Au Pui Wan StreetFo Tan Hong Kong, China SP9.0001HB Akiyuki Yasuda Contact Email kysholtd@netvigator.com 852-2799 2895

|, the undersigned, certify that | am an authorized signatory for the Applicant and therefore declare;

a) in accordance with 47CFR2.911(d), all of the statements herein and the exhibits attached hereto are true and correct to the best of my knowledge and belief. b) in accepting a Grant of Equipment Authorization issued by a TCB, under the authority of the FCC, as a result of the representations made in this application, the Applicant is responsible for:

(1) labeling the equipment with the exact FCC ID as specified in this application,

(2) compliance statement labeling pursuant to the applicable rules,

(3) compliance of the equipment with the applicable technical rules, c) _ if the Applicant is not the actual manufacturer of the equipment, appropriate arrangements have been made with the manufacturer to ensure that production units of this equipment will continue to comply with the FCCs technical requirements. d) in accordance with 47 CFR 2.909 and KDB394321, the Applicant has read, understood and agrees to accept that they are the responsible party and agree to abide by their responsibilities as specified under 47 CFR 2.909 and KDB394321. e) in accordance with 15017065, FCC KDB641163, FCC KDB610077, KDB394321 and RSP-100, the Applicant has read, understood, accepts and agrees to abide by the post market surveillance requirements.

(1) the Applicant understands, accepts and agrees that a sample may be requested for surveillance testing.

(2) the Applicant shaff make provisions to always have a production sample available upon request by SGS, FCC and/or ISED.

(3) the Applicant shall, upon request by SGS, at the Applicant's expense, provide a production sample of the requested product to SGS, FCC and/or ISED as instructed. The sample shall include all support devices, cables, software, accessories or other hardware or software required for evaluation, review, certification and audit surveillance of products certified by SGS. f) neither the Applicant nor any party to the application is subject to a denial of Federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862 because of a conviction for possession or distribution of a controlled substance. See 47CFR 1.2002(b) for the definition of a party for these purposes. g) the Applicant has read, understood, accepts and agrees to abide by the SGS North America, Inc.(TCB) terms and conditions. Link to CFRs: https://www.fcc.gov/wireless/bureau-divisionsechnologies-systems-and-innovation-division/rules-regulations-title-47 Link to KDBs: hitps://apps.fcc.gov/oetcf/kdb/index.cfm Link to RSP-100: httos://www.ic.gc.ca/eic/site/smt-qst.nsf/eng/sf01130.html Date: 8/16/2021 Title: President

*NOTE: This declaration cannot be signed by an Agent, it shall be signed by an authorized person listed in the FCC database Applicant Declaration Rev:0.0

KYSHO Multimedia LTD. Flat F, 5/F., Valiant Industrial Centre, Tel. : (852) 2799 2895 (3 Lines) 2-12 Au Pui Wan Street, Fax : (852) 2755 0533 KYSHO Fo Tan, Shatin, N. T., Hong Kong. Date: 8/16/2021 TO: Federal Communication Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MID 21046 Regarding: FCC ID: SP9-00011HB To whom it may concern:

We, the undersigned, hereby authorize SGS-CSTC Standards Technical Services Co., Ltd. (SGS) Guangzhou branch and Kobe Jian in SGS-CSTC Standards Technical Services Co., Ltd. (SGS) Guangzhou branch to act on our behalf in all manners relating to application for equipment authorization with respect to the FCC ID above, including signing of all documents relating to these matters. Any and all acts carried out by the agent on our behalf shall have the same effect as acts of our own. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 853(a). Where our agent signs the application for certification on our behalf, | acknowledge that all responsibility for complying with the terms and conditions for Certification, as specified by SGS North America, Inc., still resides with Kysho Multimedia Ltd.. This authorization is valid until further written notice from the applicant. Name (Printed): Akiyuki Yasuda Title: President For and on beh

KYSHO Signature:

On behalf of Company. Kysho Multimedia Ltd. Registered Office: Flat/RmB, 3/E, Chung Pont Commercial Building, 300 Hennessy Road, Wanchai, Hong Kong.

KYSHO Multimedia LTD. Flat F, 5/F., Valiant Industrial Centre, Tel. : (852) 2799 2895 (3 Lines) 2-12 Au Pui Wan Street, Fax : (852) 2755 0533 KYSHO Fo Tan, Shatin, N. T., Hong Kong. Date: 8/16/2021 To: SGS North America Inc. 620 Old Peachtree Road SUITE 100 Suwanee, Georgia United States From: Kysho Multimedia Ltd. Flat F, 5/F, Valiant Industrial Centre 2-12 Au Pui Wan Street Fo Tan Hong Kong, China Regarding: Confidentiality Request regarding application for FCC ID: SP9-00011HB LONG TERM CONFIDENTIALITY Pursuant to 47 CFR Section 0.459 and 0.457 of the commissions rules, the applicant hereby request confidential treatment of the documents listed below, associated with the certification application referenced above. Schematic(s) Block Diagrams Operational Descriptions The documents above contain proprietary information not released to the public. Public disclosure of this information may prove harmful to the business of the applicant. Sincerely, Name (Printed): Akiyuki Yasuda Title: President

& Re Signature: EDIA LIMITED thorized Signature(s) On behalf of Comparfy: Kysho Multimedia Ltd. Registered Office: Flat/RmB, 3/E, Chung Pont Commercial Building, 300 Hennessy Road, Wanchai, Hong Kong.