Certification Exhibit FCC ID: R7PIWRS5 IC: 5294A-IWRS5 FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-210 ACS Project Number: 14-0461 Manufacturer: Landis+Gyr Technology Inc. Model: Gridstream Series-5 IWR 5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598 Landis+Gyr Gridstream RF Series V IWR Radio Data Sheet Publication: 98-1215 Rev AD LANDIS+GYR CONFIDENTIAL INFORMATION Limitation on Warranties and Liability Information in this document is subject to change without notice. This manual or any part of it thereof may not be re-
produced in any form unless permitted by contract or by written permission of Landis+Gyr. In no event will Landis+Gyr be liable for any incidental, indirect, special, or consequential damages (including lost prof-
its) arising out of or relating to this publication or the information contained in it, even if Landis+Gyr has been advised, knew, or should have known of the possibility of such damages. 2014 Landis+Gyr, Inc. All Rights Reserved Landis+Gyr Gridstream RF Series V IWR Radio Data Sheet Publication: 98-1215 Rev AD Modification Date Revision Description Author Revision History 12/17/2014 12/09/2014 07/28/2014 05/28/2014 AD AC AB AA Review Released Released Released 2014 Landis+Gyr All rights reserved Jake Harsha Jake Harsha Kim Utesch Kim Utesch Landis+Gyr Gridstream RF Series V IWR Radio Data Sheet General The Landis+Gyr Gridstream RF Series V Integrated WanGate Radio (IWR) provides a basis for a powerful RF wireless mesh network for remote data collection and end device monitoring and con-
trol. The radio provides full two-way peer-to-peer communication to all devices within the network. The IWR also offers advanced functionality, such as individual message prioritization, additional memory for localized intelligence, and a programming language Device Control Word (DCW) used to provide interface and control to distributed automation equipment. The IWR has one RS-232 serial port for the LAN Packet Port (LPP) and one RS-232/485 serial port for the Transparent Packet Port (TPP). The LAN Packet Protocol Port is used to communicate to de-
vices that use the Gridstream IWR LAN Packet Protocol, such as a PC with configuration or diagnos-
tic software. The Transparent Packet Port is a general-purpose data port that is used to transport byte-
oriented data, such as DNP 3.0, Modbus, or DF1. NOTE: The mini-USB port is a nonfunctional feature that will be utilized in future releases. Data Sheet 98-1215 Rev AD 3 Figure 1. Landis+Gyr Gridstream Series V IWR Radio Landis+Gyr Gridstream RF Series V IWR Radio Data Sheet Landis+Gyr IWR Usage The IWR was engineered specifically for varied needs of residential and commercial applications. It enables access to the RF mesh network using a standard RS-232 connection. Useful features of the IWR include:
Simultaneous connections per RS-232 interface by:
LPP applications TPP applications FCC and Industry Canada Compliance FCC Class B This device complies with Part 15 of the FCC rules. Operation is subject to the following two condi-
tions:
1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the Instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television re-
ception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Consult Landis+Gyr or an experienced radio technician for help Increase the separation between the equipment and receiver. U WARNING: Changes or modifications to this device not expressly approved by Landis+Gyr could void the users authority to operate the equipment. RF Exposure This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 22 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 4 98-1215 Rev AD Data Sheet Landis+Gyr Landis+Gyr Gridstream RF Series V IWR Radio Data Sheet Industry Canada This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. This radio transmitter (identify the device by certification number, or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Approved Antenna: Omni-directional antenna, 5.5 dBi gain, 902-928 MHz, antenna impedance is 50 ohms. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Conformment la rglementation d'Industrie Canada, le prsent metteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou infrieur) approuv pour l'metteur par Industrie Canada. Dans le but de rduire les risques de brouillage radiolectrique l'intention des autres utili-
sateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonne quiv-
alente (p.i.r.e.) ne dpasse pas l'intensit ncessaire l'tablissement d'une communication satisfaisante. Le prsent metteur radio (identifier le dispositif par son numro de certification ou son numro de modle s'il fait partie du matriel de catgorie I) a t approuv par Industrie Canada pour fonctionner avec les types d'antenne numrs ci-dessous et ayant un gain admissible maximal et l'impdance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est suprieur au gain maximal indiqu, sont strictement interdits pour l'exploitation de l'metteur. Anatel Este equipamento opera em carter secundrio, isto , no tem direito a proteo contra interferncia prejudicial, mesmo de estaes do mesmo tipo, e no pode causar interferncia a sistemas operando em carter primrio. Data Sheet 98-1215 Rev AD 5 Landis+Gyr Gridstream RF Series V IWR Radio Data Sheet Landis+Gyr Gridstream Series V IWR Radio Specifications Table 1. General Series V IWR Specifications Electrical (General) Input Voltage Range 6 - 28 VDC Input Current (in transmitting mode) 320 mA typical (12 VDC operation) Input Current (in receiving mode) 38 mA typical (12 VDC operation) Processor Internal Memory (DDR) Serial Flash Radio (General) 160kb ROM, 32kb SRAM (Internal) 16 MB 8 MB Communication Protocol (PHY) IEEE 802.15.4g (G5i), proprietary Gridstream RF RF Frequency Range 902-928 MHz Channel Spacing RF Data Rate Receiver 200, 400 kHz (G5i) 100, 300, 500 kHz (Gridstream proprietary) 50, 150, 200 kbps (G5i) 9.6, 19.2, 38.4, 115.2, 300 kbps (Gridstream proprietary) Sensitivity (at 10% packet error rate)
-112 dBm (9.6 Kbps) Typical / -101 dBm (115.2 Kbps) Typical,
-95 dBm (300 Kbps) typical Adjacent Channel Rejection Alternate Channel Rejection Transmitter 35 dB Typical 50 dB Typical Output Power (at Antenna Connector) 21/25/30 dBm (user selectable) Modulation Type Out-of-band Spurious Emissions FSK/GFSK
<-70 dBc 6 98-1215 Rev AD Data Sheet