Product Specification User Manual
&
Product Specification WN7522C 2-LF-19 IEEE Single Band 802.11b/g/n USB2.0 Module V1.0 WN7522C 2 1 Product Specification Chapter 2 Table of Contents Chapter 1 Introduction ________________________________________________________ 4 1. Introduction ________________________________________________________ 4 1.1 Product Features____________________________________________________ 4 1.2 Applications _______________________________________________________ 4 Hardware _______________________________________________________ 5 2.1 General Overview __________________________________________________ 5 2.2 Hardware Architecture _______________________________________________ 5 2.3 Main Chipset Information ____________________________________________ 5 Software _______________________________________________________ 5 3.1 Operating System Supported __________________________________________ 6 3.2 Wireless Mode Supported ____________________________________________ 6 3.3 Security___________________________________________________________ 6 3.4 Configuration ______________________________________________________ 6 Specifications ___________________________________________________ 7 Statement_______________________________________________________ 9 Chapter 3 Chapter 4 Chapter 5 WN7522C 2 2 Revision History Edition #
Reason for revision V 01 V02 Initial Document Revise the Frequency band in France/
Regulation/Security Product Specification Issue date July 27, 2009 Nov 4th 2009 Written by Troy Chen Troy Chen WN7522C 2 3 Product Specification Chapter 1 Introduction 1. Introduction WN7522C 2 is a single band wireless 802.11 b/g/n USB module for LG Blu-ray players and home theater corresponding devices. It enables multi-media devices to connect onto 802.11 b/g/n WLAN network and attain data communication speeds up to 300 megabits-per-second
(Mbps). It is also backward compatible to the existing installed base 802.11b/g network. 1.1 Product Features High speed for wireless LAN connection, RX up at 300 Mbps data rate. Backward compatible to the existing IEEE 802.11b/g/n WLAN infrastructure. 2 28*5*5mm MIFAs Support USB v2.0 1.2 Applications Home networking for device sharing. Wireless multimedia. WN7522C 2 4 Product Specification Chapter 2 Hardware 2.1 General Overview USB 2.0 Interface and 802.11 b/g/n chipset-on-board design. 2.2 Hardware Architecture Broadcom 43231 single chip USB2.0 2.3 Main Chipset Information BCM43231: MIMO MAC + Baseband processor and RF with integrated 2.4GHz PA 2.4 PCB dimension:
42mm*29mm WN7522C 2 5 Product Specification Chapter 3 Software 3.1 Operating System Supported Windows 2000, XP, Vista Linux Driver 3.2 Wireless Mode Supported AP (Infrastructure) Client mode 3.3 Security AP (Infrastructure) mode supports Static WEP that support both 64 and 128 bit keys. WPA/WPA2(TKIP/AES) with PSK Ad-hoc mode supports None (plaintext) Static WEP that supports both 64 and 128 bit keys. WN7522C 2 6 Product Specification Chapter 4 Specifications Frequency Band:
Draft 802.11n Radio: 2.4 GHz 802.11g Radio: 2.4 GHz 802.11b Radio: 2.4 GHz USA FCC Canada IC Europe ETSI Japan STD-T66/STD-33 2412~2462MHz (Ch1~Ch11) 2412~2462MHz (Ch1~Ch11) 2412~2472MHz (Ch1~Ch13) 2412~2484MHz (Ch1~Ch14) Operating Channels:
IEEE 802.11b/g/n compliant:
11 channels (US, Canada) 13 channels (ETSI) 14 channels (Japan) Transmit Power and Sensitivity:
TX Output Power:(Typical) 16.5 +/- 2 dBm 16.0 +/- 2 dBm@54Mbps 16.0 +/- 2 dBm 11b 11g 11n Rx Sensitivity:(Typical)
-82 dBm @11 Mbps
-68 dBm @54 Mbps
-64 dBm @64-QAM, 20MHz channel spacing
-61 dBm @64-QAM, 40MHz channel spacing Modulation DBPSK @1Mbps DQPSK@2Mbp CCK@5.5/11Mbps BPSK@6/9 Mbps QPSK@12/18Mbps 16-QAM@24Mbps 64-QAM@48/54Mpb and above WN7522C 2 7 Product Specification Current consumption(5V DC):
TX: 380mA Max, @MCS7, 40MHz RX: 350mA Max, @MCS15, 40MHz Power Saving: < 50mA Radio OFF mode: < 100mA Operating Temperature: 0 ~ 60 oC ambient Storage Temperature: -10 ~ 70 oC ambient Humidity: 5 ~ 90% and must be non-condensing Regulation and certification compliance available:
ETSI/CE ESD: EN61000-4-2, which specifies 4kV contact and 8kV air discharge. WN7522C 2 8 Product Specification References IEEE 802.11b Standard Specification IEEE 802.11g Standard Specification IEEE 802.11n draft Standard Specification The drawings, specifications and the data contain herein are the exclusive property of Arcadyan Technology Corp. issued in strict confidence and shall not, without the prior written permission of Arcadyan Technology Corp., be reproduced, copied or used, in parts or as a whole, for any purpose whatsoever, except the manufacture of articles for Arcadyan Technology Corp. Arcadyan makes no warranties with respect to the correctness, accuracy or wholeness of this specification. The information in this document is subject to change without notice. Arcadyan reserves the right to make revisions to this document and the product described herein without obligation to notify any person or entity of any such changes. WARNING This document is intended for internal use only. A Non-Disclosure Agreement (NDA) is required to release this document under any circumstances WN7522C 2 9 Chapter 5 Statement Product Specification Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the users authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation of the device. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. End users must follow the specific operating instructions WN7522C 2 10 Product Specification for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Industry Canada Statement This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:
1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device This class B digital apparatus complies with Canadian ICES-003 Cet appareil numrique de la classe B est conforme la norme NMB-003 du Canada IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. Note: This equipment contains module, FCC ID: BEJ9QK-WN7522C2 and IC: 2703H-WN7522C2, which qualifies as an UNLICENSED MODULAR TRANSMITTER per FCC Public Notice DA 00-1407 and RSS-Gen Section: 7.1.1. It has been tested and found to comply with Part 15.247 of the FCC Rules and RSS-210 issue 7:2007, Annex 8. Required labeling. Any device incorporating this module must include an external, visible, permanent marking or label which states:
Contains FCC ID: BEJ-9QKWN7522C2 Contains IC: 2703H-WN7522C2. Failure to comply with this requirement will void the users authority to operate any device that incorporates this module. WN7522C 2 11 Product Specification This equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio(SAR). CE Notified Body statement:
This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. Hereby, the device manufacturer declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Explosive device proximity warning Do not operate a portable transmitter (such as a wireless network device) near unshielded blasting caps or in an explosive environment unless the device has been modified to be qualified for such use. This device can be operated in the EU without restrictions indoor. This CE marking products European Community. telecommunications R&TTE Directive (1999/5/EC) issued by the Commission of the non-harmonized for EU valid is WN7522C 2 12