USERS Manual ENGLISH PRECAUTIONS
ENGLISH TABLE OF CONTENTS Introduction Format Compatibility.3 Recording Modes..3 System Configuration System Requirements...4 Software.4 Discs4 Installation Guide Installing CD Rewriter Drive5 Rear Panel.5 Set Master or Slave Jumper6 Connect to Primary/Secondary IDE Port...7 CD-RW Drive Front Panel...8 Troubleshooting Read Problems...9 Write Problems.11
ENGLISH INTRODUCTION
Format Compatibility
Recording Modes
SYSTEM CONFIGURATION System Requirements
ENGLISH
NOTE:
Software
Discs
ENGLISH INSTALLATION GUIDE Installing CD Rewriter Drive
7.
Rear Panel ENGLISH
Set Master or Slave Jumper
NOTE:Do not use two jumpers to set MA and SL simultaneously.
ENGLISH Connect to Primary/Secondary IDE Port
CD-RW
Note
, CD-RW DRIVE FRONT PANEL ENGLISH
0
Note: Turn off the power before doing this manual ejection.
ENGLISH TROUBLESHOOTING
Read Problems Symptom
Possible Causes
Solutions
) ENGLISH Symptom
Possible Causes
Solutions
ENGLISH Write Problems Symptom
Possible Causes
Solutions
ENGLISH Symptom Possible Causes
Solutions
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed or used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and the receiver.
(3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
(4) Consult the dealer or an experienced radio/TV technician for help. Note Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. APPENDIX A. SPECIFICATIONS ATAPI/E-IDE Interface CDSize 8cm/12cm Data Transfer Rate Read] CD-ROM^ 40Xmax. (6000KB/sec, CAV^
Write] CD-R^
24X/16X] 3600KB/sec, 2400KB/sec Mode 1 Data CLV^
Rewrite] CD-RW^
10X] 1500KB/sec, CLV^
Buffer Size 2MB Supported Media CD-DA, CD-ROM, CD-Extra, CD-ROM XA, Photo CD, CD-I, CD-R, CD-RW Front Panel Busy/Write LEDB Eject ButtonB Eject Emergency HoleB Volume ControlB Stereo Headphone Jack Disc Loading Tray Installation Angle Horizontal/Vertical Random Access Time 140 ms Error Rate Hard Error Soft Error 10-12 Bite or less 10-9 Bits or less Audio Specification Line Output Level 0.7V 0.2Vrms S/N Ratio Environment 60dB Temperature OperatingG 5J to 45J StorageG -20J 60J Humidity OperatingG 15-80%] Non-condensing^
Physical Dimensions W H D 145.8 41.3 190mm Weight 1kg Power Dimensions DC + 12V 5%, DC + 5V 5%
MTBF 70,000POH DUTY25% cycle in room Temp. Specification change without notice.