Aqara Product Manual Introduction USB gateway is a specially designed for ZigBee information into general JSON message Format (need to cooperate with the SDK) design of intelligent products.It can through the USB Mouth on the adaptation of set-top box or router, will be based on the ZigBee protocol Sensor, controller and other equipment message information via wi-fi passthrough to the cloud. Basic information Model: USBWG11LM Dimensions: 47.5*18.5*8 mm Wireless connection: ZigBee Working temperature: - 20- +60 Working humidity: 0%- 95% RHNo Condensation Device supported: Android 4.4/iOS 8.0 and above Download App Search for Aqara in App Store or scan the barcode to download Aqara App. Connect the USB gateway device, and then add it according to the instruction in Add Device. Add device 1The set-top box or a router connected to the network;
2Insert the USB gateway in the set-top box or a router on the USB interface;Open the 3Aqara APP, click on the "equipment list" page in the top right corner of the "+", To add equipment page, click select USB gateway, to equipment search;
4Choose the you want to add equipment from search results FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.