Maeden Model no. ANR-BP Controller User Manual 1. AA *2 PCS Open the battery cover and insert 2 PCSof AA battery 2. XLR , XLR Connect the XLR to theaudio systemand the other XLR to the helmet. 3. VR , Turn the VR knob to control the volume of the headphones. 4.+3V ,( LED ),( LED ) Press the power button to provide +3V voltage for the helmet to active the ANC function (active noise canceling) of the helmet. (Red LEDindicator light) Using theControllerwith a Bluetooth device 5. Slide the Bluetooth switch to turn Bluetooth on or off 6.( LED ),PFG-ANR
,
, When Bluetooth is turned on, first will enter into the pairing state (the blue LED flashes), turn on the Bluetooth of the device and search for the device name "PFG-ANR" to connect to the controller. When using for the first time, you need to manually pair and connect. After that, the Bluetooth of the pairing device and the controller will be automatically connected after being turned on. 7.,,, When the music plays, press the answer button to control pause or play. Press the play button when incoming call, you can answer or hang up the call. 8.+/-, Short press the +/- button on the side to adjust the volume of Bluetooth source. 9.+/-, Long presses the +/- button on the side to switch the music of Bluetooth source. 10., 5 ,, When using the Bluetooth, if you hear a beep every 5 seconds, it means the battery is low, please replace the battery. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution:To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation distance of at least 0.5 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. Model:ANR-BP FCC ID :2ATRIANR-BP THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS USBJECT TO THE FOLLOWING TWO CONDITIONS:
(1)THIS DEVICE MAY ASSEPT ANY INTERFERENCR ABD
(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECIVED, INCLUDING INTERFERENCR THAT MAY CAUSE UNDESIRED OPERATION. Made in China Maeden Innovation Co., Ltd.