INSTRUCTION MANUAL M-2500 15 15 1 2500 W 8 1 2 9 8 11 12 3 4 10 5 6 7 17 18 SCAN LEVEL LEVEL LEVEL MP3 LEVEL MIN MAX MIN MAX MIN MAX MIC1 MIC2 LINE INPUT MIN MAX TREBLE POWER
-12dB
+12dB BASS CLIP CH1 CH2 R CH3 L
-12dB
+12dB 14 15 16 13 19 20 LINE OUTPUT SPEAKER OUT 8 21 LED OFF ON 22 115V 230V ON OFF 23 24 POWER AC 115/230V 60/50Hz 1.LCD screen 2.MODE:USB/SD/BT/FM convertor
:Play / Pause SCAN:Long press to auto search under FM radio
:Repeat one / Repeat all / Random
:PRE/NEXT under FM mode Long hold to search lower/
higher station manually
:Short press to tune to saved station
:Previous Song Long press for fast rewind
:Next Song Long press for fast forward 3.SD card input 4.USB input 5.MP3 level control 6.Treble control for high frequencies 7.Bass control for low frequencies 8.MIC1 input level control 9.MIC2 input level control 10.Line input level control 11.XLR microphone1 input 12.XLR microphone2 input 13.XLR line input 14.6.35 microphone1 channel line input 15.6.35 microphone2 channel line input 16.RCA phone(R+L) line input 17.Power LED indicator 18.Clip LED indicator 19.XLR line output 20.Speaker out 8 Ohm 21.LED Light Switch(ON/OFF) 22.115/230V Switch 23.Main power switch 24.Fused IEC mains inlet FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.