OKIN Refined Electric Technology Co., Ltd Operating Manual of Remote Control system Interface of the remote control 2. Electrical configuration diagram Page 1 of 3 Power Cord AC Pair&Power Cord DC Power Supply
(JLDP.10.023.000) Remote model
(RF2205) 1 2 3 4 5 6 7 R5.504.01.250 Power Cord AC JLDP.10.023.000 Power Supply R5.217.01.013 Pair&Power Cord DC Synchronization Cable CB.11.20.01 Control Box RF2205 Motor/(Head&Foot) Remote model 1 1 1 1 2 1 Control Box CB.11.20.01 SYNC. Head Foot Motor Page 2 of 3 OKIN Refined Electric Technology Co., Ltd 3. Button description A. BACK UP buttonPress and hold the button, the Head actuator will go up. Stop when released. B. BACK DN buttonPress and hold the button, the Head actuator will go down. Stop when released. C. FOOT UP buttonPress and hold the button, the Foot actuator will go up. Stop when released. D. FOOT DN buttonPress and hold the button, the Foot actuator will go down. Stop when released. E. FLAT button: Click the button, the Head and Foot actuator will start up simultaneously and keep running until arriving to their low limited switches,. Running can be stopped by clicking any button. The blue LEDs for backlight are on as long as any button is pressed. IF all buttons are released the LEDs will automatically turn off three seconds later. The blue LED for power is always on as long as the power on. FCC Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IC RSS warning This device complies with Industry Canada licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device. ISED RSS Warning:
This device complies with Innovation,Science and Economic Development Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'ISED applicables aux appareils radioexempts de licence. L'exploitation est autorise aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Page 3 of 3