MULTIPURPOSE CORDLESS CALLING SYSTEM Model : LM-R100US A. PRODUCT COMPONENT 1. FRONT SIDE ON/OFF SWITCH 2. REAR SIDE LABEL (FCC ID) 3. ANTENNAL(447.8625Mhz) 4. BATTERY(3.7V) 5. BUZZER 6. VIBRATOR 7. MAIN PCB 8. POWER PCB B. CALL ID SETTING 1. CONNECT TO CHARGER(LM-C030) AND TRANSMITTER(LM-T100) 2. TURN ON POWER SWITCH, CHARGER AND TRANSMITTER IS OPERATION MODE. 3. PUT PAGER(LM-R100US) IN CHARGER(LM-C030), AND CALL ID SETTING BY TRANSMITTER KEY(LM-T100) C. VIBRATION SETTING 1. CONNECT TO CHARGER(LM-C030) AND TRANSMITTER(LM-T100) 2. TURN ON POWER SWITCH, CHARGER AND TRANSMITTER IS OPERATION MODE. 3. PUT PAGER(LM-R100US) IN CHARGER(LM-C030), AND VIBRATION SETTING BY TRANSMITTER KEY(LM-T100) D. MELODY SETTING 1. CONNECT TO CHARGER(LM-C030) AND TRANSMITTER(LM-T100) 2. TURN ON POWER SWITCH, CHARGER AND TRANSMITTER IS OPERATION MODE. 3. PUT PAGER(LM-R100US) IN CHARGER(LM-C030), AND MELODY SETTING BY TRANSMITTER KEY(LM-T100) E. CHARGING 1. TURN ON POWER SWITCH OF CHARGER(LM-C030). 2. PUT PAGER(LM-R100US) IN CHARGER(LM-C030), AND THEN WILL BE CHARGED. 3. CHARGING TIME : 3 HOURS. F. OPERATION 1. TURN ON POWER SWITCH, THIS DEVICE IS OPERATION MODE 2. IF ANY MESSAGE IS RECEIVED, MELODY OR VIBTARTOR OF PAGER WILL BE ALARMED. G. FCC INFORMATION 1. FCC ID : V6OLMR100US 2. USER'S INFORMATION Cautions Modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC compliance Information When used the This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions:
1. 2. This device may not cause harmful interference, and This device must accept any interference received. Including interference that may cause undesired operation. Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio Frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. QUFIELD CO.,LTD. Head Office_Factory :
208 Mega Valley, 799 Gwanyang2-dong, Dongahn-gu, Anyang-si, Gye TEL : 1588-9957