INSTRUCTIONS FOR OPERATION RH380T LCD thermal remote control manual SETING THE OPERATING CONTROLS 1.This unit operates on AAA 1.5 volts battery*4 (not included).(We use AAA battery*4) To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use . 2. Store the controller away from excess heat or humidity . 3. This remote control unit is required with 16 code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system . If you find that your fan and light kit go on and off without using your control , simply change the combination code in your transmitter and receiver . 4.Operation buttons on the panel of transmitter . FAN key For fan speed control B AB 65432123 Cycle Operation ONOFF FAN/REV key Fan reverse control LIGHT DOWN key For down light brightness and ON/OFF control . LIGHT UPPER key For upper light brightness and ON/OFF control . LEARN key (SET) Setting for learn code 5.Start the fan and Turn off the fan:
Press the selected speed button to run the fan at the desired . Press the FAN button over 0.7 second for adjusting the ceiling fan speed. Press within 0.7 second for ON/OFF control. 6.Light control :
Turn the light on or off by only touching the LIGHT CONTROL button . Keep pressing the button in excess of 0.7 second it becomes a dimmer , the light varies cyclically in 0.8 second . 1/1 GENERAL INFORMATION :
This REMOTE controller is designed to separately control your ceiling fan speed and light brightness . The Light ON/OFF button will control the light brightness ON/OFF . INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER A. Setting the code on your new transmitter . 1. Remove battery cover . Press firmly below arrow and slide battery cover off . 2. Slide code switches to your choice of UP and DOWN position . Factory setting is all UP . Do not use this setting . Use ball point pen or small screwdriver . Slide firmly up or down . B. Setting the code on your Receiver unit . 1. turn on the power 2. To press the SET button within 1 minute and for over 3 seconds. 3. The learning will complete if the receiver light flash twice. The changes or modifications not expressly approved by the NOTICE :
party responsible for compliance could void users authority to operate the equipment . THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATIONS IS SUBJECT INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFEERENCE THAT MAY CAUSE UNDESRIED OPERATION. 2/2