INSTRUCTIONS FOR OPERATION UC7096T : SETING THE OPERATING CONTROLS 1.This unit operates on AAA 1.5 volts battery*4 (not included).(We use AAA battery*4) To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use . 2. Store the controller away from excess heat or humidity . 3. This remote control unit is required with 16 code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system . If you find that your fan and light kit go on and off without using your control , simply change the combination code in your transmitter and receiver . 4.Operation buttons on the panel of transmitter . FAN(D ) key For fan speed control FAN AUTO key Auto temp. set-up manual cycle set-up B Temp. of indoor is lower than set-up temp. B HIMEDLOWOFF Cycle Operation A B Temp. of indoor is lower than set-up temp. B Temp. of indoor is lower than set-up temp. OFF 0~2J 4K 2J B B Temp. of indoor is lower than set-up temp. 4J 8K key Have time or temp. up. key Have time or temp. down. TIMER key Set timer option of FAN OR LIGHT HOUR HOUR FAN/REV key Fan reverse control LIGHT(@ ) key For light brightness and ON/OFF control . LIGHT DELAY key Auto off after 3 mins. 5.Start the fan and Turn off the fan:
Press the selected speed button to run the fan at the desired . 6.Light control :
Turn the light on or off by only touching the LIGHT CONTROL button . Keep pressing the button in excess of 0.7 second it becomes a dimmer , the light varies cyclically in 0.8 second . LOW MED HI SPEED SPEED SPEED 1/1 GENERAL INFORMATION :
This REMOTE controller is designed to separately control your ceiling fan speed and light brightness . The Light ON/OFF button will control the light brightness ON/OFF . INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER A. Setting the code on your new transmitter . 1. Remove battery cover . Press firmly below arrow and slide battery cover off . 2. Slide code switches to your choice of UP and DOWN position . Factory setting is all UP . Do not use this setting . Use ball point pen or small screwdriver . Slide firmly up or down . B. Setting the code on your new Receiver unit . 1. Slide code switches to the same positions as set on your transmitter . They must be set to same positions to work . 2. Replace battery cover on transmitter . 3. Make sure the code switches are on the left positions . The changes or modifications not expressly approved by the NOTICE :
party responsible for compliance could void users authority to operate the equipment . THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATIONS IS SUBJECT INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFEERENCE THAT MAY CAUSE UNDESRIED OPERATION. 2/2