User manual of WSZWM110A00 1. Introduction WSZWM110A00 is a Z-wave module compliant with ITU-T G.9959 optimized for low-power applications. The ZigBee chipset is from Sigma Designs, part number SD3503. 2. Hardware Architecture:
2.1 Main Chipset Information Item ITU-T G.9959 Vendor Sigma Designs Part Number SD3503 2.2 Circuit Block Diagram The major internal and external block diagram of WSZWM110A00 is illustrated in Figure 1-1. Figure 1-1 WSZWM110A00 block diagram and System Interface Samsung Electronics page 1 of 4 Version 1.0 Z-wave SoC(SD3503)X-tal(32MHz)SAW FilterUART+3.3VdcNRESET900MHz ChipAntennaF-MEM(2Mbit)SPII/O_PortI/O_PADI/O_PAD919.70~923.10MHz 3. Operational Description WSZWM110A00 is the ITU-T G.9959 Z-wave Module that acts as a communication controller for users of a wireless device.
- Features
> Z-Wave ITU-T G.9959
> Z-Wave 9.6/40/100 kbit/s data rate
>128-bit AES security processor and hardware random number generator
- Time base of the RF frequency For Z-wave IF and RF frequency, a crystal(32MHz) is a clock reference.
- Z-wave Tranceiver The WSZWM110A00 is a fully integrated module with an on-board antenna that allows the establishment of a Z-Wave network with minimum risk. The SD3503 chip is used with an external NVM (Serial Flash MEM), 32MHz crystal, power supply decoupling, SAW filter, matching circuit, and a PCB pattern Antenna.
- Z-wave Receiver The module is converted into a digital signal through the available receive signal of 900MHz and low noise have a built-in amplifier to amplify the signal to the received signal to the low noise amplifiers to match the signal strength and the amplified signal is inside Chip ADC from the main processor the packet containing the information is interpreted. Version 1.0 Samsung Electronics page 2 of 4
- Product Details
> Data Modulation Z-Wave : FSK/GFSK for ITU-T G.9959
> Frequency :
Z-wave Version 1.0 Samsung Electronics page 3 of 4
- Product pwr Spec. Symbol Parameter VDD Power supply Min 3.0 Typ. 3.3 Max 3.6 Unit V
- Product Spec.
> Z-wave Parameter Min Typ. Max Unit RF Characteristics(NA) RF Frequency Range Output power TX Frequency Tolerance TX Harmonics RX sensitivity 2nd Harmonics 3rd Harmonics PER at -85dBm RX Spurious Emission 30.0MHz to 12.5GHz Instruction to OEM 919.70 1
-25.0
-
-
-
-
-
-
-
-
-
923.10 MHz 7 25.0 dBm KHz
-30 dBm 3
%
-54 dBm This device complies with Industry Canadas license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference and
(2) This device must accept any interference, including interference that may cause undesired operation of the device. This application and its antenna must not be co-located or operation in conjunction with any other antenna or transmitter. A minimum separation distance of 20cm must be maintained between the antenna and the person for this appliance to satisfy the RF exposure requirements. Host labeling requirement: Contains transmitter module FCC ID: A3LWSZWM110C00 IC ID: 649E-WSZWM110C00 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause undesired operation. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Version 1.0 Samsung Electronics page 4 of 4