FCC ID: EMOIW19B Compact Clock with Wireless Charging

iW19 - Instruction Sheet (New Qi module) - English Color: Black text on white paper (1C + 1C) Size: 102 W x 150 H mm Material: 85gsm wood free paper Mar. 8, 2021 POWERVALET PRO Alarm Clock with Fast Wireless Charger For questions, full instructions, warranty, and additional safety information, please scan the QR code or visit:

www.ihome.com/help/iW19 Model: iW19 OVERVIEW Wireless Charging Area ALARM SET

- Press to Preview

- Press Again within 5 seconds to Arm/Disarm Alarm

- Press & Hold to Set Alarm

(adjust with +/- and press alarm to conrm) SNOOZE/DIMMER

- Press Top Surface to Snooze Alarm

- Press & Hold to Adjust Snooze Duration

(adjust with +/- and press Snooze to conrm)

- Press Top Surface Twice to Dim Display PM Indicator QI Charge Status Indicator Low Backup Battery Indicator Alarm Indicator TIME SET/DIMMER

- Press & Hold to Set Clock

(adjust with +/- and press time to conrm)

- Press to Adjust Display Brightness

(cycle for 5 brightness levels, including OFF) Battery Backup Compartment

(for clock accuracy) press down whole unit to snooze and to dim display SET

- Press to increase/decrease time & settings

*Before use, remove battery pull tab from bottom panel. REAR CONTROLS Connect AC adapter to DC Jack, and plug into outlet. USB Charging

(5V/1A) usb charging DST DC 12V/2A

-1 +1 Auto DST Switch

(Daylight Savings) DC Jack for power supply

(12V/2A) WIRELESS CHARGING Supports:

Qi compatible phones (also works with plastic cases up to 3mm thick) AirPods with wireless charging case Place Qi compatible device face up on the charging rest. Charging status will be indicated on display:

Rapid blinking icon:

Device is not charging (reposition device) Slow blinking icon:

Device is charging Solid icon:

Device is fully charged Note: Icon may continue to blink slowly when iOS devices are fully charged. WARNING:

Do not ingest the battery, Chemical Burn Hazard. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. CAUTION - RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. IMPORTANT SAFETY INSTRUCTIONS Please heed all warnings, read and follow all instructions and keep these instructions handy for future reference. 1. Do not use this product near water. 2. Unplug unit and clean only with damp cloth. Stronger cleaning agents, such as Benzene, thinner or similar materials can damage the surface of the unit. 3. Do not block any ventilation openings. Install in accordance with the manufacturers instructions. 4. Heat This product should be situated away from heat sources such as radiators, heat registers, stoves or other appliances

(including ampliers) that produce heat. 5. Only use attachments/accessories specied by the manufacturer. 6. Unplug this product during lightning storms or when unused for long periods of time. 7. Damage Requiring Service This product should be serviced by qualied service personnel when:

- Plug has been damaged.

- Objects have fallen into or liquid has been spilled into the enclosure.

- The unit has been exposed to rain. The unit has been dropped or the enclosure damaged.

- The unit exhibits a marked change in performance or does not operate normally. 8. No naked ame sources, such as lighted candles, should be placed on this product. 9. Attention should be drawn to the environmental aspects of battery disposal. Many electronics retailers now recycle batteries and other electronic components at no charge. To nd a drop-off location near you, visit www.call2recycle.com 10. This product is suitable for use in tropical and/or moderate climates. WARNING:

- To reduce the risk of re or electric shock, do not expose this product to rain or moisture.

- Do not dispose of batteries in the household trash or re.

- The mains plug of power adaptor is used as the disconnect device, it shall remain readily operable. FCC Information This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Increase the separation between the equipment and receiver. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. ISED Information This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device. The device comply with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. Any Changes or modications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Cet quipement est conforme aux limites d'exposition aux radiations IC CNR-102 tablies pour un environnement non contrl. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :

(1) Lappareil ne doit pas produire de brouillage;

(2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. L'appareil est conforme aux exigences d'exposition RF ISED, les utilisateurs peuvent obtenir des informations canadiennes sur l'exposition aux RF et la conformit. Cet quipement doit tre install et utilis avec une distance minimale de 20 cm entre le radiateur et votre corps. Tout changement ou modication non expressment approuv par la partie responsable de la conformit peut annuler l'autorit de l'utilisateur utiliser l'quipement. CAN ICES-3 (B) / NMB-3(B), CAN RSS-216 / CNR-216 CAUTION: Remove phones metal protective case before charging. Do not place magnetic or metal objects on charger during charging. Qi compatible phones with metallic looking nishes will charge normally. iW19-030821-A 2021 SDI Technologies, Inc. All rights reserved Printed in China

WIRELESS CHARGING & SNOOZE | DIMMER POP LABEL 139.5 1

. 2 2 1 C - 63 M - 0 Y - 0 K - 0 apply adhesive in only these areas on under side of labels 5 5

. 1 DC 12V, 2A US version BLUE - Emboss 0.3mm PINK - Deboss 0.3mm GREEN - Screen Print: Black 60mm 60mm Metallic Hot Stamped iHome Logo

*Center iHome Hot Stamp with 60mm on either side hour adjust DC 12V, 2A

-1 0 +1 Intl version new version of iW19 (MCU UST2028) GAW Title: Compact Clock with Wireless Charging Version: 3 Model: iW19 Designer: Eric Holzer Date: 03.24.2021 CONFIDENTIAL and PROPRIETARY:

The information contained herein including, but not limited to the products, renderings, concepts and designs comprise intellectual property of SDI Technolo-

gies Inc. and shall be kept confidential and shall not be used or disclosed by the recipient without the written authority of SDI Technologies Inc. MODEL PLATE

(For new MCU UST2028) US Model No: iW19 Service No: iW19-A-B AC Adaptor:

DC 12V, 2A USB Output: DC 5V, 1A FCC ID: EMOIW19B IC ID: 986B-IW19B www.iHome.com | Made in China Patents: www.ihome.com/patents HVIN: iW19b WIRELESS CHARGER:

Supports Apple 7.5W and Samsung 9W Fast Charge Do not place metal phone case or metal objects in the wireless charing area. Designed and Engineered in the USA Mfd. & Srvcd. by SDI Technologies, Inc. Date Code Laser Etched Date Code BATTERY DOOR

SDI Technologies Inc. Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID:EMOIW19B Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, we hereby request confidential treatment of information accompanying this application as outlined below:

Exhibit Type Block Diagram Schematics Operational Description File Name Block SCH Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Pursuant to DA04-1705 June 15, 2004 of the Commissions public notice, We also requesting the commission to grant short-term confidentiality request on the following attachments until 180 days after the Grant Date of Equipment Authorizations. File Name User manual Exhibit Type Manual Sincerely, David Stetin 2021-04-13 Rev 11/20/07

SDI Technologies Inc. Declaration on model difference We the undersigned hereby confirm that these models are identical, and all models have the same RFmodule and antenna, PCB layout , schematics and component.Only different on model number and color of appearance. Production name Compact Clock with Wireless Charging Trademark FCC Model no. iHome EMOIW19B iW19, iW19G, iW19X (X could be single or multiple digits by any alphabets denote different cabinet color) Confirmed by:

David Stetin 2021-04-08

SDI Technologies Inc. Federal Communications Commission Authorization and Evaluation Division 1435 Oakland Mills Road Columbia, MD 21046 Date: 2021-04-08 SUBJECT: FCC Application for (FCC ID: EMOIW19B) To Whom It May Concern:

We, the undersigned, hereby authorize Sam Lv at EMTEK (DONGGUAN) CO., LTD. on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by EMTEK (DONGGUAN) CO., LTD. on our behalf shall have the same effect as acts of our own. This is to advise that we are in full compliance with the Anti- Drug Abuse Act. We, the applicant, are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Regards, Sincerely, David Stetin 2021-04-08