Users Manual PM FBT T5 SERIES Application and performance specification Electronic ballast for T5 14x3, T5 21x3, THD10%
. Description Active power factor correction. PF0.99 Low harmonic distortion Low lamp current crest factor. CF1.6 Warn (Rapid) start. Long Life De-active lamp protection Model Line Volts Lamp type Input watts 55W 80W Normal Line amps 0.46A 0.67A Power factor 0.99 0.99 Total Harmonic distortion
<10%
<10%
Crest factor
<1.6
<1.6 414mm UL listed Safety
(center to center) Non-consumer limits PMFBTT514x3 120V/60Hz T5 14W PMFBTT521x3 120V/60Hz T5 21W Performance Meets FCC Part 18 (Class A) For EMI Application:
Minimum starting temperature -18 Maximum ambient temperature 40 75 Maximum case temperature This light device has been tested and found to comply with the limits for Consumer RF Lighting Device, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. 1. Use only on 120 volt, 60 hertz. 2. Never disassemble or modify - any changes could void the user's authority to operate this device. 3. Not for use in totally enclosed fixtures. 4. Risk of electric shock - do not use where directly exposed to water. 5. This device is not intended for use with emergency exit fixtures or emergency exit lights. 6. This product may cause interference to radio equipment and should not be installed near maritime Physical parameters Mounting length Overall length Width Height 424mm 30mm 26mm safety communications equipment or other critical navigation or communication equipment operating between 0.45-30MHz. 7. To prevent burns, do not touch the bulb during operation or immediately after switching off. 8. Not for use with dimmers, electronic timer or photocell devices or occupancy sensor. 9. This device is intended to be professionally installed for Industrial or Commercial use. Warranty Universal lighting technologies warrants to the purchaser that each electronics ballast will be marched with the lamp (T5 14x3, T5 21x3) and free from defects in material or workmanship for a period of 5 years from date of manufacture when properly installed and under normal condition of use.