1.CAMERA SPECIFICATION Image Device TV System Effective Pixels Sensing Area Scanning System Sync. System Resolution Horizontal Sync Frequency Vertical Sync Frequency Video Output Gamma Consumption AGC S/N Ratio White Balance Electronic Shutter BLC Operation Frequency:
Line of Sight Range:
Receiving Sensitivity:
Video Codec:
RF Band Width:
Frame Rate:
Spread SPECTRUM:
Delay:
RF Bit Rate:
Storage Temperature Operating Temperature Minimum Illumination Power Supply Night vision distance Waterproof rating Image mode Heater Audio Viewing Angle 2.SYSTEM OPERATION 1/3 SHARP CCD PAL 512582pixels NTSC 512492 pixels 15.625 kHz 50 Hz 15.734 kHz 60 Hz 4.9mm3.7mm 2:1 Interlace Internal 420TV Lines 1.0Vp-p, 75Ohm Better than 48dB 2400-2483.5MHZ 0.45 Auto Auto Auto 120M
-78dBm MPEG4 5MHZ 200ms 12Mbps PAL: 25f/s NTSC: 30f/s FHSS/16QAM 1/60(NTSC)/1/50(PAL)1/100,000 Seconds 40 ~ 80, RH95%MAX. 20~70, RH95%MAX 0 Lux 0.1 Lux 0.5 Lux DC12V DC24V DC12V~DC24V 3~5m 8~10m 12~15m IP69K IP67 NONWATERPROOF Mirror Normal Mirror/Normal image switch Yes No Yes No 120 92 69 45 25 3.PRECAUTIONS FCC Statement:
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept an Note: Modifications to this product will void the user's authority to operate this equipment.