FCC ID: 2A4RS-HBT-1619 solar lights remote control

MOTION SENSOR SOLAR LIGHT Solar Panels Lithium iron phosphate battery 3 2V 4500mAh 3 2V 4500mAh 3 2V 9000mAt Maximum Voltage 3.65V 3.65V 3 65V Product Manual Minimum Voltage Working Current 2 65V 2.65V 2 65V 30-1800mA 30-1800mA 30-2600mA 1806 C1619 812 SV 32W SV 56W 5V32W for 5 hours for charging, when the light;

in slight Methods:

as follows mode 1 is directly the lamp is continuously modes of the lamp in sequence if the solar lamp has been in motion sensing state is on every time, the high light is on for 30 seconds. on; press and hold the switch turned on after the light is on;

mode, while the light flashes, Application 1. After the solar panel is exposed to direct sunlight then use the solar lamp;

2. Please cover the solar panel when turning button for 2 to 5 seconds, 3. Press each button to switch to a lighting and the shutdown is on after running 4 modes;

4. There are 4 lighting Mode 1: Slight Light Plus High Light. In the standby state, motion sensing When fully charged, the high light can last for 1.5 to 2 hours; If every time, the lamp is turned on for 30 seconds, be sensed 180 to 250 times; If the solar lamp is always in the standby state, the standby time is 60 hours. Mode 2: Sensing Plus High Light. In the standby state, every time, the high light is on for 30 seconds. solar lamp has been in motion sensing to 2 hours; If the motion sensing on for 30 seconds, solar lamp is always in the standby state, Mode 3: Frequent When fully charged, Mode 4: Frequent When fully charged, Mode 5. Shutdown Low Light (25% brightness). the battery High Light (100% brightness). the battery and the sensor can be sensed 180 to 250 times; If the the standby time is 200 hours state 1s on When fully charged, if the the high light can last for 1.5 the lamp is off; when the motion sensing state is on every time, the lamp is turned the motion sensing life is 8 to 10 hours. life is 1.5 to 2 hours and the sensor can state, state, state is on Maximum Power 6.8W 6.8W 95W LED Quantities 48pcs 48pcs 80pcs Maximum Lumen Value 900lm 900 Im 1350lm LED Specifications SMD 2835 29-301m 4000 / 6000k Time Charging sun exposure time is greater than 6 hours Detection Angle 120 degrees Detection Distance 5-10 meters Waterproof Grade IP65 steps Installation Please charge the product for 5 hours before use. 1. Press the button for 5 seconds to start the circuit, and then select the desired lighting mode. 2. Nail two screws on the wall and hang the product directly. Please charge the product for 5 hours before use to solar panels has close remarks influence with the local weather condons,installation The time of sun exposure Additional 1. Please attention:

relationship which will directly 2. The service Therefore, should be disposed appropriately put it into the fire to escape from the danger of explosion. 3. The lampshade broken when littered is made of plastic or dropped. the charging iron phosphate there is no need to replace because of the internal raw materials, life of lithium it will be therefore, the battery effect. battery in use. The product Never battery. is more than five years. site and direction, solar light's remote control MADE IN CHINA r@ (E [f] [!]'\rff 5

FCC Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has evaluated to meet general RF exposure requirement. The device can be used be in portable exposure without restriction.

Shenzhen herboter Industry Co., Ltd. C5266091_X10_Ed.2 Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Subject: Request for Confidentiality FCC ID: 2A4RS-HBT-1619 To Whom It May Concern, Date: 2022-02-25 Pursuant to the provisions of Sections 0.457 and 0.459 of Commission's rules

(47CFR0.457, 0.459), we are requesting the Commission to withhold the following attachment(s) as confidential document from public disclosure. Exhibits ID Label/Location Attestation Statement External Photos Block Diagram Schematics Test Report Test Setup Photos Users Manual Internal Photos Parts List / Tune Up RF Exposure Info Operational Description Cover Letter(s) SDR Software / Security Info Long-Term Confidentiality No No No Short-Term Confidentiality NOTE 2 No No No No NOTE 1 NOTE 1 No No No No No No NOTE 1: Long-Term Confidentiality may be permitted under special conditions (See II. LONG-TERM CONFIDENTIALITY, Section 3 of KDB 726920, use last in force) NOTE 2: Short-Term Confidentiality can be requested for a maximum of 180 days from the date of the grant. Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. In case of short-term Confidentiality, the applicant requests the exhibits selected above are withheld from public view for a period of ___180___ days from the date of the Grant of Equipment Authorization and prior to marketing. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. 1/1 C5266091_X10_Ed.2 Sincerely, Signature:

Name: Xizhi Liu Title: executive 1/1

C5266091_X8_Ed.1 Letter of Authorization Shenzhen herboter Industry Co., Ltd. Company: Shenzhen herboter Industry Co., Ltd. Address:

5 / F, building C, No. 2, second industrial zone, Mabu new village, Baoyuan community, Langxin community, Shiyan street, Bao'an District, Shenzhen Product Name:

solar light's remote control Model Number:

1612, HBT-1616, HBT-1920, HY-SW108-NEW HBT-1619, HBT-1911, HBT-1606, HBT-1609, HBT-

FCC Identifier:

2A4RS-HBT-1619 We authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, to act on our behalf on all matters concerning the above named equipment. Any individual within LGAI Technological Center S.A. is authorized to act on our behalf and take action on the application. We declare that authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, information related to the approval project to the Federal Communication Commission and to discuss any issues concerning the approval application. Any and all acts carried out by LGAI Technological Center S.A. on our behalf shall have the same effect as acts of our own. is allowed to forward all Name:

Xizhi Liu Date: 2022-02-25 Title:

executive Signature of applicant:

1/1

Shenzhen herboter Industry Co., Ltd. Model Different Model namesolar light's remote control Model number: HBT-1619, HBT-1911, HBT-1606, HBT-1609, HBT-1612, HBT-1616, HBT-1920, HY-SW108-NEW All models the function, software and electric circuit are the same, except the color and model number. Name: Xizhi Liu Title: executive Date: 2022.2.25 Signature of applicant: