User Manual Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification
(installation procedure). The following information must be indicated on the host device of this module;
[for FCC]
Contains FCC ID: N6C-SXULPAN
[for IC]
Contains IC: 4908A-SXULPAN
[for FCC and IC]
This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device. Le prsent appareil est conforme la partie 15 des rgles de la FCC et CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.
*If it is difficult to describe this statement on the host product due to the size, please describe in the User's manual. The following statements must be described on the user manual of the host device of this module;
[for FCC]
FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
[for IC]
5150-5250 MHz and 5250-5350 MHz bands are restricted to indoor operations only. La bandes 5150-5250 MHz et 5250-5350 MHz ont restreinte une utilisation lintrieur seulement. High-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. Les radars de haute puissance sont dsigns utilisateurs principaux (c.--d., qu'ils ont la priorit) pour les bandes 5250-5350 MHz et 5650-5850 MHz, et ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
[for FCC and IC]
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20cm or more away from persons body. Cet quipement est conforme aux limites dexposition aux rayonnements nonces pour un environnement non contrl et respecte les rgles les radiolectriques (RF) de la FCC lignes directrices d'exposition et dexposition aux frquences radiolectriques (RF) CNR-102 de lIC. Cet quipement doit tre install et utilis en gardant une distance de 20 cm ou plus entre le radiateur et le corps humain. Data transmission is always initiated by software, which is the passed down through the MAC, through the digital and analog baseband, and finally to the RF chip. Several special packets are initiated by the MAC. These are the only ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on only while one of the aforementioned packets is being transmitted. In other words, this device automatically discontinue transmission in case of either absence of information to transmit or operational failure. La transmission des donnes est toujours initie par le logiciel, puis les donnes sont transmises par l'intermdiaire du MAC, par la bande de base numrique et analogique et, enfin, la puce RF. Plusieurs paquets spciaux sont initis par le MAC. Ce sont les seuls moyens pour qu'une partie de la bande de base numrique active l'metteur RF, puis dsactive celui-ci la fin du paquet. En consquence, l'metteur reste uniquement activ lors de la transmission d'un des paquets susmentionns. En d'autres termes, ce dispositif interrompt automatiquement toute transmission en cas d'absence d'information transmettre ou de dfaillance.