FCC ID: AK8IRF303J Wireless LAN Card

Installation Description IRF303J shall be installed in Location Free TV, model: LF-X5. When IRF303J is installed in a product, we shall consider the following points;

1. Since IRF303J owns its FCC ID Number/IC Number, we shall affix an exterior label on the outside of the product if the FCC ID/IC Number is not visible. The exterior label shall use wording such as either "Contains Transmitter Module FCC ID:AK8IRF303J/IC Number:409B-

IRF303J" or "Contains FCC ID:AK8IRF303J/IC Number:409B-IRF303J". 2. IRF303J complies with requirements of sub-sections 15.203, 15.205, 15.207 and 15.247 in FCC Rules Part 15. We shall install IRF303J in accordance with their requirements. IRF303J complies with requirements of the sub-section 2.1093. When installers install IRF303J into a product, they shall ensure that the public is not exposed to radio frequency energy levels in excess of the Commissions guidelines in accordance with the sub-section 15.247(b)(5) in FCC Rules Part 15. 3. Special Accessory (Shielded tape) must be patched for RF inference. Please refer to the following picture. 4. IRF303J is to be installed only by the professionals as shown in below figure. Shielded tape Shielded tape Note: Antenna cable length:

Antenna 1: 5cm Antenna 2: 19cm Antenna 2

(HFT18) Antenna 1

(HFT18) IRF303J 5. RF exposure requirements:

For portable equipment:

The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure to low level RF that does not produce heating effects causes no known adverse health effects. Many studies of low level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. IRF303J has been tested and found to comply with the Federal Communications Commission (FCC) guidelines on radio frequency energy (RF) exposures. The maximum SAR levels tested for IRF303J has been show to be 0.533 W/kg at Body. For mobile equipment:

This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment should be installed and operated with at least 20cm and more between the radiator and persons body (excluding extremities: hands, wrists, feet and legs).

2.4GHz Band Wireless LAN Transceiver Unit PRELIMINALY IRF303J General Description IRF303J, Wireless LAN module, is compliant with 802.11b/g standard. IRF303J is designed for AV transmission, and its high performance enable 54Mbps high-bit data rate communication. Feature

- Support QoS

- Hardware-Based MAC Access Protocol

- Low packet error rate Specifications

- Wireless Data Rate

- Host Interface

- Standard

- Radio Signal Type

- Frequency Band

- Channel Support

- Data Modulation Techniques

: Mini PCI Standard 1.0

: IEEE802.11b/g compliant

: Direct Sequence Spread Spectrum (DSSS) Orthogonal Frequency Division Multiplexing (OFDM)

: 802.11b=1/2/5.5/11Mbps 802.11g=6/9/12/18/24/36/48/54Mbps

: 2400-2483.5MHz

: ch1-ch11

: BPSK (1Mbps), QPSK (2Mbps), CCK (5.5/11Mbps) OFDM (6/9/12/18/24/36/48/54Mbps)

: 660ft (Outdoor, Line of sight) 100ft (Indoor)

: Ad-Hoc (Peer-to-Peer) Infrastructure

: WEP (Key Length 40/128/256bit) / AES / WPA (PSK)

- Security

: 3.3V (+/- 5%)

- Power Voltage

: 90.0 x 32.0 x 4.6mm

- Dimensions

- Weight

: Approx.12g

- Operating Temperature Range : -0C to +50C

- Media Access Protocol

- Operating Range Sony reserves the right to change products and specifications without prior notice. This information does not convey any license by any implication or otherwise under any patents or other right. Application circuits shown, if any, are typical examples illustrating the operation of the devices. Sony cannot assume responsibility for any problems arising out of the use of these circuits.

-1-

IRF303J NOTIFICATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the use is encouraged to try to correct the interference by one or more of the following measures:

Reoriented or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that t which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC WARNIG Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. For customers in the United States This product contains mercury. Disposal of this product may be regulated if sold in the United States. For disposal or recycling information, please contact your local authorities or the Electronics Industries Alliance (http://eiae.org). This device complies with Part 15 of the FCC Rules. Operation is subjected to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation

*This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Radiation Exposure Statement:

For portable equipment:

The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure to low level RF that does not produce heating effects causes no known adverse health effects. Many studies of low level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. IRF303J has been tested and found to comply with the Federal Communications Commission (FCC) guidelines on radio frequency energy

(RF) exposures. The maximum SAR levels tested for IRF303J has been show to be 0.533 W/kg at Body. For mobile equipment:

This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment should be installed and operated with at least 20cm and more between the radiator and persons body (excluding extremities: hands, wrists, feet and legs).

-2-

IRF303J Electrical Characteristics Vdd=3.3V, Ta=25C Parameter Output power Supply current Center Frequency Tolerance Modulation Accuracy(64QAM) Sensitivity 54Mbps Tx Rx 54Mbps 54Mbps Symbol Pout2 Iddtx2 Iddrx ftol EVM2 Rx_Sens2 Min

-10

Typ 17 730 390 0 4.3

-71 Max

400

+10

Units dBm mA mA ppm

dBm

-3-

Antenna

- Model Name

- Type

- Gain (Peak)

- Connector Type

: HFT18

: Film Antenna

: 2.4GHz_Band : +1.9dBi(Typ)

: U.FL IRF303J Unit:mm

-4-

Dimension 3.6 0.6 5.5 8

. 6 1 1

. 4 IRF303J 0

. 0 9 1.0 32.0

-5-