FCC ID: AK8RCS660S Contactless IC Card Reader/Writer

o o o o o o o o o 0 C 40 C 50 C 20% RH to 90% RH 50% RH or less

-10 C 0 C 40 C 60 C 20% RH to 90% RH 50% RH or less

- 20 C 0 C 70 C 60% RH or less o 5 1 8

. 1 6

. o o

Model: RC-SE6O/S 5-045-291-01 3.3. == FRW-C0009 [ |

emai MIC/KS #3 AC-22045 & | |

FCC ID:AKSRCS660S | |

IG:4098-RCS660S | |

Made in Japan / Fabriqu au Japon Sony Corporation 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan The following figures in this section show the module's external dimensions:

Connector 1pin 0.60.1 4540.2 40 23403

(Not include Serial label) Spacer Cut position 6 points or less Metal plate Serial label Thickness 0.17(max) Ss gs

|a pov y Magnetic sheet

(behind metal plate)

-2NTH (board only) Antenna center position

(No marking on the board) 87 12.5 ALL Board

(include antenna pattern) Tolerance: +0.3

(Unit: mm) 2.2. 1.8

#0002 o ~1 al ay VR RR RK RA fron I V Gece enas-291-01 eoeeeee =

Aaj Sy = | 2 S27] nell FCC ID:AKBRCS660S V a IC:409B-RCS660S -

\ Made In Japan / Fabriqu au Japon

\ Sony Corporation 4-7-1 Konan Minato-ku Tokyo, 108-0075 Japan 35

Sony Corporation 5-1-1, Minato Mirai, Nishi-ku, Yokohama-shi, Kanagawa,220-8750 Japan Letter of Authorization Date: June 9, 2022 UL Verification Services Inc. 47173 Benicia Street, Fremont, CA 94538 Applicant: Sony Group Corporation FCC ID: AK8RCS660S To whom it may concern:

We, the undersigned, hereby authorize Akiko Nishimura of Consumer, Medical & Information Technologies Division, UL Japan, Inc. to act on our behalf in all manners relating to application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by UL Japan, Inc. on our behalf shall have the same effect as acts of our own. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. The application for the subject equipment has not been submitted to another TCB for certification. Sincerely Yours, Atsushi Mukoyama Senior Manager Section 3, Department 4 Quality Assurance & Service Operation Division Sony Corporation

Sony Corporation 5-1-1, Minato Mirai, Nishi-ku, Yokohama-shi, Kanagawa,220-8750 Japan Request for Limited Modular Transmitter Approval FCC ID : AK8RCS660S Applicant : Sony Group Corporation This transmitter, model: RC-S660/S is designed by us. It complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section 15.212 as indicated below:

Modular Approval Checklist:

June 9, 2022 Modular approval requirement

(1) Have its own RF shielding.

(2) Have buffered modulation/data inputs.

(3) Have its own power supply regulation. Yes No A part of the voltage lines going to the transmitter of the radio chip is not regulated, thus the regulated power of DC3.3V shall be supplied from a host device. the antenna and transmission system

(4) Comply with requirements of 15.203, 15.204(b) and 15.204(c).

(5) Tested in a stand-alone configuration. Unless the transmitter module will be battery powered, it must comply with the AC line conducted requirements found in FCC 15.207. AC or DC power lines and data input/output lines connected to the module must not contain ferrites, unless they will be marketed with the module. The length of these lines shall be the length typical of actual use or, if that length is unknown, at least 10 centimeters to insure that there is no coupling between the case of the module and supporting equipment. Any accessories, peripherals, or support equipment connected to the module during testing shall be unmodified and commercially available.

(6) Equipped with either a permanently affixed label or must be capable of electronically displaying its FCC ID. If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.

(7) Comply with any specific rules or operating requirements that ordinarily apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements.

(8) Comply with any applicable RF exposure requirements in its final configuration: The modular transmitter complies with FCC radiation exposure requirement. Atsushi Mukoyama Senior Manager Section 3, Department 4 Quality Assurance & Service Operation Division Sony Corporation

Sony Corporation 5-1-1, Minato Mirai, Nishi-ku, Yokohama-shi, Kanagawa,220-8750 Japan Request for Confidentiality Date: June 9, 2022 UL Verification Services Inc. 47173 Benicia Street, Fremont, CA 94538 Applicant : Sony Group Corporation FCC ID : AK8RCS660S To whom it may concern:

Please be advised that the following information is to be held confidential on behalf of us, referring to the FCC rules 0.457 and 0.459:

Block Diagram Theory of Operation Schematics The application contains technical information which we deem to be trade secrets and proprietary. If made public, the information might be used to the disadvantage of the applicant in the market place. Thank you for your attention to this matter. Sincerely, Atsushi Mukoyama Senior Manager Section 3, Department 4 Quality Assurance & Service Operation Division Sony Corporation

Sony Corporation 5-1-1, Minato Mirai, Nishi-ku, Yokohama-shi, Kanagawa,220-8750 Japan Request for Short-Term Confidentiality Date: June 9, 2022 UL Verification Services Inc. 47173 Benicia Street, Fremont, CA 94538 FCC ID : AK8RCS660S Applicant : Sony Group Corporation To whom it may concern:

Please be advised that the following information is to be held in confidence for 180 days from the date of the Grant of Equipment Authorization based on the FCC rules 0.457 and 0.459:

External Photos Internal Photos Test Setup Photos User Manual The application contains technical information, which we deem to be trade secrets and proprietary. If made public, the information might be used to the disadvantage of the applicant in the market place. Thank you for your attention to this matter. Sincerely, ____________________________________ Atsushi Mukoyama Senior Manager Section 3, Department 4 Quality Assurance & Service Operation Division Sony Corporation