X WIRELESS User GUIDE Performance Bluetooth Over-Ear Headphones for Sports Compliance with FCC rules (U.S.A., only) This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance could avoid the users authority to operate the equipment. Note This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. 02 03 04 WHATS IN THE BOX 01 01 X-TRA 02 USB Charging Cable 03 Audio Cable 04 Carrying Case E N G L I S H PAIRING 1. In the OFF position. Turn ONpairing mode by pressing and holding the "ON/OFF" button on the remote for 5 seconds until the Blue/Red LED light starts to flash on the headphones. 2. On your phone/music devices, turn Bluetooth on. It should start searching for devices. 3. Find SOUL X-TRA and select.
(You may need to enter passcode 0000 if prompted) 4. Voice prompt or beeping sound will indicate that the X-TRA is connected. 5. If pairing fails, turn off the headphones by pressing on the
"ON/OFF" button for 5 seconds then repeat the process.
(You may also see your phone/music devices instructions for more information) MIC Blue / Red LED Indicator MULTIPOINT
(PAIRING WITH MORE THAN ONE DEVICE) 1. With SOUL multipoint technology, you can pair and connect X-TRA with up to two Bluetooth devices to your headphones. 2. The headset must be in standby mode (Not connected with any device or phone) 3. To turn on, user can press the volume "+" and "ON/OFF" buttons together. User will hear a tone which indicates the activation of this feature. 4. To turn off, user can press the volume "-" and "ON/OFF" buttons together. User will hear a tone which indicates the deactivation of this feature. TIP:
* Once Multipoint is on, please be sure to repeat PAIRING instructions for both phones/devices.
**Please make sure the multipoint function is off when not connected to 2 phones/devices. CONTROLS AUTO PAIRING MODE 1. Paired devices will remember each other unless pairing information is deleted. 2. After initial pairing, simply press the ON/OFF button for 3 seconds and the headphones will be paired with the phone/music device automatically. 3. To pair a new phone/music device, go into Bluetooth settings on your phone/music device, delete paired device and repeat the PAIRING instructions above. VOLUME DOWN BACKWARD TRACK
( 2sec ) VOLUME UP FORWAED TRACK
( > 2sec ) ON / OFF
( 3sec / 5sec ) PLAY/
PAUSE ANSWER CALL END CALL REFUSE CALL
( 2sec ) LAST CALL REDIAL
( double click ) SAFETY LED LIGHT 1. LED lights is defauled to be on when X-TRA is switched on. 2. Switch between the still / flashing made and OFF by pressing the - and + button together.
- and +Press together BATTERY LIFE AND CHARGING 1. Charging the battery prior to first use is recommended but not required. The X-TRA is pre-charged however initial charge will vary. 2. Battery life status will be indicated at the top right corner of your iPhone screen. 3. Low battery indicator on headphones are shown by a Red LED light. Charge the headphones when the flashing light turns Red. 4. When charging, Red LED light means the headphones are being charged. A Blue LED light means the headphones are fully charged. SPECIFICATIONS Bluetooth Version:
V4.0 Profile:
A2DP, AVRCP, HSP, and HFP. Range:
10 meters (33 feet) Charging time (Full charge):
Approx. 2-3hours Working time:
Up to 24 hours
(Varies by volume content and Safety LED Light is off) Standby time:
Up to 20 days LED STEP 1 STEP 2 Dimensions:
164L x 200H x 72W (mm) headphone size Weight:
198g WARNING DO NOT use alcohol, paint thinners, detergent, shampoo, or other solvents for cleaning purposes. DO NOT expose your headphones to extremely high or low temperatures. DO NOT disassemble your headphones in any way to avoid electric shock. DO NOT dispose your headphone into a fire. The battery could explode and cause injury or death. Only charge the battery in accordance to the instructions provided by the company. CAUTION Risk Of Explosion Increases If Battery Is Replaced By An Incorrect Type. Dispose Used Batteries According To The Instructions. INSTRUCTIONS Do Not Discard The Used Batteries Along With Household Waste. Disposal Of Battery Should Comply With Local Environmental Regulations. CONNECT AND GET LISTENING !
Join #SOULNATION Please follow us on our social media platforms for news and updates !
@Soulelectronics Soul Electronics Soul Electronics SI30BK-UG-ML-1 www.soulelectronics.com