ICB263B Bluetooth Speaker with Clock IMPORTANT SAFETY INSTRUCTIONS WARNINGS AND PRECAUTIONS USERS GUIDE V: 820-01 1. Read these Instructions. 2. Keep these Instructions. 3. Heed all Warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturers instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11. Only use attachments/accessories specified by the manufacturer. 12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. 13. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. FCC Warnings Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver Increase the separation between the equipment and receiver. is connected. Consult the dealer or an experienced radio/TV technician for help. Additional Warnings The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on apparatus. Lappareil ne doit pas tre expos aux coulements ou aux claboussures et aucun objet ne contenant de liquide, tel quun vase, ne doit tre plac sur lobjet. Main plug is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected form the mains socket outlet completely. La prise du secteur ne doit pas tre obstrue ou doit tre facilement accessible pendant son utilisation. Pour tre compltement dconnect de lalimentation dentre, la prise doit tre dbranche du secteur. Battery shall not be exposed to excessive heat such as sunshine, fire or the like. Les piles ne doivent pas tre exposes de forte chaleur, tel qu la lumire du soleil, au feu ou autres choses de semblable. Attention marquage est situ sur le paneau arrire ou infrieur de lunit. Caution marking is located at the rear or bottom of the apparatus. The marking information is located at the rear or bottom of apparatus. Le marquage est situ sur le paneau arrire ou infrieur de lunit. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. AVERTISSEMENT: Pour rduire le risque dincendie ou de choc lectrique, ne pas exposer cet appareil sous la pluie et lhumidit. CAUTION: Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. WARNING: Do not place this unit directly onto furniture surfaces with any type of soft, porous, or sensitive finish. As with any rubber compound made with oils, the feet could cause marks or staining where the feet reside. We recommend using a protective barrier such as a cloth or a piece of glass between the unit and the surface to reduce the risk of damage and/or staining. WARNING: Use of this unit near fluorescent lighting may cause interference regarding use of the remote. If the unit is displaying erratic behavior move away from any fluorescent lighting, as it may be the cause. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. PRCAUTION: Danger dexplosion si les piles sont remplaces de faon incorrect. Remplacer les piles seulement par le mme type de pile ou lquivalent. WARNING: There is a danger of explosion if you attempt to charge standard Alkaline batteries in the unit. Only use rechargeable NiMH batteries. WARNING: The remote controls button cell battery contains mercury. Do not put in the trash, instead recycle or dispose of as hazardous waste WARNING: Lithium batteries, like all rechargeable batteries are recyclable and should be recycled or disposed of in normal household waste. Contact your local government for disposal or recycling practices in your area. They should never be incinerated since they might explode. WARNING: Shock hazard - Do Not Open. AVIS: RISQUE DE CHOC LECTRIQUE - NE PAS OUVRIR Mains plug is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected form the mains socket outlet completely. La prise du secteur est utilis pour dconnecter le systme. La prise du secteur ne doit pas tre obstrue ou doit tre facilement accessible pendant son utilisation. Pour tre compltement dconnect de lalimentation dentre, la prise doit tre dbranche du secteur. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries. No mezcle bateras viejas y nuevas. No mezcle bateras alcalinas, estndar (carbono-zinc) o recargables (ni-cad, ni-mh, etc.). CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION RISQUE D' LECTROCUTION NE PAS OUVRIR WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance. This symbol indicates that this product incorporates double insulation between hazardous mains voltage and user accessible parts. Introduction and Setup Power Plug one end of the included USB cable and adapter into the Micro USB Port on the unit and an AC power outlet to power the dock. Memory In FM radio mode, press and hold to begin setting a station as a preset. Press to cycle through preset stations. Pair/Scan Press to begin pairing. In FM radio mode, press and hold to scan through all available radio stations and set them as presets. FM ANT. ALARM SET CLOCK SET LINE IN DC IN Battery Backup The battery backup is intended for short power outages only. The clock radios primary functions cannot run off of the battery backup alone. Requires 2, AA-size, batteries (not included) Source Press to switch between Bluetooth, FM Radio, and Line In modes. Power Press to turn the unit on and off. Light Press to turn the clock face light on or off. UM-3/R6/SIZE AA, 1.5V UM-3/R6/SIZE AA, 1.5V FM ANT. ALARM SET CLOCK SET LINE IN DC IN POWER SOURCE MEMORY PAIR / SCAN TUNE +
LIGHT VOLUME TUNE ALARM ON OFF Alarm Set Press in and hold to begin setting the alarm. Clock Set Press in and hold to begin setting the analogue clock. Tune +/-
Press to tune the radio in FM Radio Mode. Press and hold to search for the next available frequency. Volume Press to adjust the volume. Alarm On/Off Press to turn the alarm on or off. Line In Micro USB Charging Port Pair Radio Indicator Indicator Line In Indicator RADIO LINE IN For Warranty Information and the most up-to-date version of this Users Guide, go to www.iLiveElectronics.com Email Support: prodinfo@dpiinc.com, Email Parts: partsinfo@dpiinc.com Copyright 2013 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specifications are subject to change without notice.. The Bluetooth word mark and logos are owned by the Bluetooth SIG. Customer Service: 1-888-999-4215 ICB263B-820-01-IB.indd 1 5/30/2013 10:50:24 AM Clock Setting the Analogue Clock 1. Press and hold in the Clock Set knob. 2. While holding in the Clock Set knob, adjust to the desired time by turning the knob. Bluetooth Setup Radio Pairing a Bluetooth Device for the First Time 1. Power on the unit by pressing the Power button. 2. Press the Source button repeatedly to switch to Bluetooth mode. 3. Release the Clock Set knob when finish 3. Press the Pair button. setting the time. Alarm Setting the Alarm 1. Press and hold in the Alarm Set knob. 2. While holding in the Alarm Set knob, adjust to the desired time by turning the knob. 3. Release the Alarm Set knob when finished selecting the desired time. 4. Press the Alarm On/Off button to turn the alarm on and finish setting the alarm. 5. Once the set alarm time is reached, the alarm will sound. Cancelling the Alarm 1. Follow the instructions for Setting the Alarm. 2. Press the Alarm On/Off button until the alarm is in the off position. FM ANT. ALARM SET CLOCK SET LINE IN DC IN The Pairing Indicator will flash blue quickly. When pairing, remain within 3 feet of the unit. 4. Using the native controls on your Bluetooth device, select the ICB263 in your Bluetooth settings to pair. If your device requests a password, enter the default password 0 0 0 0 . Refer to the users manual for your specific device for instructions on pairing and connecting Bluetooth devices. 5. When successfully paired and connected, the Pairing Indicator will display a solid blue light. After initial pairing, the unit will stay paired unless unpaired manually by the user or erased due to a reset of the device. If your device should become unpaired or you find it is unable to connect, repeat the above steps or press the Pair button to start the pairing process pairing again. Line In Using the Line In Requires a 3.5mm audio cable (not included) 1. Connect a 3.5mm audio cable to the Line In on the unit and an audio output on an MP3 player or other audio source. 2. Press the Source button to switch to Line In mode. The Line In Indicator will light up. 3. Use the native controls on the connected MP3 player or other audio source to play and control audio played through the clock radio. Tuning the FM Radio 1. Press the Power/Sleep button to turn the clock radio on. 2. Press the Source button to switch to FM radio mode. The Radio Indicator will light up. 3. Press the Tun+ and Tun-buttons to adjust the radio to the desired frequency. 4. Press and hold the Tun+ and Tun- buttons to search for the next available frequency. 5. Press the Vol+/- buttons to adjust the volume. Saving a Station as a Preset 1. Follow the instructions for Tuning the FM Radio. 2. Tune to the desired station. 3. Press and hold the Memory button. 4. Press the Tun+/- button to adjust to the desired preset number. Up to 20 stations may be saved as presets. 5. Press the Memory button to save the current radio station as a preset. Tuning to a Preset Radio Station 1. Follow the instructions for Tuning the Radio and Saving a Station as a Preset. 2. Press the Memory button to cycle through preset radio stations. Radio Reception Adjust the position of the FM Antenna to improve FM radio reception. International Support To download this Users Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at: www.iLiveElectronics.com Para descargar este Manual del Usuario en ingls, espaol y francs, o para obtener respuestas a preguntas frecuentes, visite la seccin de apoyo en www.iLiveElectronics.com Pour tlcharger ce guide de lutilisateur en anglais, espagnol ou franais, ou pour obtenir des rponses des questions frquemment poses, consultez la rubrique dassistance sur www.iLiveElectronics.com For Warranty Information and the most up-to-date version of this Users Guide, go to www.iLiveElectronics.com Email Support: prodinfo@dpiinc.com, Email Parts: partsinfo@dpiinc.com Copyright 2013 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specifications are subject to change without notice.. The Bluetooth word mark and logos are owned by the Bluetooth SIG. Customer Service: 1-888-999-4215 ICB263B-820-01-IB.indd 2 5/30/2013 10:50:26 AM