IP & MAC Binding
- Binding Setting
- ARP List Binding Settings ARP Binding: ODisable Enable ID MAC Address IP Address Bind Modify 4 00-04-EB-00-07-BE 192.168.1.101 vy Modify Delete Add New...} (Enable Ail | (Delete all | (__ Find Previous |[ Next Page 1 IP & MAC Binding Settings Bind: y]
MAC Address: 00-04-EB-00-07-BE IP Address: 192.168.1.101
(sxe) Find IP & MAC Binding Entry MAC Address: 00-04-EB-00-07-BE IP Address:
ID MAC Address IP Address Bind Link 4 00-04-EB-00-07-BE 192.168.1101 | Topage ARP List ID MAC Address IP Address Status Configure 1 00-1 9-66-CB-45-66 192.168.1.93 Unbound Load Delete 2 00-04-EB-00-07-BE 192.168.1.104 Bound Load Delete
(Bind Al) (Load All] (_Refresh_|
Service Provider: Dyndns (www.dyndns.arg) ) Goto register... User Name:
Password:
Domain Name:
Enable DDNS:
Connection Status: DONS not launching!
Cian Save Service Provider: PeanutHull ( www. oray.net ) i) Go to register... User Name:
Password:
Enable DDNS:
Connection Status: DDNS not launching!
Service Type: _ Domain Name: =
DDNS Service Provider: Cormexe ( www.comexe.cn) | Goto register. Domain Name:
Domain Name:
Domain Name:
Domain Name:
Domain Name:
User Name:
Password:
Enable DDNS Connection Status: DDNS not launching!
Can Save
- Community Setting
- SNMP System Setting Num Commi 1 public 2 public 3 public 4 public Enable All | | Disable All Access Mode Read Only Read Only Read Only Read Only SNMP System Settings System Contact:
System Name:
System Location:
Save
- Time
- Firmware
- Factory Defaults
- Backup & Restore
- Ping Watch Dog
- Speed Test
- Reboot
- Password Time Settings Time Zone: (GMT+08:00) Beijing, Hong Kong, Perth, Singapore fe]
Date: 1 1 2006 = \MMvobry) Time: 9 5 4A (HHIMM/SS) Using Daylight Saving Time: o DST begin: 0 io 0 (MM/DDJHH) DST end: it} io io (MM/DDJHH) Preferable NTP Server: 0.0.0.0 0.0.0.0 Get GMT _| (Get GMT when connected to Internet) Save Firmware Upgrade File: (Browse... ]
Firmware Version: 4.4.0 Build 100120 Rel.62294n, Hardware Version: WA5210G v1 081640EF Upgrade actory Defaults Click the following button to reset all configuration settings to their default values. Restore Backup & Restore Backup: Backup File: (Browse...) (_Restore |
Ping Watch D lity Enable:
IP Address:
Interval:
Delay:
Fail Count:
seconds seconds i Simple Network Speed Test Utility Destination IP:
User:
Password:
Advanced options: v Direction: transmit _ Duration: 10 seconds Data amount: bytes Test Results Tx: NIA, Rx: NIA Click this button to reboot the device. Passwort Old User Name: admin Old Password:
New User Name:
New Password:
Confirm New Password:
System Log Index Log Content 1 0000:Systern: The device initialization succeeded. H-Ver = WA52106 v1 081640EF : S-Ver = 4.4.0 Build 100120 Rel.52294n L = 192.168.1.254 : M = 255.255.255.0 Refresh Current Statistics Status: Disabled Packets Statistics Interval(5~60): 410 Y Seconds
(| Auto-refresh
[Reset All }
Sorted Rules: | Sorted by IP Address Reset All] (Delete All Total Current Modify IP Address!
MAC Address Packets | Bytes | Packets | Bytes | ICMP Tx UDP Tx | SYN Tx The current list is empty. Previous | | Next Page|
Firmware Version:
Hardware Version:
4.4.1 Build 100222 Rel.56698n WWA5210G v1 081640EF Wired MAC Address:
IP Address:
Su net Mask:
Wireless Operating Mode:
SSID:
Channel:
Mode:
MAC Address:
00-04-EB-90-00-08 192.168.1.254 256.265.255.0 Access Point TP-LINK_900008 1 54Mbps (802.119) 00-04-EB-90-00-08 Traffic Statistics Bytes:
Packets:
Received it}
it}
Sent 1404 24 System Up Time:
0 day(s) 00:02:28 Operation Mode CAP Client Router: WISP Client Router OAP Router: Wireless Broadband Router
@apP: Access Point LAN IP Address: 192.168.1.254 Subnet Mask: 255.255.255.0 Gateway: 0.0.0.0 MAC Address: 00-04-E8-90-00-08 Wireless
- Basic Settings
-Wireless Mode
- Security Settings
- MAC Filtering
-Wrreless Statistics
- Distance Setting
- Antenna Alignment
- Throughput Monitor Wireless Settings SSID: TP-LINK_900008 Region: United States Ensure you select a correct country to conform local law, Incorrect settings may cause interference. Warning Channel: Automatic ca Mode: 54Mbps @02.119) , Save A Selecting the incorrect country may cause interference to other devices and violate the applicable law. Cr LAN Segment 1 LAN Segment 2 dy ~~ (=a AP2 AP List AP Count: 63 ID BSSID SSID Signal Channel Security Choose 1 00-21-27-48-23-78 TP-LINK_482378 28 dB 1 OFF Connect 2 00-1 D-OF-98-2B-08 TP-LINK 265 dB an ON Connect 3 00-08-01-00-00-80 AKING 18 dB an OFF Connect Refresh Wireless Security Disable Security WEP Type: Automatic WEP Key Format: Hexadecimal Key Selected WEP Key Key Type Key 1: Disabled |
Key 2: Disabled |
Key 3: Disabled he]
Key 4: Disabled |
WPA/WPA2 Version: Automatic he|
Encryption: Automatic Z|
RadiusServerP: 6, Radius Port, [1812 _|(1-85535, 0 stands for default port 1812) Radius Password:
Group Key Update Perio: 86400 _{in. second, minimum is 30, 0 means no update) WPA-PSK/WPA2-PSK Version: Automatic he |
Encryption: Automatic he PSK Passphrase:
(The Passphrase is between 8 and 63 characters long) Group Key Update Period: 86400 (in second, minimum is 30, 0 means no update, only be valid in AP mode.) Save Note: Some security mode can not be selected since it can not be supported by the current wireless mode. Wireless Statistics Current Connected Wireless Stations numbers: 1 Refresh ID MAC Address Current Status Received Packets Sent Packets 4 00-04-EB-90-00-08 AP-DOWIN 0 39428
{ Previous |[ Next |
Distance Setting Adjust option: Automatic Distance: (0-52.6km) Note: Specify the distance value in kilometers, accurate to the first decimal place. Ifthe distance is set too short or too long, it will result poor connection and throughput performance, itis best to set the value at 110% of the real distance. If the AP is being used in an indoor setting, please use the default setting. tenna Alignm Remote RSSI: 14dB Signal Percent: AT%
rssirance: [7 fa Throughput Monitor Rate: Kbps Max 19.4511Kbps 2.2402Kbps Current 14.2714Kbps BREET 1 2525Kbps Min 14.2714Kbps 1.7363Kbps Run Time: 92 s Average 14.7732Kbps 19375Kbps DHCP
- DHCP Settings
- DHCP Clients List idress Reservation P Settings DHCP Server: @ Disable Enable Start IP Address: 192.168.1.100 End IP Address: 192.168.1.199 Address Lease Time: 120 minutes (1~2880 minutes, the default value is 120) Default Gateway: 0.0.0.0 (optional) Default Domain: (optional) Primary DNS: 0.0.0.0 (optional) Secondary DNS: 0.0.0.0 (optional) Save DHCP Clients List ID Client Name MAC Address Assigned IP Lease Time 1 microsoft 00-19-66-CB-45-66 192.168.1.100 01:56:59 Address Reservation ID MAC Address Reserved IP Address Status Modify
{Enable All | | Disable All| | Delete All_|
(Previous ]( Next |
Add or Modify an Address Reservation Ei MAC Address: 00-04-EB-00-07-5F Reserved IP Address: 192.168.1.23 Status: Enabled v
Wireless Advanced Settings Enable WMM Enable AP Isolation Disable short preamble RTS Threshold: 2346 (1-2346) Fragmentation Threshold: 2346 (256-2346) Beacon Interval: 100 (20-1000ms) Power: Max v | Obey Regulatory Power Antenna Settings: Vertical (Mi LED1 LED2 LED3 LED4 Signal LED Thresholds: 4 18 25 (|/a3 | 0-9ad8) Save
- Community Setting
- SNMP System Setting Num Commi 1 public 2 public 3 public 4 public Enable All | | Disable All Access Mode Read Only Read Only Read Only Read Only SNMP System Settings System Contact:
System Name:
System Location:
Save ___ System Tools Firmware
- Factory Defaults
- Backup & Restore
- Ping Watch Dog
- Speed Test
- Reboot
- Password
- Syslog Firmware Upgrade File: (Browse... ]
Firmware Version: 4.4.0 Build 100120 Rel.62294n, Hardware Version: WA5210G v1 081640EF Upgrade actory Defaults Click the following button to reset all configuration settings to their default values. Restore Backup & Restore Backup: Backup File: (Browse...) (_Restore |
Ping Watch D lity Enable:
IP Address:
Interval:
Delay:
Fail Count:
seconds seconds i Simple Network Speed Test Utility Destination IP:
User:
Password:
Advanced options: v Direction: transmit _ Duration: 10 seconds Data amount: bytes Test Results Tx: NIA, Rx: NIA Click this button to reboot the device. Passwort Old User Name: admin Old Password:
New User Name:
New Password:
Confirm New Password:
System Log Index Log Content 1 0000:Systern: The device initialization succeeded. H-Ver = WA52106 v1 081640EF : S-Ver = 4.4.0 Build 100120 Rel.52294n L = 192.168.1.254 : M = 255.255.255.0 Refresh WAN Connection Type:
PPPoE Connectiot User Name:
Password:
PPPoE v| (_Detect_]
username ]
[sceccsse Wan Connection Mode:
Connect on Demand Max dle Time: [16 Connect Automatically
|minutes (0 means remain active at all times.) Time-based Connecting Period of Time:from Connect Manually Max dle Time: | {5 0 (HHMI) to : [69
|minutes (0 means remain active at all times.) Disconnected!
(HH:MM) MAC Clone WAN MAC Address: 00-08-01-00-00-05 Your PC's MAC Address: O0-19-66-80-64-2B Clone MAC Address
(save) jal Servers ID Service Ports IP Address Protocol Status Modify
(Enable All | {Disable All | [ Delete All |
Add or Modify a Virtual Server E:
Service Port: 1720 (OX oF XX) IP Address: 192.168.1.169 Protocol: ALL Status: {Enabled E]
Common Service Port: [Select One~ v4
(se) DMZ Current DMZ Status: Enable Disable DMZ Host IP Address: 192.168.1.169 Save mote Management Web Management Port: 68 Remote Management IP Address: 0.0.0.0 (Enter 255.255.255.256 for all) jal Servers ID Service Ports IP Address Protocol Status Modify
(Enable All | {Disable All | [ Delete All |
Add or Modify a Virtual Server En Service Port: 80 GOCKX oF XX), IP Address: 192.168.1.188 Protocol: ALL ig Status: Enabled Common Service Port: --Select One-- el
(save) LAN or High-Speed Internet Bridge Connections Create Shortcut Delete Local Area Connection Prope! 21 x]
General | Authentication | Advanced |
Connect using:
8 Realtek RTL8139 Family PCI Fast Ett This connection uses the following items:
#} QoS Packet Scheduler MF AEGIS Protocol (IEEE 802.1) v3.4.3.0 Internet TC 4 >
Install... | Unirstall Properties Description Transmission Control Protocol/Internet Protocol. The default wide area network protocol that provides communication across diverse interconnected networks. T~ Show icon in notification area when connected J Notify me when this connection has limited or no connectivity OK Cancel internet Protocol (TCP/IP) Properties il 2\ x]
General | Alterate Configuration |
You can get IP settings assigned automatically if your network supports this capability. Otherwise, you need to ask your network administrator for the appropriate IP settings. Obtain an IP address automatically
{Use the following IP address:
f Use the following DNS server addresses:
Prefered DNS server Advanced. Cancel Internet Protocol (TCP/IP) Properties General |
[ 2x!
You can get IP settings assigned automatically if your network supports this capability. Otherwise, you need to ask your network administrator for the appropriate IP settings. Obtain an IP address automatically
@ Use the following IP address:
IP address:
Subnet mask:
Default gateway:
192.168. 1 . 241 255. 255.255. 0 192.168. 1 1 Gbtain DNS yer addres:
Preferred DNS server:
Alte mate DNS server:
( Use the following DNS server addi y esses:
202. 96 . 134. 134 Advanced... Cancel