FCC ID: SWX-UAP6L UniFi Network UAP6 Lite

SPECIFICATIONS/Model:UAP6-Lite MECHANICAL Dimensions Weight Enclosure Characteristics Mounting Characteristics Weatherproofing ( IP XX ) Resistance ( IK XX ) HARDWARE Processor Specs Memory Information Management Interface Networking Interface Buttons LEDs Power Method Power Supply Supported Voltage Range Max. Power Consumption Max. TX Power 2.4 GHz 5 GHz 2.4 GHz 5 GHz 2.4 GHz 5 GHz MIMO Throughput Speeds Operating Temperature Operating Humidity Certifications SOFTWARE Wi-Fi Standards Wireless Security 160x32.65mm without mounting)300g

(with mounting)315g PC 110 + Die casting- ADC 12 880 MHz MIPS 1004KEc DDR3 SDRAM 2Gbit PC + SGCC NA NA Ethernet 1x RJ45 GbE reset White/Brue 802.3af 802.3af 44 to 57VDC 12 W 23 dBm 23 dBm 2x2 2x2 300 Mbps 1201 Mbps

-10C~60C 5 to 95% Noncondensing 802.11a/b/g/Wi-Fi 4/Wi-Fi 5/Wi-Fi 6 WEP, WPA-PSK, WPA-Enterprise (WPA/WPA2/WPA3) 8 per radio Not Supported 802.1Q Supported 300+

Per-User Rate Limiting BSSID Zero-Handoff VLAN Advanced QoS Guest traffic isolation Concurrent Clients Supported Data Rates

(Mbps) 802.11a 802.11b 802.11g 802.11ac (Wi-Fi 5) 802.11ax (Wi-Fi 6) 802.11n (Wi-Fi 4) 6.5 Mbps to 300 Mbps (MCS0 - MCS15, HT 20/40) 6, 9, 12, 18, 24, 36, 48, 54 Mbps 1, 2, 5.5, 11 Mbps 6, 9, 12, 18, 24, 36, 48, 54 Mbps 6.5 Mbps to 866.7 Mbps (MCS0 - MCS9 NSS1/2, VHT 7.3 Mbps to 1.2 Gbps (MCS0 - MCS11 NSS1/2, HE 20/40/80/160) 20/40/80/160) FCC Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. The following apply to Class A products This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. The following apply to Class B products

"This equipment has been tested and found to comply with the limits for a Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help."

by ISED Canada CAN ICES-3(A/B)/NMB-3(A/B) This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device. The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems. CAN ICES-3(A/B)/NMB-3(A/B) Le prsent appareil est conforme aux CNR dISDE Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :

1. lappareil ne doit pas produire de brouillage;

2. lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont rservs uniquement pour une utilisation lintrieur afin de rduire les risques de brouillage prjudiciable aux systmes de satellites mobiles utilisant les mmes canaux. RF Exposure Warning The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter. Les antennes utilises pour ce transmetteur doivent tre install en considrant une distance de sparation de toute personnes dau moins 20 cm et ne doivent pas tre localis ou utilis en conflit avec tout autre antenne ou transmetteur.

UNF: UAP6 Lite MAN-UAPE-Lite 1C: 6545A-UAPEL 802.30 POE CCID: SWX-UAPEL inn CEQ &

xt _Now er, HY 10017 USA 3000000000 427mm

685 Third Avenue, New York, New York 10017 USA Ubiquiti Inc. Date: April 20, 2020 Subject: Ad Hoc Mode Function Declaration FCC ID: SWX-UAP6L IC ID: 6545A-UAP6L To Whom it may concern, We, Ubiquiti Inc. declare that the device does not support any non-US channels and country code selection and Channel 12 and 13 in 2.4 GHz band in all the operational mode(s). Regards, Applicant Address Signature Name and Job Title. E-mail Tel.

: 685 Third Avenue, New York, New York 10017 USA

: Ubiquiti Inc.

: Mark Feil / Compliance Manager

: [email protected]

: 408-942-3084

Ubiquiti Inc. 685 Third Avenue, New York, New York 10017 USA Date: 2020/4/22 Federal Communications Commission 7435 Oakland Mills Rd Columbia MD 21046-1609 Subject: Product Certification Representative Authorization Letter FCC ID: SWX-UAP6L Product name: UniFi Network UAP6 Lite To whom it may concern:

We the undersigned, hereby authorize following person to act as our agent in the preparation of an application for equipment authorization of model UAP6-Lite to the FCC Rules and Regulations. Address

: No.3-1, Lane 6, Wen San 3rd St. Kwei Shan Dist., TaoYuan City 333, Taiwan (R.O.C.) International Certification Corp. Name

: Gary Chang Job Title

: Manager e-mail

: [email protected] Webs We further certifies that neither the applicant nor any party to this application, as defined in 47 CFR Ch. 1.2002(b), is subject to a denial to Federal benefits, that include FCC benefits, pursuant to section 5301 of the Anti-Drug Abuse Act of 1998, 21 U.S.C. 862. This appointment also includes the authority to complete FCC Form 731 on our behalf and sign the application as an authorized agent. Applicant Address Title. E-mail Tel.

: Ubiquiti Inc.

: 685 Third Avenue, New York, New York 10017 USA Signature

Name and Job _________________________________

: Mark Feil / Compliance Manager

: [email protected]

: 408-942-3084

Ubiquiti Inc. 685 Third Avenue, New York, New York 10017 USA Date: April 20, 2020 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Rd Columbia MD 21046-1609 Subject: Request for confidentiality FCC ID: SWX-UAP6L To whom it may concern:

Short-term confidentiality Internal Photographs External Photographs User's manual Test Set up photo Permanent confidentiality Block Diagram Schematics Operational Description competitors. Pursuant to DA 04-1705 of the Commissions pubic notice, in order to comply with the marketing regulations in 47CFR 2.803 and the importation rules in 47 CFR 2.1204, while ensuring that business sensitive information remains confidential until the actual marketing of newly authorized devices. We are requesting the commission to grant short-term confidentiality request on the following attachments until 180days. Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, the Applicant Hereby requests confidential treatment of information accompanying this Application As outlined below:

The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Should you require any further information, please contact the undersigned. Thank you for your consideration in this matter.

: 685 Third Avenue, New York, New York 10017 USA Applicant Address Signature Name and Job Title. E-mail Tel.

: Ubiquiti Inc.

: Mark Feil / Compliance Manager

: [email protected]

: 408-942-3084