Datasheet UFP-SFL UniFi Protect Smart Flood Light S ma r t ma na g e d floodlig ht w ith inte g r a te d motion de te ction a nd lig ht s e ns ing . H ous e d in a compa ct de s ig n for low pr ofile mounting , a nd e a s ily config ur e d w ith U niFi P r ote ct. Weatherproong IPX5 Mechanical Dimensions Weight Enclosure Materials Mount Materials Hardware Processor Memory Information Management Interface Networking Interface Max. Power Consumption Power Method Power Supply Button RF LEDs 135 x 65 x 50mm (5.31 x 2.56 x 1.97") Without Mount: 216 g (7.62 oz) With Flat Wall Mount: 236 g (8.32 oz) With Angle Mount: 273 g (9.63 oz) Plastic, Metal Flat Wall Mount: Plastic Angle Mount: Plastic The Qualcomm QCA9531 SoC 10/100 Mbps RJ45 Ethernet Port 64 MB DDR2 UniFi Protect 10.5W 802.3af PoE Factory Reset Bluetooth 4.0 R/B/W ESD/EMP Protection Air: 8kV, Contact: 8kV 802.3af PoE, 48VDC, 0.22A Max Operating Temperature
-10to 45 C (14 to 113 F) Operating Humidity Certications 20 to 80% Noncondensing FCC, IC, CE Specications are subject to change. Ubiquiti products are sold with a limited warranty described at: www.ui.com/support/warranty 2020 Ubiquiti Inc. All rights reserved.Ubiquiti, the Ubiquiti U logo, the Ubiquiti beam logo, UniFi, and UniFi Protect are trademarks or registered trademarks of Ubiquiti Networks, Inc. in the United States and in other countries. Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. All other trademarks are the property of their respective owners. FCC Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
"This equipment has been tested and found to comply with the limits for a Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help."
ISED Canada CAN ICES-3(B)/NMB-3(B) This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device. The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems. CAN ICES-3(B)/NMB-3(B) Le prsent appareil est conforme aux CNR dISDE Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :
1. lappareil ne doit pas produire de brouillage;
2. lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont rservs uniquement pour une utilisation lintrieur afin de rduire les risques de brouillage prjudiciable aux systmes de satellites mobiles utilisant les mmes canaux. RF Exposure Warning The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter. Les antennes utilises pour ce transmetteur doivent tre install en considrant une distance de sparation de toute personnes dau moins 20 cm et ne doivent pas tre localis ou utilis en conflit avec tout autre antenne ou transmetteur.