2 3 4 GAS INSTALLATION Receiver Connection & Binding 5 DRONE Mode Switch 6 7 8 9 The system is not connected The receiver not responding during operation 10 Your transmitter and receiver are too close You are around metal objects The model selected is not the model bound to The model is not the bound one Low battery voltage Loose or damaged wires or connectors between battery and receiver Take transmitter 1 to 3 meters away from receiver Try in an area with less metal around Check the selected model and ensure you Rebind your transmitter and receiver Charge your battery Check the wires and connection between the battery and receiver. Repair or replace wires and/or connectors FCC ID: 2ABYMVOLANTEX757 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, If not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. 2014