d TERMINAL PAYMENT CRADLE XC60 INSTALLATION GUIDE 1. PACKAGE CONTENT 2. DEVICE OVERVIEW
XC60 Device Overview (Figure 1):
Power adaptor REAR SIDE Figure 1 BACK AREA 1 2 3 4 COM1 COM2 USB Host LAN FRONT SIDE Figure 2 FRONT AREA 5 6 Charging Contact Status LED LEFT SIDE Figure 3 SIDE AREA 7 DC JACK XC60 Power spec:
Input: 12V DC, 2A Power Adapter spec:
Input: 100 ~240 ac Output: 12V DC, 2A min This symbol is intended to alert the user before starting using the POS. Caution: This product shall be only used with a certified power supply unit which was investigated according to the standard of IEC 60950-1, UL 60950-1 and CAN/CSA C22.2 No. 60950-1-07, and marked I.T.E. LPS, and with operating temperature: minimum 40C, output rated: 12V DC, minimum 2 A.
Operating Temperature: 0oC to 40oC 3. POWER ON/OFF THE DEVICE To power ON the device: Plug-in the DC JACK To power OFF the device: Un-Plug the DC JACK Figure 4 4. LED BEHAVIORS Insert Power adapter and device will power up, there is a LED status:
Location:
Top right corner (Figure 5) Figure 5
Blinking Red - System update process Solid Red - System errors and cant operation Solid Orange System power on Solid Green System power on and under connection Blinking Green System power on and in idle mode 5. CONNECT WITH XCL_AT-150/XCL_AT-100 Place xCL_AT-150/xCL_AT-100 on the XC60 for charging and as Figure 6. Figure 6 FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. XAC Automation Corporation 886-3-577-2738 www.xac.com.tw The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation. XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or errors made herein;
nor for incidental or consequential damages resulting from the furnishing, performance or use of his material.