FCC ID: SRQ-K5161Z Vodafone K5161z

 

Product Safety Information

Vodafone Broadband USB

Stick



Please read this

Following the w

others and dam

s safety informatio

warnings will help p

mage to your devic

on before you use t

prevent injury to y

ce.

the device.

yourself or

Pictograms and

s

d Graphic Symbols

Read t

the Safety Informa

ation before using

this

device

. Failure to comply

y with safety warni

ings can

result

in serious injury.

Do not

g

t use while driving

of 5m

mm

medic

al devices

medic

al facilities

For bo

ody-worn operatio

on maintain a sepa

aration

Keep a

away from pacem

makers and other p

personal

Switch

h off when instruc

cted in hospitals an

nd



Switch off when instructed in aircrafts and

airports

Switch off in explosive environments

Do not use while refueling or near gas or

flammable liquids

Do not dispose of this device or its battery in a fire.

Avoid contact with magnetic media

Avoid Extreme Temperatures

Avoid contact with liquid, keep dry

Do not try and disassemble

Do not rely on this device for emergency

communications

Only use approved accessories

This d

evice is not intend

ded for use by you

ung

childre

en. If you allow a

child to use it ensu

ure the

child i

small p

is strictly supervise

ed. This device con

ntains

parts which are a

choking hazard

Do not

t to use this devic

e whilst walking a

across a

road o

or cycling

RF Exposure

Your device contains a radio transmitter and a receiver.

When it is ON, it receives and transmits RF energy. When

your device is in use, thesystem handling your connection

controls the power level at which your device transmits.

Specific Absorption Rate (SAR)

Your wireless device is a radio transmitter and receiver. It is

designed not to exceed the limits for exposure to radio waves

recommended by international guidelines. These guidelines

were developed by the independent scientific organization

ICNIRP and include safety margins designed to assure the

protection of all persons, regardless of age and health.

The guidelines use a unit of measurement known as Specific

Absorption Rate, or SAR. The SAR limit for wireless devices

is 2 W/kg and the highest SAR value for this device when

tested at the body was 0.795 W/kg* with 5 mm distance.

SAR is measured utilizing the device’s highest transmitting

power and where supported with multiple simultaneous

transmitters. The actual SAR of this device while operating is

typically well below that indicated above. This is due to

automatic changes to the power level of the device to ensure

it only uses the minimum power required to communicate

with the network.

* The tests are carried out in accordance with EN 50566 and

EN 62209-2.

Body worn operation

To ensure compliance with RF exposure guidelines the device

must be used with a minimum of 0.5 cm separation from the

body.

Failure to observe these instructions could result in your RF



exposure exceeding the relevant guideline limits and may use

more power than necessary.

FCC Statement

FCC Compliance (when US bands are supported)

Federal Communications Commission Notice (United States):

Before a wireless device model is available for sale to the

public, it must be tested and certified to the FCC that it does

not exceed the limit established by the government-adopted

requirement for safe exposure.

The SAR limit for USB Sticksadopted by the USA is 1.6

watts/kilogram (W/kg) averaged over one gram of tissue. The

highest SAR value reported to the FCC for this device type

was compliant with this limit.

This device complies with part 15 of the FCC Rules. Operation

is subject to the condition that this device does not cause

harmful interference.

Caution: Changes or modifications not expressly approved by

the manufacturer could void the user’s authority to operate

the equipment.

NOTE: This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable



protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation.

If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more

of the following measures:

—Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and

receiver.

—Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

—Consult the dealer or an experienced radio/ TV technician

for help.

Distraction

Driving

Full attention must be given to driving at all times in order

to reduce the risk of an accident. Using this device while

driving causes distraction and can lead to an accident. You

must comply with local laws and regulations restricting the

use of wireless devices while driving.

Operating machinery

Full attention must be given to operating the machinery in

order to reduce the risk of an accident.

Product Handling

You alone are responsible for how you use your device and any



consequences of its use.

You must always switch off your device wherever the use of

a mobile phone is prohibited. Use of your device is subject to

safety measures designed to protect users and their

environment.

• Always treat your device and its accessories with care and

keep it in a clean and dust-free place.

• Do not expose your device or its accessories to open flames

• Do not expose your device or its accessories to liquid,

or lit tobacco products.

moisture or high humidity.

• Do not drop, throw or try to bend your device or its

accessories.

• Do not use harsh chemicals, cleaning solvents, or aerosols

to clean the device or its accessories.

• Do not paint your device or its accessories.

• Do not attempt to disassemble your device or its

accessories: only authorized personnel must do so.

• Do not expose your device or its accessories to extreme

temperatures, minimum –20 and maximum +60degrees

Celsius. For optimal performance operate within a range of

minimum -10 and maximum +55 degrees Celsius.

• Please check local regulations for disposal of electronic

products.

• Do not carry your device in your back pocket as it could

break when you sit down.

• Do not operate the device where ventilation is restricted -

for example, do not operate inside a jacket pocket, inside

a handbag or in any confined space.

Small Children

Do not leave your device and its accessories within the reach

of small children or allow them to play with it.



They could hurt themselves or others, or could accidentally

damage the device.

Your device contains small parts with sharp edges that may

cause an injury or which could become detached and create

a choking hazard.

Electrostatic discharge (ESD)

Do not touch the SIM card’s metal connectors.

Power supply

Do not connect your device to the power supply or switch it

on until instructed to do so in the installation instructions.

Air Bags

Do not place this device in the area over an air bag or in the

air bag deployment area.

Store the device safely before driving your vehicle.

Emergency Situations

This device, like any wireless device, operates using radio

signals, which cannot guarantee connection in all conditions.

Therefore, you must never rely solely on any wireless device

for emergency communications.

Device Heating

Your device may become warm during charging and during

normal use, do not use this device if it is overheated.

Electrical Safety

Accessories

Only use approved accessories.

Do not connect with incompatible products or accessories.



Do not touch your device with wet hands. Doing so may cause

an electric shock.

Connection to a Car

Seek professional advice when connecting a device interface

to the vehicle electrical system.

Faulty and Damaged Products

Do not attempt to disassemble the device or its accessory.

Only qualified personnel should service or repair the device or

its accessory.

If your device or its accessory has been submerged in water or

other liquid, punctured, or subjected to a severe fall, do not

use it until you have taken it to be checked at an authorized

service centre.

Interference

Care must be taken when using the device in close proximity

to personal medical devices, such as pacemakers and hearing

aids.

Pacemakers

Pacemaker manufacturers recommend that a minimum

separation of 15 cm be maintained between a device and a

pacemaker to avoid potential interference with the

pacemaker.

Hearing Aids

People with hearing aids or other cochlear implants may

experience interfering noises when using wireless devices or



when one is nearby.

The level of interference will depend on the type of hearing

device and the distance from the interference source,

increasing the separation between them may reduce the

interference. You may also consult your hearing aid

manufacturer to discuss alternatives.

Medical devices

Please consult your doctor and the device manufacturer to

determine if operation of your device may interfere with the

operation of your medical device.

Hospitals

Switch off your wireless device when requested to do so in

hospitals, clinics or health care facilities. These requests are

designed to prevent possible interference with sensitive

medical equipment.

Aircraft

Switch off your wireless device whenever you are instructed

to do so by airport or airline staff.

Consult the airline staff about the use of wireless devices on

board the aircraft. If your device offers a ‘flight mode’ this

must be enabled prior to boarding an aircraft.

Interference in cars

Please note that because of possible interference to electronic

equipment, some vehicle manufacturers forbid the use of

devices in their vehicles unless an external antenna is included

in the installation.



Explosive environments

Petrol stations and explosive atmospheres

In locations with potentially explosive atmospheres, obey all

posted signs to turn off wireless devices such as your device or

other radio equipment.

Areas with potentially explosive atmospheres include fuelling

areas, below decks on boats, fuel or chemical transfer or

storage facilities, areas where the air contains chemicals or

particles, such as grain, dust, or metal powders.

Blasting Caps and Areas

Turn off your device or wireless device when in a blasting area

or in areas posted turn off “two-way radios” or “electronic

devices” to avoid interfering with blasting operations.

Software Information

The product software version is BD_K5161zV1.0 or later.

Software updates will be released to enhance usability of the

product.

Specification

This radio equipment operates with the following frequency

bands and maximum radio-frequency power.

NOTE:

This product is compliant with the power limits required by

the European Union. Frequency bands supported by the

product vary by model.

Service

Power Level(Maxim

P

mum)

GSM 900 MH

Hz

GSM 1800 M

MHz

35dBm

3

32dBm

3

UMTS Band 1

1 (2100 MHz) 2

25 dBm

UMTS Band 8

8 (900 MHz)

25 dBm

2

LTE Band 1

LTE Band 3

LTE Band 7

LTE Band 8

0

LTE Band 20

25dBm

2

25dBm

2

25 dBm

2

25 dBm

2

25 dBm

2

Disposal of You

r Old Appliance

1.

2. A

d-out wheeled bin

When this crossed

t

ed to a product, it

symbol is attache

the

uct is covered by t

means the produ

ive 2012/19/EU.

European Directi

ts

electronic product

All electrical and

om

ed of separately fro

should be dispose

aste stream via

the municipal wa

ction facilities

designated collec

e government or t

appointed by the

local authorities.

sal of your old

The correct dispos

elp prevent potent

appliance will he

uences for the

negative consequ

d human health.

environment and

tial

the

3. T

EU DECLARATION OF CONFORMITY

Hereby,Vodafone declares that the radio equipment type Vodafone

K5161z is in compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at the

following Internet address: vodafone.com/K5161z/ec-declaration

Vodafone

Vodafone S.àr.l., 15 rue Edward Steichen, L-2540 Luxembourg,

Grand-Duché de Luxembourg



 

 

 

 

 

 

 

 

 

 

Model:k5161z ZTE IMELXXXXXXXXXXXXXXX CE eesenrs conse front inside FCC ID: SRO-K5161Z the back exterior

 

 

ZTE Corporation Request for Confidentiality Date:

_2021-01-26_ Subject: Confidentiality Request for: _____ FCC ID: SRQ-K5161Z ______ Pursuant to FCC 47 CRF 0.457(d) and 0.459 and IC RSP-100, Section 10, the applicant requests that a part of the subject FCC application be held confidential. Type of Confidentiality Requested Permanent Short Term Short Term Short Term Short Term Short Term Short Term Short Term Short Term Short Term ______(Insert Explanation as Necessary)______ Permanent*1 Permanent Permanent Permanent Permanent Permanent*

Exhibit Block Diagrams External Photos Internal Photos Operation Description/Theory of Operation Parts List & Placement/BOM Tune-Up Procedure Schematics Test Setup Photos Users Manual

*Note:

______ZTE Corporation_____ has spent substantial effort in developing this product and it is one of the first of its kind in industry. Having the subject information easily available to "competition" would negate the advantage they have achieved by developing this product. Not protecting the details of the design will result in financial hardship. Permanent Confidentiality:

The applicant requests the exhibits listed above as permanently confidential be permanently withheld from public review due to materials that contain trade secrets and proprietary information not customarily released to the public. Short-Term Confidentiality:

The applicant requests the exhibits selected above as short term confidential be withheld from public view for a period of __180_ days from the date of the Grant of Equipment Authorization and prior to marketing. This is to avoid premature release of sensitive information prior to marketing or release of the product to the public. Applicant is also aware that they are responsible to notify TCB in the event information regarding the product or the product is made available to the public. TCB will then release the documents listed above for public disclosure pursuant to FCC Public Notice DA 04-1705. NOTE for Industry Canada Applications:

The applicant understands that until such time that IC distinguishes between Short Term and Permanent Confidentiality, either type of marked exhibit above will simply be marked Confidential when submitted to IC. Sincerely, By:

(Signature/Title2) Yu Gong

(Print name)

 

 

ZTE Corporation POWER OF ATTORNEY DATE: 01/26/2021 To:

Federal Communications Commission, Authorization & Evaluation Division, 7435 Oakland Mills Road, Columbia, MD 21046 We, the undersigned, hereby authorize TA Technology (Shanghai) Co., Ltd.

/Huang Ting on our behalf, to apply to FCC on our equipment for FCC ID:

SRQ-K5161Z. Any and all acts carried out by TA Technology (Shanghai) Co., Ltd. / Huang Ting on our behalf shall have the same effect as acts of our own. Sincerely, Print name: Yu Gong Company: ZTE Corporation