MY JEEXR:59*98mm BiAA BAT: 105eFA ZK 98 mm LE-SHOW-BLU ENGLISH LED WIRELESS SPEAKER initial use,
+ To charge your Splash LED Wireless Speaker, connect the supplied Micro USB cable into the Micro-USB charging port and connect the other end to a USB power outlet (5V adaptor not included). LED indicator wil illuminate RED to indicate that the speaker is charging. Allow approximately 3-4 hours charging time to fully charge the speaker, When battery is fully charged, the LED will turn off. Operating the Bluetooth Speaker Tum the Bluetooth Speaker ON by holiding down the power button (1) for Two Seconds. The speaker LED ring will be white light and tone prompts you the device is pairing mode. 2. Enable Bluetooth search mode on your smartphone and select pairing name LE-SHOW" on your Bluetooth device Uist Once the speaker has successfully connected, you'll. hear a beep 3.To change the LED rings color, press the bulbbutton(2). 4.To Power down the Speaker, hold down the start button
(1) for Two Seconds. The LED ring will shut oft ex Safety and Care Instructions:
+ Do not attempt to disassemble the unit.
+ Repairs to electrical equipment should only be performed bya qualified service person. Improper repairs may place user as risk and void warranty.
+ Do not puncture or harm the exterior surface of the product in any way.
* Do not drop or tet the unit fall from high places, as doing so may damage the device.
+ Do not use this unit for anything other than its intended se or purpose. Doing so may damage the device and void warranty. destroy the battery and/or distort certain parts.
+ Do not use abrasive cleaning solvents to clean the unit. In order to prolong battery life turn off when not in use. NOTE: This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference ina residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will nat occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which an be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more ofthe following measures:
-Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet ona circuit different
= 59mm LEDeez Bluetooth | MANUAL (ENGLISH) ON/OFF/PAIRING | + This productis not a toy. Keep out of reach of children. from that to which the receiver is connected, harging th: ker CHARGING + Do not expose batteries or battery pack to excessive heat Charging the Bluetooth Speaker or open flame. Consult the dealer or an experienced radio/TV technician amo .Do not expose the unit to extremely high or low for help
+ Please make sure battery is fully charged before | Burton temperatures as this wil shorten the life of the device, Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 ofthe FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. BT ID: 0051448 FCCID: 2AANZSHOW