DS-PD2-D15AME 15m Dual Detector START Diagram references detect when both PIR and Microwave technologies are Masked. The detector is sensors. The Mask is adjustable between 0 to 1M.
MASK and ALARM relay will open and the Green and Orange LEDs will be and a walk test must be done. Blocking:
15m when the panel is disarmed. When blocking is detected the alarm relay blocking, the DS-PD2-D15AME must be walk tested so that the PIR and MW sensors Blocking Enabled/Disabled:
and the RI input should be connected to an output on the control panel which gives 0V when DISARMED and removes 0V when ARMED. To enable the feature, switch 6 must be OFF DS-PD2-D15AME is supplied with the following:
BRACKETW (Wall Bracket), BRACKETC (Ceiling Bracket) and TAMPER
(Back tamper) NOTE:
remains at 15m. Coverage Maximum range Op mal installa on height Creep-zone protec on Key features Adjustable an -masking (an -spray) An blocking technology Blue Wave Technology Automa c sensi vity Digital temperature compensa on Separate indica on: microwave, PIR and alarm 3 microwave frequencies to avoid interference DEOL resistors on board Tamper protec on included Signal Strength Indicators (SSI) Wired Power supply Current consump on at rest Current consump on in alarm Relay type Output relay Tamper terminal Electrical specica ons Microwave frequency Alarm response Detec on speed Direct light lter Op cs Geometric lens congura on Other details Opera ng temperature Weight Dimensions Accessories Wall/ceiling brackets included Long range and curtain lenses included Bracket back tamper kit included Cer ca ons and warranty Electrical conformity Warranty 85 74zones 7planesCurtain 15m/18m/30m 1.8-2.4m yes yes yes yes yes yes yes yes yes yes n/a 9-16 DC (12DC nominal) 23mA 30mA Solid state 60DC, 50mA protec on 12DC max, 50mA max 10.515, 10.525, 10.535GHz 2.5 second 0.3 - 3m/s 6500 Lux Sealed 3D
-10C / +40C 125g 117 x 69 x 55 mm yes yes yes CE 2 years User Manual COPYRIGHT 2018 Hangzhou Hikvision Digital Technology Co., Ltd. COPYRIGHT 2018 Hangzhou Hikvision Digital Technology Co., Ltd. ALL RIGHTS RESERVED. ALL RIGHTS RESERVED. wholly, by any means, without the or implied, regarding to the Manual. About this Manual This manual is applicable to video security control panel. About this Manual This manual is applicable to detector. Please use this user manual under the guidance of professionals. Trademarks Acknowledgement website For electrical products sold within the European Community. At the end of the electrical Please use this user manual under the guidance of professionals. products life, it should not be disposed of with household waste. Please recycle where Trademarks Acknowledgement country. This product operates in a European non-harmonised frequency band. Hereby at www.pyronix.com/product-compliance.php This product and - if applicable - the supplied accessories too are marked with "CE"
and comply therefore with the applicable harmonized European standards listed Commercial and Light Industrial Environment. MASK/ALARM EOL LINK
!
The Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power Source according to the IEC60950-1 standard. Please refer to technical specifications for detailed information. K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 GENERAL WIRING 3EOL A A T T EOL INPUT 1 COM DEOL A A T T EOL INPUT 1 COM N/C A A T T EOL INPUT 1 COM HIK HIK CONTROL PANEL Z1 COM Z2 Z3 GENERAL GENERIC CONTROL PANEL Z1 COM Z2 Z3 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 1M MAX 30%
K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 Max: 1M 30% Mask OFF
1m
>1m K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 A A T T EOL INPUT 1 COM PGM NC C NO Control Panel Programming K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 15m Volumetric Lens Horizontal Coverage 85 60 zones 7 planes 18m Curtain Lens For INCERT compliance, set pulse count to 1
(see switch 4 diagram) 30m Long Range Lens For INCERT compliance, set pulse count to 1
(see switch 4 diagram) Horizontal Coverage Horizontal Coverage at Minimum Range Horizontal Coverage at Maximum Range PULSE COUNT 1 0.25 - 2.5m/s 0.25 - 2.5m/s AND
=
OR
=
TAMPER TAMPER LINK MASK/A LARM EOL FCC Information Please take attention that changes or modication not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installedC and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help FCC Conditions This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. 2 DEOL DEOL 3EOL 3EOL 3 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 8 K 6 6 K 5 7 K 4 2 K 2 6 K 5 7 K 4 2 K 2 K 5 1 K 1 K 1 K 1 K 3 3 PCX 162i Z1 COM 2 PCX 162i Z1 COM Hard Wired Resistor (Generic) Hard Wired Resistor (Generic) Z1 COM Z1 COM 8k2 6k8 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 K 3 K 5 1 K 2 1 2 K 8 8 K 6 6 K 5 7 K 4 2 K 2 K 1 8 K 6 6 K 5 7 K 4 2 K 2 K 1 6 K 5 7 K 4 2 K 2 K 1 PIR ALARM MICROWAVE PIR Activated Microwave Activated Alarm Mask Processing Masked/
Blocked Powering up PIR Failed Self Test Microwave Failed Self Test Low Voltage HORIZONTAL COVERAGE 12m 6m O85 60 zones 7 planes RLNS074 INCERT ONLY 12m Volumetric Lens 6m 12m VERTICAL COVERAGE 1.8-2M 6m 12m