Compatible with Qi-Enabled Devices Charging your phone is now easier than ever. This dock charges qi enabled devices wireless. Simply place your phone on the charging pad the the LED indicator will light up and your phone will begin charging by induction. Charge your phone without ever having to look for a cable again!
Packing Contents:
1x wireless charging dock. 1x Micro USB Cable. 1x Manuel How to Use:
1. Connect the charging dock to the supplied USB cable. 2. Connect the USB plug to USB power supply(support:5V/
2A) 3. When the red light appears. The dock has entered standby mode. 4. Charging will begin when your device( Qi-Enabled) is placed on the dock. 5. When the blue light is showing. The device is charging. 6. When the device is fully charged. The blue light turn off. Specifications:
Input: 5V / 2A Output Power: 5 Watts Power Conversion: 70%
Working Frequency: 114.5-204kHz Charging Distance: 2~7mm Note: Power supply support 5V/2A LED State:
Mode RED BLUE NOTE Standby ON OFF Charging OFF ON FULL OFF OFF ERROR FLASH FLASH (Check it,and Replace again) Warning:
1. Do not squeeze or collisions. 2. Do not disassemble or throw into fire or water,to avoid causing a short circuit leakage. 3. Do not use wireless charger in severely hot,humid or corrosive environments,to avoid circuit damage and occurs leakage phenomenon. 4. Do not place too close with magnetic stripe or chip card(ID card,bank cards,etc. ) to avoid magnetic failure. 5. Please keep the distance at least 20cm between implantable medical devices(pacemakers,implantable cochlear,etc.)and the wireless charger,to avoid potential interference with the medical device. 6. To take care of children,to ensure that they wont play the wireless charger as a toy,to avoid unnecessary accidents. MADE IN CHINA V1.0 FCC COMPLIANCE STATEMENT This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the part responsible for compliance could void the users authority to operate the equipment. The distance between user and products should be no less than 20cm