FCC ID: OUCWK30-ARX-07 Wireless Remote Receiver

2. Users manual (provisionally) REMOTE TRANSMITTER UP After you push POWER button, when you continue pushing the UP button, continue transmitting UP code from the transmitter. The target to control continues moving up. DOWN After you push POWER button, when you continue pushing the DOWN button, continue transmitting DOWN code from the transmitter. The target to control continues moving down.

- 2 -

PROPOSED FCC ID LABEL AND LOCATION OMRON CORPORATION FCC ID: OUCWK30-ARX-07 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID LABEL LOCATION

3. Block diagram This is the block diagram concerning to the receiver. RECEIVING MODULE 8BIT CPU input data EEPROM POWER SOURCE(5V) 12V / 24V

(car battery) output DRIVING CIRCUIT LIFT UP MOTOR Signal of vehicle status Figure 3.1 block diagram of the receiver

- 3 -

6. PCB 6.1 Circuit diagram Figure 6.1 Circuit diagram

- 6 -

4. Specification 4.1 CPU Type ROM RAM EEPROM Clock frequency Clock frequency generation Package 4.2 RF block Local clock frequency Frequency generation Modulation Bandwidth Carrier Detect Sensitivity 4.3 Others Dimension Weight Battery Operation Voltage Operation temperature 68HC805P18 (8bit) Manufacturer: Motorola 8K bytes 192 bytes 128 bytes 4.19MHz Crystal resonator 28pin SOP 324.55MHz Crystal resonator Single Superheterodyne 200KHz 30 dBuVemf 70mm 71.6 mm32.5 mm 21 g Car Battery (DC 12/24V) DC 12V, 7mA / DC24V,9mA

-30 ~ +70

- 4 -

1. Constitution of the Wireless Remote Controller The wireless remote controller is a system that it controls up or down in a target by remote controller.

(For example, it controls up or down a seat for vehicle.) This system consists of two components. The TRANSMITTER is a device that continues transmitting the signal when the button is continued pressing. The transmission signal consists of several synchronous codes, unique identification code, and function code. The RECEIVER is fixed in side of target to control. It works intermittently to reduce the battery exhaustion. When the receiver detects the synchronous code, it runs continuously to receive the signals completely. After receiving the signal, the receiver decides which operation will be performed. The user can select the following operations by pressing the button of the transmitter. OPERATION Up Down Up the target Down the target ACTION Transmitter f = 313.85MHz

- 1 -