A3700 Smart Payment Tablet PAX Technology Limited Product name A3700 Smart Payment Tablet ModelA3700 1. Checklist Congratulations on receiving your PAX Technology payment terminal. We do hope you enjoy it!
The box you have just opened should contain the following items:
1 x PAX A3700 Smart Payment Tablet 1 x AC Power Adapter 1 x Product Manual 1 x Cable 2. Installation SAM/SIM/microSD Card:
Uncover the silicone strip (On the back of the terminal). Insert the SAM/SIM card to the corresponding card slot. 3. Instructions aPower On/Off Power on: Press the side ON/OFF button terminal turns on successfully. two seconds until LCD backlight light, the Power off: Press the side ON/OFF button clickPower off to shut down the terminal two seconds until the shutdown menu pops up, bMagnetic Stripe Card Place the magnetic strip end of the magnetic card toward the device and swipe the card smoothly in the magnetic reader slot.(Support double-sided & bi-directional swiping) c IC Card Insert the chip side of the IC card into the IC card slot and to bottom(Support double-sided cards) dContactless Card Place the contactless card in the sensor area next to the IC card slot 4. General Usage Tips a) Avoid placing this product in direct sunlight for extended periods, nor in environments with excessively high temperature, moisture or dust. b) Only qualified personnel should repair this product. c) Before using cards in the chip reader, please ensure it is free from any foreign objects. d) Working environment:
Temperature range:0 ~ 45; Humidity range10 ~ 93 (non-condensation) Storage environment:
Temperature range:-20 ~ 70; Humidity range :10 ~ 93 (non-condensation) f)The adaptor with short circuit protection function 5. Battery Usage Tips WARNING:
a) The terminal is equipped with a non-removable built-in battery. Do not replace the battery by yourself to avoid damaging the battery or the terminal. b) Do not use the battery in direct sunlight or smoky and dusty environments. c) Do not strike, squeeze or step on the battery, nor throw it into liquid or fire. d) Any product warranty is only valid if batteries supplied by PAX Technology Limited are used. e) Charging time should not exceed 24 hours. Over-charging or over-discharging may damage the battery. f) If the product is not being used for an extended period, whether in storage or otherwise, make sure to recharge the battery at least every 6 months. h) PAX Technology Limited advises that best-practice is to replace batteries every 2 years. i) Dispose of batteries in a responsible manner 6Warning FCC compliance statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. FCC SAR statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). These requirements set a SAR limit of 4W/kg averaged over ten gram of tissue. The highest SAR value reported under this standard during product certification for use when properly hold on the extremity. ISED compliance statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :
(1) Lappareil ne doit pas produire de brouillage;
(2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. ISED 5G Wi-Fi statement The user manual for LE-LAN devices shall contain instructions related to the restrictions mentioned in the above sections, namely that:
i. the device for operation in the band 51505250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
ii. where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated. i. le dispositif utilis dans la bande 5150-5250 MHz est rserv une utilisation en intrieur afin de rduire le risque de brouillage prjudiciable aux systmes mobiles par satellite dans le mme canal;
ii. le cas chant, le (s) type (s) d'antenne, le (s) modle (s) d'antenne et l'angle (s) d'inclinaison le plus dfavorable ncessaire (s) pour rester conforme (e) au p.e. L'exigence relative au masque d'lvation nonce la section 6.2.2.3 doit tre clairement indique. IC SAR statement This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 4 W/kg averaged over ten gram of tissue. The highest SAR value reported under this standard during product certification for use when properly hold on the extremity. L'quipement est conforme aux limites d'exposition aux rayonnements de l'IED pour les environnements non contrls. L'utilisateur final doit se conformer des instructions d'exploitation spcifiques afin de respecter la conformit l'exposition aux radiofrquences. Cet metteur ne doit pas tre au mme endroit ni fonctionner en collaboration avec une autre antenne ou un autre metteur. L'quipement portatif est conu pour rpondre aux exigences d'exposition aux ondes radio tablies par l'IED. Ces exigences fixent une limite SAR de 4 W / kg en moyenne pour 10 g de tissu. La valeur SAR la plus leve rapporte conformment la prsente norme au cours du processus de certification du produit, lorsque l'extrmit est correctement tenue. 7. Icons Dispose in a professional recycling manner Class II equipment For indoor use only Energy efficiency marking AC voltage DC voltage microSD logo Trademark notice:
microSD logo is a trademark of SD-3C LLC.