Regulatory Information If you have questions about this product, write to Sony Customer Information Service Center at 12451 Gateway Blvd., Ft. Myers, FL 33913, USA, or visit Sony Customer Service on the Sony Online Support Web site at http://www.sony.com/pcsupport. Declaration of Conformity Trade Name: SONY Model No.: PCV-E21L Responsible Party: Sony Electronics Inc. Address: 16450 W. Bernardo Drive San Diego, CA 92127 USA Telephone: 858-942-2230 This phone number is for FCC-related matters only. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Model No.: PCVA-IMB7A (For models equipped with Giga Pocket features) and VGP-WMS1 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
QO Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. OO O Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Only peripherals (computer input/output devices, terminals, printers, etc.) that comply with FCC Class B limits may be attached to this computer product. Operation with noncompliant peripherals is likely to result in interference to radio and television reception. All cables used to connect peripherals must be shielded and grounded. Operation with cables, connected to peripherals, that are not shielded and grounded, may result in interference to radio and television reception. FCC Part 68 This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the modem card is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. This modem uses the USOC RJ-11 telephone jack. A telephone plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to the line, as determined by the total RENs, contact the telephone company. For products approved after July 23, 2001, the REN for this product is part of the product identifier that has the format US:AAAEQHHTXXXX. The digits represented by ## are the REN without a decimal point (e.g. 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label. If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operations of the equipment. If this happens, the telephone company will provide advance notice in order for you to make the necessary modifications in order to maintain uninterrupted service. If trouble is experienced with this equipment, for repair or warranty information, please contact the Sony Customer Information Service Center at 1-888-4-SONY-PC (1-888-476-6972), or write to the Sony Customer Information Center, 12451 Gateway Blvd., Fort Myers, FL 33913, USA, or find Sony Customer Service on the Web at http://www.sony.com/pcsupport. If this equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment from the network until the problem is resolved. Repair of this equipment should be made only by a Sony Service Center or Sony authorized agent. For the Sony Service Center nearest you, call 1-888-4-SONY-PC (1-888-476-6972), or visit the Sony Online Support Web site at http://www.sony.com/pesupport. Connection to Party Line Service is subject to state tariffs. Contact the state public utility commission, public service commission, or corporation commission for information. If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. Please use a surge arrestor against electrical surges. FCC Radio-Frequency Exposure Statement(United States) This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body (excluding extremities: hands, wrists and feet). This equipment must not be co-located or operating in conjunction with any other antenna or transmitter, except for wireless devises to be supplied with this equipment. IC RSS-210(Canada) Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. L'utilisation de ce dispositif est autorise seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) l'utilisateur du dispositif doit tre prt 4 accepter tout brouillage radiolectrique regu, mme si ce brouillage est susceptible de compromettre le fonctionnement du dispositif. To prevent radio interference to the licensed service, this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing. Pour empcher que cet appareil cause du brouillage au service faisant l'objet d'une licence, il doit tre utilis a l'intrieur et devrait tre plac loin des fentres afin de fournir un cran de blindage maximal Si le matriel (ou son antenne d'mission) est install a l'extrieur, il doit faire l'objet d'une licence The term IC before the radio certification number only signifies that the Industry Canada technical specifications were met. Leterme <IC:> avant le numro dhomologation ne signifie seulement que les normes d Industrie Canada ont t respectes. IC Exposure of Humans to RF Fields(Canada) The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canadas website:
www.he-se.ge.ca/rpb. Linstallateur du prsent matriel radio doit s'assurer que Iantenne est situe ou pointe de manire a ce que cette dernire nmette pas de champs radiolectriques suprieurs aux limites spcifies par Sant Canada pour le grand public: consulter le Code de scurit 6, disponible sur le site Web de Sant Canada, a l'adresse suivante: www.he-sc.ge.ca/rpb. oO Telephone Consumer Protection Act of 1991 (United States) The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device, including FAX machines, to send any message unless such message clearly contains, in a margin at the top or bottom of each transmitted page or on the first page of the transmission, the date and time it is sent and an identification of the business, other entity, or individual sending the message, and the telephone number of the sending machine or such business, other entity, or individual. (The telephone number provided may not be a 900 number or any other number for which charges exceed local or long distance transmission charges.) In order to program this information into your facsimile machine, see your fax software documentation. Telephone Consumer Guidelines (Canada) Please refer to your telephone directory under Privacy Issues and/or Terms of Service. For more detailed information, please contact:
CRTC Terrasses de la Chaudire Tour centrale 1 promenade du Portage 5 tage Hull PQ KIA ON2. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numrique de la classe B est conforme a la norme NMB-003 du Canada. Model No.: PCVA-IM87A. (For models equippd with Giga Pocket features) Supplementary Television Broadcasting Receiving Apparatus - Appareils supplmentaires de rception de tlvision, Canada. Disposal of Lithium Battery You can return your unwanted lithium batteries to your nearest Sony Service Center or Factory Service Center. For the Sony Service Center nearest you, call 1-888-476-6972 in the United States or 1-800-961-7669 in Canada. Do not handle damaged or leaking lithium batteries. In some areas, the disposal of lithium batteries in household or business trash may be prohibited. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturers instructions. The battery pack used in this device may present a fire or chemical burn hazard if mistreated. Do not disassemble, heat above 212 F (100C), or incinerate. Dispose of used battery promptly. Keep away from children. Ne pas manipuler les batteries au lithium qui tuient ou sont endommagees. Une batterie non conforme prsente un danger d'explosion. La remplacer seulement par une batterie identique ou de type quivalent recommand par le fabricant. Evacuer les batteries uses selon les directives du fabricant. La manutention incorrecte du module de batterie de cet appareil prsente un risque d'incendie ou de brilures chimiques. Ne pas dmonter, incinrer ou exposer a une temprature de plus de 100C. Evacuer promptement la batterie use. Garder hors de porte des enfants. Industry Canada Notice This equipment meets the applicable Industry Canada technical specifications. The Ringer Equivalence Number (REN) is an indication of the maximum number of devices allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the RENs of all the devices does not exceed 5. Avis de LIndustrie Canada Le presnt matriel est conforme aux spcifications techniques applicables d Industrie Canada. Lindice dquivalence de la sonnerie (IES) sert 4 indiquer le nombre maximal de terminaux qui peuvent tre raccords 4 une interface tlphonique. La terminaison d'une interface peut consister en une combinaison quelconque de dispositifs, 4 la seule condition que la somme d indices dquivalence de la sonnerie de tous les dispositifs nexcde pas 5. Macrovision license This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited. Licence Macrovision Ce produit intgre une technologie de protection de la loi sur le droits de proprite intellectuelle couverts par la lgislation amricaine. L utilisation de cette technologie doit tre autorise par Macrovision. Elle est uniquement destine 4 un usage priv et 4 dautres fins de visualisation limite, sauf autorisation contraire de la part de Macrovision. Tout dsossage ou dsassemblage est formellement interdit.